Sediment records of Sb and Pb stable isotopic ratios in Lake Qinghai

A sediment core in Lake Qinghai in northwest China was collected in 2006. ¹³⁷Cs and ²¹⁰Pb activities were analyzed to investigate the chronology of the sediment core. Sb and Pb concentrations, and Pb stable isotopic ratios were analyzed to study the historical atmospheric deposition records and sources of Sb over the past 15 centuries. The Sb concentration was 4.21 ± 1.52 μg/g in the sediments, its vertical distribution of Sb shows three large peaks in the recent two centuries, 1799, 1896 and 1944, coincided with Sb contamination from large wars, respectively. The peak in 1920 responded the large earthquake that happened in northern China, which was not far away from Lake Qinghai. The Sb/Pb ratio, ²⁰⁶Pb/²⁰⁷Pb and ²⁰⁸Pb/²⁰⁶Pb results suggest that Sb and Pb were probably from the ores in South China and coals in North China before 1965, but obviously from uses of leaded gasoline after 1965.     

Carbon monoxide-assisted synthesis of single-crystalline Pd tetrapod nanocrystals through hydride formation

Carbon monoxide can adsorb specifically on Pd(111) to induce the formation of unique Pd nanostructures. In the copresence of CO and H(2), single-crystalline Pd tetrapod nanocrystals have now been successfully prepared. The Pd tetrapods are enclosed by (111) surfaces and are yielded through hydride formation. Density functional theory calculations revealed that the formation of PdH(x) in the presence of H(2) reduces the binding energy of CO on Pd and thus helps to decrease the CO coverage during the synthesis, which is essential to the formation of the PdH(x) tetrapod nanocrystals. In addition to tetrapod nanocrystals, tetrahedral nanocrystals were also produced in the copresence of CO and H(2) when the reaction temperature was ramped to further lower the CO coverage. Upon aging in air, the as-prepared PdH(x) nanocrystals exhibited a shape-dependent hydrogen releasing behavior. The conversion rate of PdH(x) tetrapod nanocrystals into metallic Pd was faster than that of tetrahedral nanocrystals.     

纳米抗癌药物载体的研究进展

与传统抗癌药物相比,纳米抗癌药物载体具有可在体内实现长循环,于癌症组织处富集,在体内缓慢可控释放,药物利用率高,药效高,并且生物相容性与可降解性良好的优点。目前已经实现包括纳米微粒、纳米胶束、树枝状大分子等多种结构的纳米抗癌药物载体的设计,选用的药物载体材料也涵盖多种聚酯以及蛋白质多肽等生物相容性良好的材料。     

稀土改质催化剂对废食用油制备燃料油的影响

利用浸渍法制备稀土改质催化剂,用于废食用油脂催化裂解的裂解气催化改质。考察了催化剂活性组分含量、硅铝比、焙烧温度、改质反应温度对产物组成、烯烃含量及收率的影响。得最佳条件:ZSM-5作为催化剂载体,催化剂活性组分镧稀土含量为6%,催化剂焙烧温度为550℃,改质反应温度为360℃。在最佳条件下催化改质,燃料油烯烃含量降低了34.3%,汽油含量提高了14.36%,轻柴油含量提高了1.67%,重柴油含量下降了6.72%,重油含量下降了2.2%,燃料油总收率提高了7.12%,油品质显著提高。     

Simultaneous determination of trifloxystrobin and trifloxystrobin acid residue in rice and soil by a modified quick,easy, cheap,effective, rugged,and safe method using ultra high performance liquid chromatography with tandem mass spectrometry

A sensitive analytical method for the simultaneous determination of trifloxystrobin and its metabolite trifloxystrobin acid in rice including straw, bran, brown rice and soil was developed by using ultra high performance liquid chromatography coupled with tandem mass spectrometry. The fungicide trifloxystrobin and its metabolite trifloxystrobin acid were extracted using acetonitrile with 1% formic acid v/v and subsequently cleaned up by primary secondary amine, octadecylsilane or graphitized carbon black prior to ultra high performance liquid chromatography coupled with tandem mass spectrometry. The determination of two target compounds was achieved in less than 3 min using an electrospray ionization source in positive mode. The limits of detection were below 0.22 μg/kg and the limits of quantification did not exceed 0.74 μg/kg in all matrices, which were much lower than the maximum residue levels established by the Codex Alimentarius Commission. The overall average recoveries in four matrix at three levels (0.1, 1.0 and 5.0 mg/kg) ranged from 74.2 to 107.4% with a relative standard deviations of less than 7.8% (n = 5) for both analytes. The method was demonstrated to be convenient and reliable for the routine monitoring of trifloxystrobin and its metabolite. The developed method was validated and applied for the analysis of degradation study samples.     

二价与四价金属离子等摩尔共掺杂的锂离子电池正极材料LiMn1.9Mg0.05Ti0.05O4的制备与表征

以氢氧化锂、乙酸锰、硝酸镁和钛酸丁酯为原料, 以柠檬酸为螯合剂, 采用溶胶-凝胶法制备了二价镁离子与四价钛离子等摩尔共掺杂的尖晶石型锂离子电池正极材料LiMn_1.9Mg_0.05Ti_0.05O₄. 采用热重分析(TGA), X射线衍射(XRD), 扫描电子显微镜(SEM), 透射电子显微镜(TEM)和电化学性能测试(包括循环伏安(CV)和电化学交流阻抗谱(EIS)测试)对所得样品的结构、形貌及电化学性能进行了表征. 结果表明: 780℃下煅烧12 h 得到了颗粒均匀细小的尖晶石型结构的LiMn_1.9Mg_0.05Ti_0.05O₄材料, 该材料具有良好的电化学性能, 在室温下以0.5C倍率充放电, 在4.35-3.30 V电位范围内放电比容量达到126.8 mAh·g^-1, 循环50 次后放电比容量仍为118.5mAh·g^-1, 容量保持率为93.5%. 在55℃高温下循环30次后的放电比容量为111.9 mAh·g^-1, 容量保持率达到91.9%, 远远高于未掺杂的LiMn₂O₄的容量保存率. 二价镁离子与四价钛离子等摩尔共掺杂LiMn₂O₄, 改善了尖晶石锰酸锂的电子导电和离子导电性能, 使其倍率性能和高温性能都得到了明显的提高.     

Breathing Effect in a Cobalt Phosphonate upon Dehydration/Rehydration: A Single‐Crystal‐to‐Single‐Crystal Study

Two cobalt phosphonates, [Co₂(2,2′‐bpy)₂(H₂O)(pbtcH)] ( 1 ) and [Co₂(H₂O)(pbtcH)(phen)₂] ( 2 ; pbtcH₅=5‐phosphonatophenyl‐1,2,4‐tricarboxylic acid, 2,2′‐bpy=2,2′‐bipyridine, phen=1,10‐phenanthroline), with layer structures are reported. Compound 1 contains O‐C‐O and O‐P‐O bridged tetramers of Co₄, which are further connected by pbtcH^4? units to form a layer. In compound 2 , the cobalt tetramers made up of water‐bridged Co₂ dimers and O‐P‐O linkages are connected into a layer by pbtcH^4? units. Upon dehydration, compounds 1 and 2 experience single‐crystal‐to‐single‐crystal (SC–SC) structural transformations to form [Co₂(2,2′‐bpy)₂(pbtcH)] ( 1 a ) and [Co₂(pbtcH)(phen)₂] ( 2 a ), respectively. The process is reversible in each case. Notably, a breathing effect is observed for 1 , accompanied by pore opening and closing due to the reorientation of the coordinated 2,2′‐bpy molecules. The transformation was also monitored by in situ IR measurements. Magnetic studies reveal that antiferromagnetic interactions are mediated between the magnetic centers in compounds 1 and 1 a , whereas ferromagnetic interactions are dominant in compound 2 .     

表面官能团化增强碳纳米笼超级电容器性能

以具有多级孔结构、高比表面积、良好导电性等特征的碳纳米笼（CNCs）为前体,采用硝酸氧化法在CNCs表面引入含氧官能团。以CNCs为超级电容器电极材料,在相同电流密度下,官能团化样品的比电容显著高于纯CNCs;在1A·g^-1下比电容最高可达到255F·g^-1,比纯CNCs的188F·g^-1增加了34%,这表明表面含氧官能团化能够显著提高CNCs的超级电容器比电容。在100A·g^-1的大电流密度下,硝酸氧化后CNCs的比电容保持在111~167F·g^-1,表明具有良好的耐大电流充放电性能。在10A·g^-1的电流密度下循环10000圈后,CNC-6M样品的比电容由196F·g^-1下降到176F·g^-1,样品的比电容仍保留90%,具有良好的循环稳定性。表面含氧官能团化CNCs所表现出的这种优异的超级电容器性能归因于CNCs的多尺度分级孔结构、高比表面积、良好的导电性、表面亲水性含氧官能团化带来的浸润性提高和引入的赝电容。     

Color Point Tuning in Lu3−x−yMnxAl5−xSixO12:yCe3+ for White LEDs

A series of the solid‐solution phosphors Lu_3?x?yMn_xAl_5?xSi_xO₁₂:yCe³⁺ is synthesized by solid‐state reaction. The obtained phosphors possess the garnet structure and exhibit similar excitation properties as the phosphor Lu₃Al₅O₁₂:Ce³⁺, but with an effectively improved red component in the emission spectrum. This can be attributed to the energy transfer from Ce³⁺ to Mn²⁺. Our investigation reveals that electric dipole–quadrupole interactions dominate the energy‐transfer mechanism and that the critical distance determined by the spectral overlap method is about 9.21 Å. The color‐tunable emissions of the Lu_3?x?yMn_xAl_5?xSi_xO₁₂:yCe³⁺ phosphor as a function of Mn₃Al₂Si₃O₁₂ content are realized by continuously shifting the chromaticity coordinates from (0.354, 0.570) to (0.462, 0.494). They indicate that the obtained material may have potential application as a blue radiation‐converting phosphor for white LEDs with high‐quality white light.