气相色谱-质谱联用法测定维生素C泡腾片中的甜蜜素

采用气相色谱-质谱(GC-MS)选择离子监测法(SIM),建立了准确可靠、灵敏度高、快速简便的测定维生素C泡腾片中甜蜜素含量的新方法.样品中的甜蜜素衍生后用有机试剂提取,在选择离子模式下进行测定,以保留时间和特征离子比例进行定性,单离子定量.甜蜜素的线性范围为0.05-10mg/L,检出限为0.6mg/kg,回收率为90.5%-96.9%,相对标准偏差小于4.4%.方法分析所用时间短,结果准确可靠,选择性好,适用于维生素C泡腾片中甜蜜素含量的检验.     

一类时变需求且存货影响销售率的EOQ模型

从实际背景出发,在R AM P型需求和存货影响销售率条件下,讨论了一类以缺货开始的变质性物品的EOQ模型.给出了模型的求解方案及单位时间内平均利润最大化的两个充分条件,并用数值算例进行了验证.     

锰(Ⅱ)-高碘酸钾-灿烂绿体系测定水中痕量锰

在 HAc- Na Ac环境中 ,锰 ( )对于高碘酸钾氧化灿烂绿的反应具有很强的催化作用。据此 ,建立了催化动力学光度法测定痕量锰 ( )的新方法。该方法的检出限为 2 .2 2× 10 -11g/ m L ,测定线性范围为0 .1— 12 ng/ m L。直接用于环境水样中锰的测定 ,获得满意的结果     

关于拟AP内射模的一些研究

Let R be a ring. R is called right AP-injective if, for any a ∈ R, there exists a left ideal of R such that lr(a) = Ra (?) Xa. We extend this notion to modules. A right .R-module M with 5 = End(MR) is called quasi AP-injective if, for any s ∈ S, there exists a left ideal Xs of S such that ls(Ker(s)) = Ss (?) Xs. In this paper, we give some characterizations and properties of quasi AP-injective modules which generalize results of Page and Zhou.     

考虑通货膨胀与最长顾客等待时间的变质性物品的库存模型

本文建立了一种考虑通货膨胀与时间价值的变质性物品的库存模型,在模型中允许短缺发生且拖后的需求速率与在缺货期间已经发生的缺货量有关.和已有相关模型的主要区别在于本模型把一个可重复的订货周期内的最大平均利润的净现值作为目标函数,且增加了在缺货期间最长顾客等待时间的限制,以确保库存系统拥有较高的服务水平.然后讨论了模型最优解的存在性与唯一性,并提供了寻求模型整体最优解的算法.最后用实例说明了此模型在实际中的应用.     

对一个统计控制问题的再探讨

本文对利用回归模型进行统计控制的问题进行了进一步研究,发现已有的方法有值得改进之处,并为此提出了一种新的求解控制阈值的方法。模拟和实例研究表明我们的方法适用于一般的误差分布情形,而且在误差分布为非正态时优于已有的方法。     

黄芪成分F3新制剂的工艺监测

对黄芪成分F3新制剂中多糖、蛋白质进行了工艺监测，多糖提取达99．2％，蛋白质≤0．2％，符合黄芪成分F3的质量标准要求，达到了选择最佳提取工艺的目的，结果令人满意。     

Stopband Phenomena in the Passband of Left-Handed Metamaterials

Stopband phenomena are reported in the passband of left-handed metamaterials. The samples with linear defect are designed by removing one layer of split ring resonators （SRRs）. It is shown that the left-handed transmission peaks have a distinct transform with the relative deviation of the SRRs centre from the wire centre 8, from a single left-handed peak, double left-handed peaks with different magnitude to no transmission peak, i.e. left-handed properties of metamaterials disappear. Numerical simulation shows that the change of 8 makes the effective permeability shift at a frequency range, where stopband occurs. It is thought that the stopband in left-handed passband is due to the symmetry breaking between SRRs and wires in the metamaterials.     

Optimization of a Cryogenic System at Temperature 2 K for the PKU-FEL Facility

The conceptual design of a cryogenic system at temperature 2 K for the Peking University Free Electron Laser （PKU-FEL） facility is carried out. In order to minimize the scale of the cryogenic system and the running cost, the superconducting accelerator and the superconducting injector will mainly run at a long-pulsed mode. Optimization of the 2-K cryogenic system is carried out based on the heat load estimation and running parameters. Total cooling power of 52.5 W for the long-pulsed mode is necessary for the PKU cryogenic system. The PKU cryogenic system will be the first 2-K system for accelerators in China and will provide experience for similar facilities.     

ECR-SFC轴向注入系统聚束器效率的研究

为了减少目前SFC轴向注入系统中聚束器杂散电场对束流轴向注入效率的影响, 提高新系统中SFC的束流俘获效率, 参考原始设计, 对目前聚束器的电极结构进行了设计改进. 两种情况下的聚束器杂散场对注入效率影响的计算表明, 改进后0B02的聚束效率较目前有较大提高. 同时计算了束流空间电荷效应对聚束效率的影响, 据此对新SFC轴向注入系统中聚束器的位置进行了重新调整.