Synthesis and Characterization of New Soluble Polyamides from 9,9-Bis[4-(chloroformylphenoxy)phenyl]xanthene and Various Aromatic Diamines

9,9‐Bis(4‐hydroxyphenyl)xanthene (BHPX) was synthesized in 82% yield from xanthenone in a one‐pot, two‐step synthetic procedure. A new diacyl chloride monomer, 9,9‐bis[4‐(chloroformylphenoxy)phenyl]xanthene (BCPX), was synthesized in three steps from the nucleophilic fluorodisplacement of 4‐fluorobenzonitrile with the dipotassium bisphenolate of BHPX, followed by alkaline hydrolysis of the intermediate bis(ether nitrile), and then chlorination with thionyl chloride. Several novel aromatic polyamides containing ether and bulky xanthene groups with the inherent viscosities (0.72–0.98 dL/g) were prepared by the low temperature polycondensation of BCPX with various aromatic diamines in N,N‐dimethylacetamide (DMAc) solution containing pyridine (Py). All new polyamides were amorphous and readily soluble in various polar solvents such as DMAc, N,N‐dimethylformamide (DMF), N‐methyl‐2‐pyrrolidone (NMP) and Py. These polymers showed relatively high glass transition temperatures between 236 and 298°C, decomposition temperatures at 10% weight loss ranging from 490 to 535°C and 483 to 515°C in nitrogen and air, respectively, and char yields at 700°C in nitrogen higher than 50%. Transparent, flexible, and tough films of these polymers cast from DMAc solutions exhibited tensile strengths ranging from 82 to 106 MPa, elongations at break from 10% to 25%, and initial moduli from 2.0 to 2.8 GPa.     

Opal gel templated synthesis of oblate titania opal materials

Ordered arrays of oblate titania bodies were template synthesized using opal gel templates under uniaxial compression at ambient temperature during the favorable titania sol/gel process. The aspect ratio was controllable by the compression degree.     

Template synthesis of tin-doped indium oxide (ITO)/polymer and the corresponding carbon composite hollow colloids

SnO₂, In₂O₃, and Sn-doped In₂O₃ (ITO)/polymer and the corresponding carbon composite hollow colloids are template synthesized. It is essential that the sulfonated gel shell of the cross-linked polystyrene hollow colloid can favorably induce adsorption of target precursors. After being calcined in air to remove the template, SnO₂, In₂O₃, and ITO hollow colloids are obtained. Because the cross-linked polymer gel can be transformed into carbon in nitrogen at higher temperature such as 800 °C, metal oxide/carbon hollow colloids are consequently derived, whose shells are mesoporous. The SnO₂-, In₂O₃-, and ITO-containing polymer or carbon composite hollow colloids will be promising in sensors, catalysts, and fuel cells as electrode materials. Electronic supplementary material The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

不完全相反转发展过程的流变行为

以动态应力流变仪ＤＳＲ（ＤｙｎａｍｉｃＳｔｒｅｓＲｈｅｏｍｅｔｅｒ）对双酚Ａ型环氧树脂在低乳化剂浓度（２３３ｗｔ％）下的相反转乳化过程进行了稳态应力扫描及动态频率扫描实验．实验结果表明,体系在相反转点前表现为牛顿流体行为,粘度几乎不变;相反转点时,体系粘度增加幅度很小,体系的有关动态流变参数（剪切储能模量、损耗模量和复数粘度）均出现极小值,将此归于局部连续水相的润滑作用;进一步加水,体系的动态流变量增加,意味着相反转在相反转点后仍在继续进行．所以,体系在低乳化剂浓度时,发生了不完全相反转．     

Template Synthesis of Polyacrylonitrile‐Based Ordered Macroporous Materials and Their Derivatives

Ordered macroporous polyacrylonitrile (mPAN) materials with 10¹–10³ nm pore diameter were prepared by radical polymerization using colloidal silica as a template followed by removal of the template. Both ordered macroporous carbon and hydrogels were derived from mPAN by means of pyrolysis and alkaline hydrolysis, respectively, whose morphology and composition were characterized experimentally.     

Nafion修饰电极计时电位溶出法测定多巴胺的研究

本文提出了Nafion 修饰电极计时电位溶出分析方法,讨论了测定多巴胺(DA)的实验条件,研究了修饰电极的富集作用及其电极反应机理。去甲肾上腺素(NE)、抗坏血酸(AA)等均不干扰测定DA,选择性好。     

不完全相反转乳化过程分散相水滴形态发展研究

相反转乳化技术是制备高分子树脂水基分散体系的新方法[1～4].相反转指多组分体系(如油/水/乳化剂)中的连续相在一定条件下相互转化的过程,如在油/水/乳化剂体系中,其连续相由水相向油相(或从油相变为水相)的转变.在连续相转变区,体系的界面张力最低,因而分散相的尺寸最小.同理,可利用相反转技术直接将高分子树脂乳化为尺寸很小的水基微粒,即制备高分子树脂的水基分散体系.由于高分子树脂的粘弹性及相反转过程的复杂性,对高分子树脂的相反转乳化过程的机理研究较少.杨振忠[5]等通过调节高分子非离子型乳化剂浓度,可以有效地控制相反转完善程…     

石油焦渣油浆燃烧特性的试验研究

石油焦渣油浆是为电站燃油锅炉开发的一种新型代用燃料,本文对南京金陵石化所提供的渣油和石油焦所制成石油焦渣油浆的燃烧特性进行了试验研究。结果表明,浓度为４０％的石油焦渣油浆可以成功地进行制备、加热、输送和燃烧,并具有较高的燃烧效率;石油焦渣油浆的浓度、油焦浆的加热温度、负荷和氧量对其燃烧效率有很大影响。