LaB6场发射阵列牺牲层制备工艺

 分析了传统牺牲层材料铝在制备LaB6场发射阵列时存在的问题,利用溅射及热蒸发工艺依次制备铝膜和氧化锌膜,制备出了一种新型的牺牲层——ZnO-Al复合牺牲层,并对所制备的阵列进行了测试。实验结果表明：ZnO-Al复合牺牲层能够有效地解决电化学腐蚀的问题,所制备出的LaB₆场发射阵列尖锥保持了完好的形貌,其发射特性也达到了最初制备场发射阵列的要求,说明ZnO-Al复合牺牲层是作为LaB₆场发射阵列牺牲层的理想材料。     

Influence of laser mode on splitting beam illumination effect of Dammann grating

The influences of various laser modes on the splitting beam effect of Dammann grating are studied in theory and by numerical simulation. The results show that fundamental mode laser resembles plane wave while high order mode laser differs from plane wave in the splitting beam effect by Dammann grating. Therefore, the fundamental mode laser is more suitable to be the light source to improve the energy efficiency in far-distance image detecting systems, such as laser image ladar, which use Dammann grating in the ilhlmination svstem.     

木质素胺絮凝剂的制备及其脱色性能

以造纸污泥中提取的木质素和二乙基环氧丙基胺（简称环氧胺单体）为原料,通过接枝共聚反应制备了木质素胺絮凝剂（DL）,并确定了最佳合成工艺条件,同时采用傅里叶变换红外光谱（FTIR）对产物结构进行了表征。结果表明,以1.5mo1·L^-1NaOH为催化剂,木质素和环氧胺单体的质量比为1:1,于70℃下接枝反应2h时,所得絮凝剂DL对3种模拟染料废水的脱色率分别可达89.66%、74.10%和89.84%,通过比较DL与木质素的絮凝效果以及絮体微观形貌,对DL的絮凝机理进行了初步探讨。     

基于SERS光谱的银溶胶溶液中腺嘌呤的定量分析

碱基是构成核酸的物质基础。碱基的含量分析对于生物体的生理活动及新陈代谢过程研究具有重要意义。本文利用表面增强拉曼散射(SERS)光谱技术研究了腺嘌呤在相对稳定的银溶胶溶液中的SERS光谱信号强度与浓度的定量关系。研究表明添加聚合物作为稳定剂的银溶胶具有良好的稳定性。进一步研究表明, 在1×10-4~ 1×10-3mol ·L-1的浓度范围内, 以吡啶作为内标, 分析物腺嘌呤与内标物特征谱峰强度之比与腺嘌呤的浓度之间呈现良好的线性关系。     

多维漫透射光谱提高复杂混合溶液分析能力

多维漫透射光谱技术利用传统的近红外透射测量方式,增加一维扫描装置,获得透射方向上的径向光谱,并利用多点漫透射光谱对复杂混合溶液进行成分分析。实验设计了基于氙灯光源、精密电控平移台和光谱仪的检测装置,选用Intralipid-20%,India Ink和C₆H₁₂O₆共配制225种成分含量不同的混合溶液,分别测量距其透射中心点0～5 mm(间隔0.25 mm)范围内的20点漫透射光谱信号,以偏最小二乘回归算法对单点和多点漫透射光谱信号进行建模分析。实验得到India Ink含量和Intralipid-20%含量随漫透射光位置点的增加建模及预测的精度提高,C₆H₁₂O₆含量随漫透射光位置点的增加建模及预测精度没有明显变化。结果表明,增加不同位置信息的漫透射光谱信号,能够提高复杂混合溶液中强吸收物质和强散射物质的信噪比,对于弱吸收弱散射物质有望在提升系统精度的前提下提高其预测能力。     

Enhanced photocatalytic activity of TiO2 thin film coating on microstructured silicon substrate

Photocatalytic TiO2 thin film is prepared by sol–gel technique on microstructured silicon substrate produced by femtosecond laser cumulative irradiation. The photocatalytic activity is evaluated by the degradation of methylene blue (MB) solution under ultraviolet (UV) irradiation. For 6-ml MB solution with initial concentration of 3.0×10~-5 mol/L, the degradation rate caused by TiO2 thin film of 2-cm~2 area is higher than 70% after 10-h UV irradiation. Microstructured silicon substrate is found to enhance photocatalytic activity of the TiO2 thin film remarkably. The femtosecond laser microstructured silicon substrate is suitable to support TiO2 thin film photocatalysts.     

Pulse width compression and enhancement of peak power in a diode-pumped doubly Q-switched Nd:GdVO<Subscript>4</Subscript> 1.34 μm laser with AO and V<Superscript>3+</Superscript>:YAG saturable absorber

By using both acousto-optic (AO) modulator and V³⁺:YAG saturable absorber, a diode-pumped doubly Q-switched a-cut Nd:GdVO₄ laser at 1.34 μm is realized. The average output power and the pulse width for different AO repetition rate f have been measured. The experimental results show that the doubly Q-switched laser can compress the pulse width and improve the pulsed peak power in comparison to the singly Q-switched laser with AO or V³⁺:YAG saturable absorber. At the pump power 10.34 W and f = 10 kHz, the greatest pulse width compression ratio 72% and the highest peak power improvement 8.8 times have been obtained, respectively.     

HIRFL上合成的第一个新核素—208Hg

本文简述在中科院近物所HIRFL上发现的第一个新核素208Hg的合成和鉴别,兼论利用HIRFL提供的中能重离子束开展远离β稳定线核素合成和衰变研究的优势、困难以及拟采用的物理和技术路线。 The synthesis and identification of the first discovered new nuclide 208Hg on HIRFL(Heavy Ion Research Facility of Lanzhou) were described. In this paper the superiorities, difficultiesas well as the physical and technical line about the synthesis and decay study for the nuclides far fromβ-stability line to be made at HIRFL were discussed.     

Experimental study on the 1.94-μm laser performance of c-Cut Tm:YAP crystal with various doping concentration

The influence of the thulium ion concentration on the 1.94-??m laser performance of c-cut Tm:YAP crystal was investigated in this paper. Three crystals with 3, 4, and 5% Tm³⁺ (atom concentration) were examined at 18°C. Our experimental results showed that, the best power performance was obtained with the 4% Tm:YAP crystal. By using 24.8 W of incident pump power at 795 nm, a maximum of 7.5 W of output power was obtained. The slope efficiency was 48.8%, corresponding to diode-to-Tm conversion efficiency of 30.2%.     

Computer design of a compact cyclotron

Here we present results of the computer design of the structural elements of a compact cyclotron by the example of HITFiL cyclotron selected as the driving accelerator that is under construction at the Institute of Modern Physics (Lanzhou, China). In the article a complex approach to modeling of the compact cyclotron, including calculation of electromagnetic fields of the structural elements and beam dynamics calculations, is described. The existing design data on the axial injection, magnetic, acceleration and extraction systems of the cyclotron are used as a starting point in the simulation. Some of the upgrades of the cyclotron structural elements were proposed, which led to substantial improvement of the beam quality and transmission.