LD-end-pumped Nd:YAP laser operating at 1341.4 nm and doubling of its frequency

We report an LD-end-pumped linearly-polarized continuous-wave (CW) Nd:YAP laser operating at 1341.4 nm. Making use of the plane-concave resonator (T = 2.4%) and the plane-plane resonator (T = 2.6%), we obtain linearly-polarized laser radiation at 1341.4 nm with a power of 3.15 and 2.86 W and corresponding optical slope efficiency of 18.4 and 17.5%, respectively. The effect of the laser oscillation mode on the output is analyzed. An experiment on the intra-cavity frequency doubling with an LBO crystal has been performed, and a laser power of 431 mW in one direction at 670.7 nm was obtained.     

翼型前缘分离流动在等离子体激励器控制下的响应

将等离子体对中性气体的作用模型化为彻体力矢量,采用DES(Detached Eddy Simulation)和DDES(Delayed-Detached Eddy Simulation)方法,求解带彻体力源项的Navier-Stokes方程,研究NACA0015翼型16°迎角下,前缘分离流动在等离子体激励器控制下的响应过程.激励器工作后,DDES计算结果显示,分离流动经历一个渐近的再附过程;DES计算因发生网格诱导分离,得到了非定常的响应过程.     

Y型四能级系统中电磁感应透明和巨Kerr非线性效应的研究

在Y型四能级原子系统中理论分析了外加相干控制场的强度变化对电磁感应透明和Kerr非线性效应的影响.结果发现:当外加的耦合场和抽运场的强度从相等变得不相等时,原子系统对探测场的吸收曲线从一个透明窗口逐渐变成了具有两个透明点的增益区间,透明点的位置、增益值的大小以及增益区间的宽度都与变化着的外场的拉比频率密切相关;当两个外场强度较弱并且相对强度减小时,Kerr非线性效应有所增强但同时伴随有吸收;而当两个外场的强度较强并且相对强度增大时,Kerr非线性的峰值也随之增大并且逐渐与透明点对应,即获得了无吸收巨Kerr非线性效应.研究还发现,抽运场的强度变化对Kerr非线性增强的影响作用较耦合场要大.     

非球面碳化硅反射镜的加工与检测

为了获得高精度非球面碳化硅(SiC)反射镜,对非球面碳化硅反射镜基底以及改性后碳化硅反射镜表面的加工与检测技术进行了研究。介绍了非球面计算机控制光学表面成型（CCOS）技术及FSGJ-2非球面数控加工设备。采用轮廓检测法和零位补偿干涉检测法分别对碳化硅反射镜研磨和抛光阶段的面形精度进行了检测,并采用零位补偿干涉检测法及表面粗糙度测量仪对最终加工完毕的碳化硅反射镜的面形精度和表面粗糙度进行检测。测量结果表明：各项技术指标均满足设计要求,其中非球面碳化硅(SiC)反射镜实际使用口径内的面形精度（RMS值）为0.016λ(λ=0.6328μm）,表面粗糙度（RMS值）为0.85nm。     

Sigma Meson Production in Nuclear Reactions

The sigma meson production in p ＋ ^12C and p A- ^40Ca reactions at the incident energy Ep = 1.5 GeV is investigated within the Quantum Molecular Dynamics model. The simulation results indicate a distinctive A dependence of the sigma production, that is, the increase of A is followed by an increase of the production cross sections. We find that the σ meson production in proton-induced reactions is strongly medium-dependent, and the produced σ mesons decaying in a denser medium experience a stronger mass shift towards lower masses. This mass shift is an experimentally accessible observable in the final state pion pairs, which do not suffer from reabsorption by the surrounding nucleons. It is pointed out that the ratio of measured sigma cross sections as a function of the sigma invariant-mass from various reactions is a good probe to explore the existence of the σ meson in a dense nuclear environment.     

LOM and HOM damping study in a superconducting deflecting cavity for ALS at LBNL

Superconducting deflecting cavities can be used in synchrotron light source to generate subpicosecond X-ray pulses while the impedance of the lower order modes (LOM) and higher order modes (HOM) in the cavity should be kept below an accepted level to avoid beam instability. These modes can be damped by adding waveguide on beam pipe. Detailed simulation of Q in CST Microwave Studio is introduced and experiment results on an aluminum model cavity with damping waveguide are reported to make a comparison.     

光栅莫尔条纹在机床数控改造中的应用研究

从机床数控改造的实际出发,针对我国目前国产机床加工精度普遍不高,数控化程度较低等问题,提出了一种全新的设计方案,利用光栅作为位置检测元件,形成全闭环控制系统,结果表明既能够大大提高零件的加工精度,又能节省改造成本,为机床数控改造提供了参考。     

Calculations of Photo-Ionization Cross Sections for Lithium Atoms

Photo-ionization cross sections for the ground and the ≤5 excited states of lithium atoms are calculated in the photoelectron energy ranging from threshold to 0.5 Rydberg. The wavefunctions for both the bound and continuum states are obtained by solving the SchrSdinger equation numerically in a symplectic scheme. Our results are in excellent agreement with the recent experimental measurements and in harmony with other theoretical calculations.     

基于MEMS微镜的傅里叶变换光谱仪原理与分析

提出了一种新型的基于可编程MEMS(micro-electro-mechanical systems)微镜的微型傅里叶变换红外光谱仪。该光谱仪采用可编程MEMS微镜和倾斜反射镜替代了传统傅里叶变换光谱仪的动镜系统。理论分析了该光谱仪的工作原理,并进行了计算机仿真,验证了该方法的可行性。结果表明,该光谱系统能够准确地还原光谱信息,其光谱分辨率在近红外区域小于5 nm,波长准确性约1 nm,系统理论上的信号采集周期约50 ms。适合于利用阿达玛变换提高信噪比,可应用于微量物质检测。     

Controllable 0-pi transition in a superconducting graphene-nanoribbon junction

The supercurrent in a Josephson junction composed of the zigzag edged graphene nanoribbon (ZGNR) lying between two superconducting leads [superconductor-graphene-superconductor (SGS) junction] has been studied by the Green's function method. It is found that a small transverse electric field applied on the ZGNR can reverse the supercurrent direction, leading to a so-called 0-pi phase transition. The 0-pi phase transition can happen periodically with a change in the ZGNR's length, and, more importantly, can be easily and electrically controllable by a gate voltage, which is absent in the conventional superconducting pi junction and would make the SGS junction very promising for future application in superconducting electronics, as well as quauntum information and computation.