The facile in situ preparation and characterization of C/FeOF/FeF<Subscript>3</Subscript> nanocomposites as LIB cathode materials

C/FeOF/FeF₃ nanocomposite was synthesized by a facile in situ partial oxidation method. High-resolution transmission electron microscopy (HR-TEM) showed a special texture comprised of interpenetrating nanodomains of FeOF and FeF₃. Cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) measurements revealed that the introduction of nanodomain FeOF enhanced both the electronic and ionic conductivity of the composite material. Therefore, the improvement of electron and lithium-ion dynamics resulted in the significant enhancement of the electrochemical performances of the material at ambient temperature. At a current density of 20 mA g^?1 within potential range 1.5–4.5 V, the specific capacities of the first ten circles were maintained at about 400 mAh g^?1 _. This material also exhibited excellent cycling capacity retention capability especially for high C rates. When the current density further increased to 100 and 200 mA g^?1, a steady capacity of 80 and 60 mAh g^?1 was observed, respectively. Furthermore, nearly no capacity loss was observed for the followed cycles. The discharge platforms based on intercalation and conversion reaction were also heightened by about 0.4 V, which increased the contribution of high voltage capacities. Compared to C/FeF₃, C/FeOF/FeF₃ is showing more of capacitive behavior, which also contributes to the high specific capacity delivered and is believed to be closely related to the enlarged nanodomain interfaces between two electrochemical active materials. An expansion-cracking-oxidation mechanism was proposed to explain the formation of this interpenetrating nanodomains of FeOF and FeF₃.     

声波在含气泡液体中传播特性及产热效应*

该文对含气泡液体中的声波方程采用线性分析方法,研究了超声波在含气泡液体中的传播特性以及产热效应。当声波在含气泡液体中传播时,气泡的存在会影响声波的传播,在声波频率接近气泡共振频率的频段内,声信号在液体中传播时剧烈衰减,而在声波频率远远高于或低于气泡共振频率时,声波的传播基本不受影响。在接近气泡共振的频段内,声波耗散的能量最终转化为热能。同时液体中的气泡会在声波驱动下径向振动并辐射声波,伴随气泡壁在液体中的粘滞振动,热量随之产生。结果表明,两种产热机制分别在不同频段起主导作用。     

基于纠缠见证的路径纠缠微波检测方法

提出了一种基于纠缠见证的路径纠缠微波信号检测方法.路径纠缠微波是微波频段上的连续变量纠缠,介绍了利用微波压缩态和微波分束器制备路径纠缠微波的方法.根据部分转置正定判据以及2?2纠缠态密度矩阵的部分转置具有负本征值的性质,分别对常见的两种2?2纠缠进行了纠缠见证算符的构造,用于对两路信号是否为纠缠态进行判定.将连续变量纠缠的路径纠缠微波分解为大量2?2纠缠子系统叠加的纠缠态,证明其能够利用所构造的2?2纠缠见证算符来检测路径纠缠微波.同时分析了微波分束器的作用,并利用微波分束器设计了一种用于检测路径纠缠微波信号的实验方案,并在理论上分析了纠缠检测所得到的结果.结果表明,该方法能够有效检测路径纠缠微波信号,降低了检测的复杂度和计算量.本文的研究为纠缠微波的检测提供了思路.     

Human‐Serum‐Albumin‐Coated Prussian Blue Nanoparticles as pH‐/Thermotriggered Drug‐Delivery Vehicles for Cancer Thermochemotherapy

Constructing novel multimodal antitumor therapeutic nanoagents has attracted tremendous recent attention. In this work, a new drug‐delivery vehicle based on human‐serum‐albumin (HSA)‐coated Prussian blue nanoparticles (PB NPs) is synthesized. It is demonstrated that doxorubicin (DOX)/HSA is successfully loaded after in situ polymerization of dopamine onto PB NPs, and the PB@PDA/DOX/HSA NPs are highly compatible and stable in various physiological solutions. The NPs possess strong near‐infrared (NIR) absorbance, and excellent capability and stability of photothermal conversion for highly efficient photothermal therapy applications. Furthermore, a bimodal on‐demand drug release sensitively triggered by pH or NIR irradiation has been realized, resulting in a significant chemotherapeutic effect due to the preferential uptake and internalization of the NPs by cancer cells. Importantly, the thermochemotherapy efficacy of the NPs has been examined by a cell viability assay, revealing a remarkably superior synergistic anticancer effect over either monotherapy. Such multifunctional drug‐delivery systems composed of approved materials may have promising biomedical applications for antitumor therapy.     

热处理和紫外辐射对DNA影响的拉曼光谱研究

检测了鲕鱼精ＤＮＡ纤维和经过４０℃，９１℃，２００℃加热处理的拉曼光谱。研究结果表明，在熔融温度以下热处理对ＤＮＡ构象的影响是轻微的，在熔融温度以上则随温度的升高，对ＤＮＡ分子结构的影响有破坏也逐渐加剧，首先受影响的是腺嘌呤和脱氧核糖。     

Analysis and Verification on the Chain-like Model with Normal Distribution of Magnetorheological Elastomer

在磁流变弹性体链化模型的基础上,引入斜链夹角的正态分布,采用偶极子法从理论上分析了诸多因素对磁流变弹性体磁致剪切模量的影响,包括颗粒链的初始倾斜角、外加磁场强度、剪应变大小等,并进行了实验验证.     

TDI CCD像元响应不一致性校正算法

线阵TDI CCD遥感相机的不一致性校正对获取高质量的图像来说具有重要意义。主要对TDI CCD像元响应不一致性的校正算法及其硬件实现进行了深入的研究。对CCD的噪声特性进行了详细的分析,给出了像元响应不一致性(PRNU:Pixel-response non-uniformity)的退化模型及校正算法,并对其计算精度进行了分析,在硬件电路上对校正算法进行了验证,详细分析了影响校正效果的各种因素。实测结果表明,校正后图像的信噪比得到显著提高。     

Gray photorefractive polymeric optical spatial solitons

We show that gray spatial optical solitons are possible in biased photorefractive polymers under steady-state conditions. We find that for a given material parameter the absolute value of a gray photorefractive polymeric soliton's phase decreases with an increase in the beam's grayness, whereas it increases with the material parameter for a given beam's grayness and that the full width half maximum (FWHM) of the gray soliton beam's intensity increases with the beam's grayness when the normalized background intensity and the material parameter are fixed and decreases with an increase in the normalized background intensity when the material parameter is fixed. On the other hand, we also show that N coupled beam evolution equations in biased photorefractive polymers can exhibit multicomponent gray solitons. These multicomponent gray solitons can be obtained provided that the N coupled beams share the same polarization, wavelength, and are incoherent with one another. The characteristics and stability properties of these multicomponent gray solitons are also discussed in detail.     

压电波形对喷墨打印电极的调控规律

压电喷墨打印是制备印刷电子器件的主要手段之一,其墨滴喷射状态直接受压电波形的影响,因而压电波形对于器件打印具有重要意义。本文主要研究了压电波形对薄膜晶体管(TFT)电极打印效果的影响,实验通过改变压电波形的加压速率和脉冲持续时间,打印得到了一系列的电极样品,并对其图形效果及表面粗糙度进行了测量。实验表明,随着加压速率和脉冲持续时间的增大,墨滴喷出动能增大,最终打印的图形效果先改善后恶化,表面粗糙度则随之增大。在加压速率取值为0.08~1.65 V/μs、脉冲持续时间取值为1.216~2.688μs的区间内得到了失真程度较小的电极图形,在加压速率及脉冲持续时间分别为0.25 V/μs、2.688μs及0.65 V/μs、1.600μs时,电极图形化效果较好,表面粗糙度分别为59.04 nm和59.27 nm。通过对压电波形参数的合理设置,能够实现对打印图形效果的优化。     

交叉分子束方法研究H+CH4和H+CD4反应:CH3/CD3的振动激发态产物通道

We study the H+CH₄/CD₄→H₂/HD+CH₃/CD₃ reactions using the time sliced velocity map ion imaging technique. Ion images of the CH₃/CD₃ products were measured by the (2+1) resonance enhanced multi-photon ionization (REMPI) detection method. Besides the CH₃/CD₃ products in the ground state, ion images of the vibrationally excited CH₃/CD₃ products were also observed at two collision energies of 0.72 and 1.06 eV. It is shown that the angular distribution of the products CH₃/CD₃ in vibrationally excited states gradually vary from backward scattering to sideways scattering as the collision energy increases. Compared to the CH₃/CD₃ products in the ground state, the CH₃/CD₃ products in vibrationally excited states tend to be more sideways scattered, indicating that larger impact parameters play a more important role in the vibrationally excited product channels.