La1-xPrxMnO3(x=0.1,0.2)薄膜庞磁电阻性质的研究

一种新的庞磁电阻氧化物薄膜La1-xPrxMnO3(x=0.1,0.2)薄膜用脉冲激光沉积(PLD)方法生长在(100)SrTiO3单晶基底上.XRD结果显示薄膜具有很好的外延单晶取向.电输运和磁性质的研究表明薄膜具有显著的庞磁电阻效应(CMR)效应,其中磁电阻比率达95%(在5T的磁场下).X射线光电子能谱(XPS)的结果表明薄膜体系中Pr离子的价态为+4价,因此该薄膜很可能是电子掺杂的庞磁电阻体系.     

WAXS studies on block copolymers of ethylene and propylene

Wide-angle X-ray scattering from presumed block copolymers of polypropylene (PP) and ethylene-propylene copolymer (EPR), i.e., PP-EPR and PP-EPR-PP, synthesized by sequential polymerization with δ-TiCl₃? Et₂AlCl, was examined and compared with WAXS of mechanical blends and chain-transfer mixtures of PP and EPR with comparable compositions. The peak at 2θ = 20° for both the copolymers and the mixtures was attributed to the γ modification of PP in EPR. A strong variation in the ratio of diffraction intensities I₀₄₀/I₁₁₀ of PP in block copolymers and mixtures was explained in terms of crystallite growth in different directions. Analysis of the patterns and calculation of crystallinity, crystallite size, and lattice parameters led to the conclusion that block structure existed in the prepared copolymers.     

关于Lipschitz域上反射Brown运动的游程

本文具体刻画有界 Lipschitz 域上的反射 Brown 运动跨过某给定时刻 t 的离开 Martin 边界的游程．在此基础上,给出 Lipschitz 域上的反射 Brown 运动的边界过程的 L(?)vy 系统．     

�۱��ƫ��������ˮ��������ǿ�����������о�

By using Fluent software with the Eulerian multiphase model and Non-equilibrium boiling model, the subcooled flow boiling heat transfers was numerically simulated in the plain upward vertical tubes under the condition of one-side heating. The influences of the different mass flux, inlet temperatures and heat flux on the heat transfer coefficient, the void fraction and heat transfer deterioration were investigated.     

Ethylene–propylene copolymerization with bis(β‐enaminoketonato) titanium complexes activated with modified methylaluminoxane

Ethylene–propylene copolymerization, using [(Ph)NC(R₂)CHC(R₁)O]₂TiCl₂ (R₁ = CF₃, Ph, or t‐Bu; R₂ = CH₃ or CF₃) titanium complexes activated with modified methylaluminoxane as a cocatalyst, was investigated. High‐molecular‐weight ethylene–propylene copolymers with relatively narrow molecular weight distributions and a broad range of chemical compositions were obtained. Substituents R₁ and R₂ influenced the copolymerization behavior, including the copolymerization activity, methylene sequence distribution, molecular weight, and polydispersity. With small steric hindrance at R₁ and R₂, one complex (R₁ = CF₃; R₂ = CH₃) displayed high catalytic activity and produced copolymers with high propylene incorporation but low molecular weight. The microstructures of the copolymers were analyzed with ¹³C NMR to determine the methylene sequence distribution and number‐average sequence lengths of uninterrupted methylene carbons. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5846–5854, 2006     

Highly soluble and optically transparent poly (ether imide)s based on 2,6‐ or 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and aromatic bis(ether amine)s bearing trifluoromethyl groups

Two series of novel fluorinated poly(ether imide)s (coded IIIA and IIIB ) were prepared from 2,6‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride and 2,7‐bis(3,4‐dicarboxyphenoxy)naphthalene dianhydride, respectively, with various trifluoromethyl‐substituted aromatic bis(ether amine)s by a standard two‐step process with thermal or chemical imidization of the poly(amic acid) precursors. These fluorinated poly(ether imide)s showed good solubility in many organic solvents and could be solution‐cast into transparent, flexible, and tough films. These films were nearly colorless, with an ultraviolet–visible absorption edge of 364–386 nm. They also showed good thermal stability with glass‐transition temperatures of 221–298 °C, 10% weight loss temperatures in excess of 489 °C, and char yields at 800 °C in nitrogen greater than 50%. The 2,7‐substituted IIIB series also showed better solubility and higher transparency than the isomeric 2,6‐substituted IIIA series. In comparison with nonfluorinated poly (ether imide)s, the fluorinated IIIA and IIIB series showed better solubility, higher transparency, and lower dielectric constants and water absorption. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 5909–5922, 2006     

交换自同构群的若干结果

借助于环论的方法研究了具有交换自同构群的有限群,提出了一种新的自同构构作技术,并用之证明了这样的非交换有限群具有非循环的中心子群,以及其每个极大子群的中心子群也都非循环.     

添加助剂的钙钛矿型氧化物NdMO_3上的甲烷氧化偶联——Ⅱ.15% Li_2O/NdMO_3(M=Cr、Mn、Fe、Co、Ni)上的OCM反应研究

在添加了15%Li_2O的NdMO_3(M=Cr、Mn、Fe、Co、Ni)上进行了甲烷氧化偶联(OCM)反应研究.通过改变反应气中CH_4:O_2浓度比,在氧化态和“脱氧态”催化剂上的CH_4脉冲反应,探讨了表面吸附氧和晶格氧在OCM反应中的作用以及NdMO_3中不同金属离子(M)对OCM反应活性的影响等.     

Finite-element calculation of the influence of interdiffusion on eigenstates in a GaAs/Al x Ga1-x As single-quantum-well structure

The influence of interdiffusion on eigenstates in an interdiffusion-induced GaAs/Al_xGa_1-xAs single-quantum-well structure is analysed numerically by the finite element method. In this approach, the confinement potential profile of the interdiffused quantum well structure is nonlinear and is modelled by an error function and, in particular, the nature of the effective mass of an electron is considered. The results show that the number of eigenstates and energy levels varies with the extent of the interdiffusion. Numerical results for the quasi-bound states in the quantum well structure with an applied electric field are also presented.     

α－蒎烯／苯乙烯共聚产物微臭氧化－薄层层析分离研究

建立了一种α－蒎烯／苯乙烯共用产物分离分析微臭氧化－薄层层析法．通过标准样品的分离和ＩＲ、ＮＭＲ表征以及共聚体组分的测定，表明这种方法对α－蒎烯／苯乙烯均聚体混合物和共聚产物中均、共聚体的分离完全，样品回收率很高，解决了α－蒎烯／苯乙烯均、共聚体无法分离分析的难题．