基于远场的拼接光栅压缩池的设计

 利用傅里叶光学方法得到了失调拼接光栅压缩池输出光束的远场振幅表达式，建立了分析拼接光栅的各种误差的理论模型，得到了拼接误差对脉冲的影响是附加相位延迟和角度偏转。在要求远场的一倍衍射极限区域的积分能量分布达到理想情况下的90％的条件下，对于含有口径为40 cm、脉宽为0.1~10 ps脉冲的系统进行分析并分别得到了各种误差的容限。     

时间分辨光子计数系统的研究和应用

对由SPCM-AQR-14和MCS组成的时间分辨光子计数系统进行了研究,分析了SPCM和MCS的工作原理及主要特性.利用该系统对磷光物质和洋葱的延迟发光进行了测量,对它们的光子计数率曲线进行拟合,发现其光强衰减符合双曲线规律.     

Diode-pumped 671 nm laser frequency doubled by CPM LBO

A design of diode-pumped high-efficiency Nd:YVO₄/LBO red laser is reported. Using critical phase-matching (CPM) LBO, 671 nm red laser was obtained from 1342 nm light by intracavity frequency doubling. With an incident pump laser of 800 mW, using type-I and type-II CPM LBO, 97 and 52 mWTEM₀₀ mode red laser outputs were obtained, with optical-to-optical conversion efficiencies of up to 12.1% and 6.5%, respectively.     

V3+:YAG晶体的生长、色心与光谱性能研究

采用石墨电阻加热的温梯法生长了V:YAG晶体,晶体的不同部位呈现两种不同的颜色:浅绿色和黄褐色.通过对比分析不同颜色V:YAG晶体的室温吸收光谱,推断出石墨发热体高温下扩散出来的C可以起到还原作用,提高晶体中V3+tetra离子的浓度,同时诱导了F心的形成.在1300℃下,对不同颜色的V:YAG晶体进行真空退火处理,发现处于八面体格位中的V3+离子在热激发作用下与近邻的四面体格位Al3+离子存在置换反应,由此产生一定浓度的四面体格位V3+离子.同时,F心在退火过程中被完全消除,释放出来的自由电子被高价态的V离子俘获,可以进一步提高晶体中四面体格位V3+离子的浓度.     

聚丙烯孔洞铁电驻极体膜的电极化及其电荷动态特性

根据栅控恒压电晕充电组合反极性电晕补偿充电法的实验结果计算出铁电驻极体的极化强度.结果说明，伴随着薄膜内孔洞气体的Paschen击穿，该铁电体的极化强度随栅压增加而显著上升.利用上述充电方法和热刺激放电(TSD)谱的分析讨论了这类空间电荷型宏观电偶极子，及与其补偿的空间电荷热退极化的电荷动态特性；阐明了这两类俘获电荷的能阱分布，即构成宏观电偶极子的位于孔洞上下介质层内的等值异号空间电荷分别被俘获在深、浅两种能值陷阱内，而位于薄膜表面层的注入空间电荷则被俘获在中等能值陷阱中. 关键词： 反极性电晕补偿充电法 铁电驻极体 充电电流 热刺激放电     

二项式光场与级联三能级原子的量子纠缠

利用量子熵理论，研究了二项式光场与级联三能级原子的量子纠缠，讨论了光场与原子的初始参量对其量子纠缠性质的影响.结果表明，利用二项式光场的特性，可以揭示从相干态到数态之间的所有态光场与三能级原子相互作用时的量子纠缠性质.选择适当的系统参数可以制备稳定的光场-原子qutrit纠缠态. 关键词： 二项式光场 级联三能级原子 光场熵 量子纠缠     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

Nuclear Quadrupole Coupling Constants of Chlorine and Microwave Spectrum, Structure, and ab Initio Calculation of 1-Chloro-1,1,2-trifluoroethane

The microwave spectrum of the ³⁵Cl and ³⁷Cl isotopic species of 1-chloro-1,1,2-trifluoroethane (HCFC-133b) has been investigated in the frequency region 10 to 50 GHz using a Stark modulation microwave spectrometer. A pulsed jet Fourier transform microwave spectrometer was also used for the measurement of hyperfine splittings. A least-squares analysis of the observed b-type Q- and R-branch transition frequencies gave rotational and centrifugal distortion constants and components of the chlorine nuclear quadrupole coupling constant tensors in the principal axes system as follows: A=4625.161 (3) MHz, B=2004.127 (2) MHz, C=1875.813 (2) MHz, Δ_J=0.144 (9) kHz, Δ_JK=1.0748 (8) kHz, Δ_K=1.57 (1) kHz, δ_J=0.01376 (4) kHz, δ_K=−0.146 (4) kHz, χ_aa=−57.958 (10) MHz, χ_bb=21.231 (11) MHz, and χ_cc=36.727 (11) MHz for ³⁵ClCF₂CH₂F species, and A=4607.684 (6) MHz, B=1960.565 (2) MHz, C=1834.823 (2) MHz, Δ_J=0.106 (7) kHz, Δ_JK=1.022 (3) kHz, Δ_K=1.48 (1) kHz, δ_J=0.0142 (2) kHz, δ_K=−0.18 (2) kHz, χ_aa=−46.268 (11) MHz, χ_bb=17.319 (13) MHz, and χ_cc=28.950 (13) MHz for ³⁷ClCF₂CH₂F species. The structural parameters are calculated from the observed six rotational constants by assuming the partial structure of ab initio calculation. The electronic properties of the C-Cl bond are evaluated from the observed nuclear quadrupole constants of chlorine. These molecular properties are compared with those of other related molecules.     

Laser induced copper electroless plating on polyimide with Q-switch Nd:YAG laser

The results of laser induced deposition of copper on polyimide substrate from copper electrolyte solution are reported. Unlike most work reported in the literatures where CW Ar⁺ lasers were used, a second harmonic (532 nm wavelength) Q-switch Nd:YAG laser was used for our experiments. The deposition process was conducted by laser-catalyzing of the polyimide surface and subsequent photothermal-accelerated reduction of copper-complex ions in an alkaline reducing environment. The characteristics of the deposited copper line were investigated in terms of laser beam scanning speed, and the number of scans. The surface morphology and chemical composition of the deposited copper were analyzed using field emission scanning electron microscope (FESEM) and energy dispersive spectrometer (EDX). The optimum processing conditions have been identified. The copper deposit was found to adhere well to the substrate.     

不连续不可逆二维映象的动力学特性

总结两个保守映象不可逆地分段连续链接(称为类耗散系统)以及一个保守映象与一个耗散映象不可逆地分段连续链接(称为半耗散系统)情况下得到的五项共同动力学特征：不连续边界象集构成的随机网成为唯一的混沌轨道；由于某些相点具有两个逆象而导致的相空间塌缩(类耗散)；由于系统的不连续不可逆性质而出现的胖分形禁区网；在具有吸引子共存时占据不连续边界象集随机网和胖分形禁区网区域的点滴状吸引域以及由此导致的吸引子不可预言性；即使在传统强耗散存在的情况下点滴状吸引域仍由类耗散机制主宰.以一个累积-触发电路为例，说明这五项系统动 关键词： 随机网 禁区网 点滴状吸引域