氯化聚乙烯弹性体的固相法合成

讨论了以固相法合成氯化聚乙烯（ＣＰＥ）弹性体的过程．实验结果表明，以固相氯化反应所得的ＣＰＥ，其大分子链上Ｃｌ取代基的分布比水相悬浮法更均匀．氯化过程的温度直接影响氯化速度及分子结构，如残留结晶、氯分布等．而聚乙烯颗粒表面与内部的氯化程度取决于氯化速度．大分子链上Ｃｌ取代基对邻近基团的氯化起阻碍作用     

Hexa-Coordinate phosphorus Chemistry and Life Chemistry

The amino acids' side chains were acting as the relay device to regulate the chemical reactivi-ties of the N-phosphoryl amino acids. These modulation effects were performed through the partici-pation of the phosphoryl group.     

Synthesis and Crystal Structure of Cadmium（Ⅱ） Complex [Cd（H2O）（CH3OC6H4COO）2]n

1 INTRODUCTION Cadmium (Ⅱ) complexes have been exten- sively studied from both chemical and structural views, mainly due to the capability of cadmium (Ⅱ) (shared by most d10 metal ions) to adopt different modes of coordination determined by the consideration of size, as well as electrostatic and covalent bonding forces[1]. And the field of coordination polymers has witnessed tremendous growth over the last decade[2]. Many coordination polymeric networks have been shown to posses intere…     

Physical and chemical properties of a durably efficacious ammonium bicarbonate as a fertilizer and its yield-increasing mechanism

A new fertilizer of cocrystal type,known as durably efficacious ammonium bicarbonate (DEAB),has been developed by adding a certain amount of dicyandiamide (DCD) as an ammonia-stabilizing agent to ammonium bearbenate(AB)during the process of its production.As compared with AB,DEAB was found to have a reduction of direct volatilization loss by 53%,a fertilizer availability period prolonged from 35-45 to 90-110 d,and an increase in the rate of nitrogen in fertilizer being utilized by 5.9%-10.2%,and a saving of the amount of fertilizer to be ap-phed by 20%-30% for the same level of yield,or an increase of the crop yield by over 10% for the same level of ni-tregen fertilization;in addition,it was found to show usually a function of promoting the crop to early mature.It can be apptied as basal dressing all in one time to soil and thus also used as a labour-saving and crop yield-increasing fertil-izer for is non-mtertillage,plastics film covering and water-saving agriculture     

Electrochemical Determination of Ascorbic Acid at γ-MnO<Subscript>2</Subscript> Modified Carbon Black Microelectrodes

A carbon black microelectrode modified by -MnO₂ has been prepared. The electrocatalytical oxidation of ascorbic acid (AA) at this microelectrode was investigated. The 2nd-order linear scan voltammograms of AA are recorded from –0.5 to 0.5V (vs. SCE). The relationship between the oxidation peak current of AA and its concentration in the range of 1.0×10^–64.0×10^–3molL^–1 is linear. The detection limit (3) was found to be 6.0×10^–7molL^–1. Also, the determination of AA in samples is evaluated, and the results are satisfactory.     

缬沙坦类似物合成中间产物的捕获(Ⅱ)

In this article we mainly discuss the effect of anion of Lewis acid on the structure of the intermediate in synthesis of valsartan analogue. The crystal belongs to monoclinic system with space group P2₁/c, and a=1.099 9(3) nm, b=1.913 4(5) nm, c=0.977 8(3) nm, β=104.806(4)°, V=1.989 5(9) nm³, D_c=1.708 g·cm^-3, Z=18. CCDC: 629931.     

5-氨基-1,10-菲咯啉：可异构化杂环螯合荧光载体作为比例计量型锌离子荧光探针的一种原型

5-amino-l,10-phenanthroline （5-AP）, as a tautomeric heterocyclic aromatic chelating fluorophore （THACF）, can sense Zn^2＋ selectively by shifting emission from 495 to 564 nm upon Zn^2＋ addition in ethanol. The ratiometric fluorescent sensing behavior has been correlated to the tautomerization of 5-AP affected by solvents and metal chelation. The strategy using THACF as ratiometric fluorescent sensor for Zn^2＋ not only simplifies the synthetic procedure but also gives a promising alternative for Zn^2＋ ratiometric fluorescent sensor design.     

含氟丙烯酸酯聚合物乳胶膜表面性质

采用XPS和界面张力仪分别测定了含氟丙烯酸酯聚合物乳胶膜表面的组成及水在其表面的动态接触角, 并用状态逼近方程模型计算了含氟聚合物乳胶膜的表面张力, 考察了温度对乳胶膜润湿性的影响. 结果表明, 含氟聚合物乳胶膜表层较深处的F 1s信号强度比近表面要弱, 乳胶膜表面张力随表面氟原子浓度增加在一定程度上呈现线性下降；含氟侧链(Rf)较长(碳原子数n＞6)的含氟聚合物, 其表面张力随Rf单元含量增加而下降的趋势显著高于Rf较短(n≤6)的含氟聚合物, 而水在含氟聚合物乳胶膜表面上的后退接触角θr随n增大出现急剧上升, n≥10 时, θr值几乎恒定不再随n增大而改变. 此外, 参与共聚的非氟丙烯酸酯酯基碳链较短时, 水在共聚物乳胶膜表面的θr随氟单元含量增加而增加的趋势更显著；温度超过40 ℃后, 水对聚合物乳胶膜的润湿性随温度上升略有改善.     

一步法直接合成有机季铵功能修饰的介孔分子筛SBA-15

以P123 嵌段共聚物为模板剂, 3-三甲基丙基氯化铵三甲氧基硅烷(TMAPS)为修饰剂, 酸性条件下一步法直接合成了有机季铵基团功能修饰的SBA-15, 并通过XRD、TEM、N2吸附-脱附、Raman 光谱等对功能化样品的结构和性质进行了表征, 对一步法合成TMAPS 修饰的SBA-15 的可能反应机理进行了探讨. 修饰后的SBA-15 仍然保持了二维六方特征介孔结构, 随着TMAPS负载量的增大, SBA-15 孔道有序度下降, 孔径、孔容和比表面积也随之下降. 有机季铵基团在SBA-15 孔道表面均匀分散, 可与HAuCl4通过快速离子交换制备Au 颗粒高度分散的Au-SBA-15.     

单取代二茂铁西佛碱型液晶化合物的合成及介晶性研究

报道了两个系列二茂铁衍生物，FcC_6H_4N＝CHC_6H_4OC_nH_(2n+1)（系列I） 和FcC_6H_4N＝CHC_6H_4O_2CC_6H_4OC_nH_(2n+1)（系列II）（Fc:ferrocenyl；n = 2，4，6，8，10，12，14，16），并通过DSC和热台偏光显微镜对其介晶性进行 了研究。系列I不具有介晶性，系列II呈较窄的液晶温度范围。其结果显示分子的 刚性部分长度对介晶性有重要影响。