用双表面活性剂为共模板合成中孔分子筛MCM-48

利用水热法以非离子表面活性剂聚乙二醇辛基苯基醚和阳离子表面活性剂十六烷基三甲基溴化铵为共模板合成了中孔分子筛MCM-48.实验中发现利用较强的范德华力和氢键,聚乙二醇辛基苯基醚可在很大程度上降低合成MCM-48所需阳离子表面活性剂的用量,且利于制备有序性好、骨架聚合度高、稳定性好的MCM-48.通过调节聚乙二醇辛基苯基醚与十六烷基三甲基溴化铵的比例,可得到不同物相结构的分子筛.     

In search of covalently bound tetra- and penta-oxygen species: a photoelectron spectroscopic and Ab initio investigation of MO4- and MO5- (M = Li,Na, K,Cs)

Although neutral and ionic O4(0/-/+) species have been observed experimentally and considered for energetic materials, O4(2-) and O5(2-) dianions have not yet been explored. O4(2-) is valent isoelectronic to the well-known ClO3- and SO3(2-) anions, and O5(2-) is valent isoelectronic to ClO4- and SO4(2-). All are stable, common anions in solutions and inorganic salts. In this article, we explore the possibility of making covalently bound O4(2-) and O5(2-) species stabilized in the forms of M+O4(2-) and M+O5(2-) (M = Li, Na, K, Cs) in the gas phase. Laser vaporization experiments using M-containing targets and an O2-seeded carrier gas yielded very intense mass peaks corresponding to MO4- and MO5-. To elucidate the structure and bonding of the newly observed MO4- and MO5- species, we measured their photoelectron spectra and then compared them with ab initio calculations and the spectra of ClO3-, Na+SO3(2-), ClO4-, and Na+SO4(2-). Careful analyses of the experimental and ab initio results showed, however, that the observed species are of the forms, O2-M+O2- and O2-M+O3-. The more interesting M+O4(2-) and M+O5(2-) species were found to be higher-energy isomers, but they are true minima on the potential energy surfaces, which suggests that it might be possible to synthesize bulk materials containing covalently bound tetra- and pentatomic oxygen building blocks.     

C反应蛋白免疫电极的研究

C反应蛋白(CRP)是临床医学中重要的检验项目之一。本文以醋酸纤维素-戊二醛-己二胺载体膜与自制的原电极研制成非标记CRP免疫电极。研究了载体膜的组成对电极灵敏度的影响,并采用均匀设计法对载体膜的活化条件、抗原抗体结合时间以及电极测试条件等进行了优化。该电极响应快、灵敏度高、重现性和稳定性良好。在最佳实验条件下,电极线性范围为1.8～60μg/ml,所得线性回归方程为E=0.2+0.091[CRP];相关系数0.9989。在用于血清样品的测定中,取得满意结果。     

测定核黄素的化学发光新方法

研究了核黄素的化学发光性质，建立了一种测定核黄素的化学发光新方法，并应用于实际样品中核黄素的测定，与文献相比，本方法无需避光，而且分析体系和样品处理简单；干扰小，牛血清白蛋白、抗坏血酸、天冬氨酸等８种生物有机物质和 Ｃｕ（Ⅱ）、Ｚｎ（Ⅱ）、Ｆｅ（Ⅲ）等１５种常见金属离子的允许量较大；核黄素溶液浓度在０． １０～５０ ｍｇ／Ｌ范围内，与化学发光强度成正比，方法线性范围宽；测定１．０ｍｇ／Ｌ核黄素溶液１２次，求得相对标准偏差为２．９％，方法精密度高；方法的检测限为０．０７５ ｍｇ／Ｌ，灵敏度高。     

Reversible wettability of a chemical vapor deposition prepared ZnO film between superhydrophobicity and superhydrophilicity

A superhydrophobic ZnO thin film was fabricated by the Au-catalyzed chemical vapor deposition method. The surface of the film exhibits hierarchical structure with nanostructures on sub-microstructures. The water contact angle (CA) was 164.3 degrees, turning into a superhydrophilic one (CA < 5 degrees) after UV illumination, which can be recovered through being placed in the dark or being heated. The film was attached tightly to the substrate, showing good stability and durability. The surface structures were characterized by scanning electron microscopy and atomic force microscopy.     

Preparation and characterization of sulfated zirconia (SO4/ZrO2)/Nafion composite membranes for PEMFC operation at high temperature/low humidity

Fine particle superacidic sulfated zirconia (SO₄²⁻/ZrO₂, S-ZrO₂) was synthesized by ameliorated method, and composite membranes with different S-ZrO₂ contents were prepared by a recasting procedure from a suspension of S-ZrO₂ powder and Nafion solution. The physico-chemical properties of the membranes were studied by ion exchange capacity (IEC) and liquid water uptake measurements, scanning electron microscopy (SEM) and X-ray diffraction (XRD) analysis, thermogravimetry–mass spectrometry (TG–MS) and Fourier transform infrared (FT-IR) spectroscopy. The results showed that the IEC of composite membrane increased with the content of S-ZrO₂, S-ZrO₂ was compatible with the Nafion matrix, the incorporation of the S-ZrO₂ could increase the crystallinity and also improve the initial degradation temperature of the composite membrane. The performance of single cell was the best when the S-ZrO₂ content was 15 wt.%, and achieved 1.35 W/cm² at 80 °C and 0.99 W/cm² at 120 °C based on H₂/O₂ and at a pressure of 2 atm, the performance of the single cell with optimized S-ZrO₂ was far more than that of the Nafion at the same condition (e.g. 1.28 W/cm² at 80 °C, 0.75 W/cm² at 120 °C). The 15 wt.% S-ZrO₂/Nafion composite membrane showed lower fuel cell internal resistance than Nafion membranes at high temperature and low relative humidity (RH).     

Development and validation of HPLC methods for enantioseparation of mirtazapine enantiomers at analytical and semipreparative scale using polysaccharide chiral stationary phases

Novel HPLC methods were developed for the analytical and semipreparative resolution of new antidepressant drug mirtazapine enantiomers. At analytical scale, the separation of the mirtazapine enantiomers was investigated using both cellulose and amylose tris(3,5-dimethylphenylcarbamate) (CDMPC and ADMPC) chiral stationary phases under normal-phases and polar organic modes. Good baseline enantioseparation was achieved using cellulose tris(3,5-dimethylphenylcarbamate) chiral stationary phases under both normal-phases and polar organic modes. Furthermore, the elution order of mirtazapine enantiomic pairs was found reversed by changing the stationary phase from the amylose-based ADMPC–CSPs to its cellulose-based counterpart, CDMPC–CSPs. The validation of the analytical methods including linearity, limit of detection (LOD), limit of quantification (LOQ), recovery and precision, together with the semipreparative resolution of mirtazapine racemate were carried out using cellulose tris(3,5-dimethylphenylcarbamate) chiral stationary phases and methanol as mobile phase without any basic additives under polar organic mode. At analytical scale, the elution times of both enantiomers were less than 6 min at normal temperature and 1.0 ml/min, with the separation factor () 1.99 and the resolution factor (Rs) 3.56. Then, the analytical methods were scaled up to semipreparative loading to obtain small quantities of both mirtazapine enantiomers. At semipreparative scale, about 16 mg/h enantiomers could be isolated and elution times of both enantiomers were less than 10 min at 2.0 ml/min. To increase the throughput, the technique of boxcar injections was used. One enantiomer ((−)-(R)-mirtazapine) was isolated with purity of >99.9% e.e. and >98.0% yield and another ((+)-(S)-mirtazapine) was isolated with purity of >97.0% e.e. and >99.0% yield. In addition, optical rotation and circular dichroism (CD) spectroscopy of both mirtazapine enantiomers isolated were also investigated.     

随机模糊集与随机集

本文研究了三个方面的工作：一是定义了一种模糊集上的可测结构，从而定义了随机模糊集，这些定义都与论域Ｘ上的拓扑结构无关。将通常意义下的集合看成特殊模糊集得到的通常集合上的超可测结构与文（３）中的定义一致；二是给出了随机模糊集、随机集的一些等价条件；三是研究了随机模糊集、随机集的分布与其有限维落影族的关系。     

Stab-Resistant Performance of the Well-Engineered Soft Body Armor Materials Using Shear Thickening Fluid

Stab-resistant body armor can effectively prevent sharp instruments from attacking the protected parts and reduce the threat to human bodies. Shear thickening fluid (STF) is a kind of smart material with variable viscosity and its viscosity can change significantly with external stimuli. The soft and adaptive characteristics of STF provide a new idea for improving the performance of stab-proof materials. In this work, three kinds of soft anti-stabbing materials were designed and prepared with aramid, poly–p–phenylene benzodioxazole (PBO), and carbon fiber fabrics impregnated with STF. Quasi-static puncture tests and dynamic impact tests were conducted to compare the performance of different anti-stabbing structures. The results showed that the peak piercing force of the STF-treated fabrics in the puncture testing was greatly increased than that of neat samples. Against the D2 knife, the maximum impact load of STF/PBO fiber fabric was increased from 55.8 N to 72.9 N, increasing by 30.6%. Against the D3 spike, the maximum impact load of STF/aramid fabric was increased from 128.9 N to 254.7 N, increasing by 197.6%. The mechanical properties of fibers were important factors for the resistance to knives, and the fabric structure was the key point to bear the spike. Optical photographs of fabric fractures and scanning electron microscope analysis indicated that the STF effectively limited the slip of the fiber bundle when the tool penetrated the fabric, which played a positive role in maintaining the tightness and integrity of the fabric structure.     

A Modified Vancomycin Molecule Confers Potent Inhibitory Efficacy against Resistant Bacteria Mediated by Metallo-β-Lactamases

Multidrug-resistant bacterial infections mediated by metallo-β-lactamases (MβLs) have grown into an emergent health threat, and development of novel antimicrobials is an ideal strategy to combat the infections. Herein, a novel vancomycin derivative V_b was constructed by conjugation of triazolylthioacetamide and vancomycin molecules, characterized by reverse-phase high performance liquid chromatography (HPLC) and confirmed by matrix-assisted laser desorption/ionization-time of flight mass spectrometry (MALDI-TOF MS). The biological assays revealed that V_b effectively inhibited S. aureus and methicillin-resistant S. aureus (MRSA), gradually increased the antimicrobial effect of β-lactam antibiotics (cefazolin, meropenem and penicillin G) and exhibited a dose-dependent synergistic antibacterial effect against eight resistant strains tested, which was confirmed by the time-kill curves determination. Most importantly, V_b increased the antimicrobial effect of meropenem against the clinical isolates EC08 and EC10 and E. coli producing ImiS and CcrA, resulting in a 4- and 8-fold reduction in MIC values, respectively, at a dose up to 32 μg/mL. This work offers a promising scaffold for the development of MβLs inhibitors, specifically antimicrobials for clinically drug-resistant isolates.