Black fungus derived aerogel with double faced properties

Black fungus aerogel (BFA) exhibited interesting double-faced properties. Weexplored the diverse properties of each side of the black fungus in three aspects:water contact angle measurements, liquid selective absorption capacity and air pollutant adsorption abilities.     

Solid-state synthesis of a conducting polythiophene via an unprecedented heterocyclic coupling reaction

Prolonged storage ( approximately 2 years) or gentle heating (50-80 degrees C) of crystalline 2,5-dibromo-3,4-ethylenedioxythiophene (DBEDOT) affords a highly conducting, bromine-doped poly(3,4-ethylenedioxythiophene) (PEDOT), as confirmed by solid-state NMR, FTIR, CV, and vis-NIR spectroscopies. The novel solid-state polymerization (SSP) does not occur for 2,5-dichloro-3,4-ethylenedioxythiophene (DCEDOT), and requires a much higher temperature (>130 degrees C) for 2,5-diiodo-3,4-ethylenedioxythiophene (DIEDOT). X-ray structural analysis of the above dihalothiophenes reveals short Hal.Hal distances between adjacent molecules in DBEDOT and DIEDOT, but not in DCEDOT. The polymerization may also occur in the melt but is significantly slower and leads to poorly conductive material. Detailed studies of the reaction were performed using ESR, DSC, microscopy, and gravimetric analyses. SSP starts on crystal defect sites; it is exothermic by 14 kcal/mol and requires activation energy of approximately 26 kcal/mol (for DBEDOT). The temperature dependence of the conductivity of SSP-PEDOT (sigma(rt) = 20-80 S/cm) reveals a slight thermal activation. It can be further increased by a factor of 2 by doping with iodine. Using this approach, thin films of PEDOT with conductivity as high as 20 S/cm were fabricated on insulating flexible plastic surfaces.     

The importance of temperature and viscosity effects for surfactant adsorption measurements made using the electrochemical quartz crystal microbalance

The measurement of adsorbed surfactant is important to fields such as corrosion inhibition, metal cleaning, and separation technologies. The electrochemical quartz crystal microbalance (EQCM) is an important tool that can be used to measure adsorbed surfactant. However, such measurements are subject to significant temperature and viscosity effects that must be appropriately considered. This paper discusses the effect of temperature and viscosity on EQCM measurements in solution environments and the ability of the EQCM to measure surfactant adsorption.     

Lithium isotope separation by chemical exchange with polymer-bound azacrown compounds

The chromatographic separation of lithium isotopes was investigated by chemical exchange with the recently synthesized polymer-bound dibenzo pyridino diamide azacrown (DBPDA) and reduced dibenzo pyridino diamide azacrown (RDBPDA). Column chromatography was employed for the determination of the effect of solvents and ligand conformation on the separation coefficients. The maximum separation coefficients, , for the DBPDA and RDBPDA at 20.0±0.02°C with acetonitrile as eluent, were found to be 0.034±0.002 and 0.035±0.002, respectively. The isotope separation coefficient and adsorption capability of the lithium ion on the DBPDA and RDBPDA were only slightly dependent on ligand structure, but strongly dependent on the solvent. DBPDA and RDBPDA appeared to have almost the same value for the isotope separation coefficient of lithium.     

辛基甲基亚砜与离子型表面活性剂在水溶液中的相互作用

本文用测定表面张力的方法研究了非离子表面活性剂辛基甲基亚砜(OMS)分别与离子型表面活性剂C_(10)H_(21)SO_4N_a(SDeS)、C_7F_(15)COONa(SPFO), C_(10)H_(21)N(CH_3)_3B_r(DeTAB)等在水溶液中的相互作用。发现上述混合体系的胶团形成及表面吸附都有不同程度的增效作用; 表面活性分子在吸附层中的相互作用参数β~s以及在胶团中的相互作用参数β~m均为负值并有一定变化规律; OMS与DeTAB的相互作用较OMS与SDeS或SPFO的相互作用弱得多; 此现象自OMS分子在水溶液中的质子化作用得到解释。     

Application of Et3NHCl-AlCl3 Ionic Liquid as an Initiator in Cationic Copolymerization of 1, 3-Pentadiene with Styrene

Room temperature ionic liquids (RTILs) as advanced, technological solvents can be designed to fit a particular application. They used as green “media and/or catalysts” for chemical synthesis have been extensively reviewed recently. RTILs1 not only show …     

Facile synthesis of substituted dihydro-1,4-dithiins and -1,4-dithiepins from α-oxo ketene cyclic dithioacetals

A novel and facile synthesis of substituted 2,3-dihydro-1,4-dithiins and 6,7-dihydro-5H-1,4-dithiepins based on the reactions of α-bromo/hydroxy ketones with α-oxo ketene cyclic dithioacetals has been developed. A general mechanism for the reactions is proposed.     

表面修饰二氧化锡纳米微晶的制备与表征

制备了硅烷偶联剂KH-570表面修饰的SnO2纳米微晶，通过FT-IR、XPS、TEM和TG-DTA对其结构和表面特性进行表征和研究. FT-IR和XPS分析结果确证了KH-570与SnO2表面是以化学键合或物理吸附方式相结合,粒子表面存在酯基等有机官能团的红外吸收特征；观测到KH-570中Si原子的Si2s和Si2p谱线. TEM分析表明，表面修饰反应增强了SnO2纳米微晶的疏水性和分散性.由XPS和TG的实测数据探讨了纳米粒子具有较低包覆量的可能原因.     

Self-assembly between silver(I) and di- and tri-2-pyridines with flexible spacer: formation of discrete metallocycle versus coordination polymer

The self-assembly of metallosupramolecules from reactions of flexible 2-pyridyl ligands and silver salts is described. When 1,3-bis(2-pyridyl)propane (L1), tris[(2-pyridyl)methyl]methane (L2), and 1,3-bis(2-pyridyl)-2-tolylpropane (L3) are used in combination with silver ions, novel discrete metallocyclic complexes are formed in crystals. Moreover, the self-assembly of 1,3-bis(2-pyridyl)-2-phenylpropane (L4) with silver nitrate yields a coordination polymer. The examination of its solution shows that this coordination polymer is formed via the solution-based discrete metallocyclic species.     

Asymmetric Intramolecular Hydroalkoxylation of Unactivated Alkenes Catalyzed by Chiral N‐Triflyl Phosphoramide and TiCl4†

By using a combination of a chiral N‐triflyl phosphoramide and TiCl₄ as the catalyst, a new process for asymmetric intramolecular hydroalkoxylation of unactivated alkenes was developed, producing various chiral tetrahydrofuran derivatives in 51%—99% yields with 30%—71% ee's.