Diffusion Structural Analysis Study of Titania Films Deposited by Sol-Gel Technique on Silica Glass

The diffusion structural analysis (DSA) was used to characterize microstructure changes of hydrous titania gel films under in situ conditions of heating. TG and DTA were used in order to elucidate the processes controlling the formation of anatase film during heating of hydrous titania gel film. The annealing of porosity and near surface structure defects of the dehydrated titania films was indicated by DSA in the temperature range 255–700°C as the decrease of radon release rate. It was demonstrated that the annealing was enhanced on heating in oxygen in comparison with heating in argon. The DSA experimental results were compared with model curves describing the radon diffusion mobility and the annealing of radon diffusion paths.     

Spectroscopic Study of Proton-Transfer Interaction between Methylbis(1-silatranylmethyl)amine and Phenols

Acid-base interaction of phenol and 4-nitrophenol with methylbis(1-silatranylmethyl)amine in acetonitrile is completely shifted toward formation of solvation-separated ion pairs. The unusually high electron-donor power of the exocyclic nitrogen atom in the amine is due to the presence of two silatranylmethyl groups exhibiting a super-electron-donor inductive effect.     

Arsenic determination in marine sediment using ultrasound for sample preparation.

This work deals with As determination in marine sediment using ultrasound for sample preparation. It is shown that As can be quantitatively extracted from marine sediment using 20% (v/v) HCl and sonication. The slurry is centrifuged and the analyte is determined in the supernatant by hydride generation atomic absorption spectrometry (HG AAS). A flow injection (FI) system is employed for hydride generation, with 0.5% (m/v) NaBH(4) used as reducdant and a 20% (v/v) HCl used as sample carrier. The limit of quantification is 1.6 microg g(-1) of As, which is based on 800 microl of sample solution and 0.200 g of sample mass in a volume of 50 mL. Certified and non certified marine sediment samples were analyzed; the results were in accordance with the certified or reference values. Speciation analysis by HPLC-ICP-MS showed that As(V) is the only detectable As species present in the supernatant of the centrifuged sample.     

Fully developed mixed convection in horizontal and inclined tubes with uniform heat flux using nanofluid

Fully developed laminar mixed convection of a nanofluid consists of water and Al₂O₃ in horizontal and inclined tubes has been studied numerically. Three-dimensional elliptic governing equations have been solved to investigate the flow behaviors over a wide range of the Grashof and Reynolds numbers. Comparisons with previously published experimental and numerical works on mixed convection in a horizontal and inclined tube are performed and good agreements between the results are observed. Effects of nanoparticles concentration and tube inclinations on the hydrodynamics and thermal parameters are presented and discussed. It is shown that the nanoparticles concentration does not have significant effects on the hydrodynamics parameters. Heat transfer coefficient increases by 15% at 4 Vol.% Al₂O₃. Skin friction coefficient continually increases with the tube inclination, but the heat transfer coefficient reaches a maximum at the inclination angle of 45°.     

Buckling of a stiff thin film on a compliant substrate in large deformation

A finite-deformation theory is developed to study the mechanics of thin buckled films on compliant substrates. Perturbation analysis is performed for this highly nonlinear system to obtain the analytical solution. The results agree well with experiments and finite element analysis in wavelength and amplitude. In particular, it is found that the wavelength depends on the strain. Based on the accurate wavelength and amplitude, the membrane and peak strains in thin films, and stretchability and compressibility of the system are also obtained analytically.     

Application of the wavelet transform for a channel flow in a mixed convection phenomenon

The aim of this paper is to investigate laminar-turbulent transition in a mixed convection phenomenon occurring in a horizontal rectangular duct. Indeed, laminar-turbulent transition is well known in the case of forced convection but the presence of secondary flow induced by natural convection on this transition is not well highlighted. In this study, we will not be concerned by determining a critical threshold value of a Reynolds number of transition but only to estimate the degree of turbulence in the transition regime, i.e. weak turbulence in the case of a mixed convection phenomenon. This is possible thanks to the application of the wavelet transform. The calculation of the Hölder exponent, associated with the maximum value of the singularity spectrum for various experimental conditions allows the degree of turbulence to be measured. The variation of the Hölder exponent versus heat flux and Reynolds number enables us to show that there are two ways to go towards turbulence: thermal by increasing heat flux and hydrodynamic by increasing fluid velocity.     

NMR investigations of hexamethyldisilane confined in controlled pore glasses: Pore size distribution and molecular dynamics studies

In this work, the melting-point depression and molecular dynamics of hexamethyldisilane confined within five controlled pore glasses, with mean diameters ranging from 7.9 to 23.9 nm, are studied by high-field (9.4 T) nuclear magnetic resonance (NMR), and the results are discussed with reference to the bulk substance. The melting-point depression in pores with radiusR follows the simplified Gibbs-Thompson equation ΔT=k _p/(R−s) with ak _p value of 74 K · nm and ans value of 1 nm. To our knowledge, this is the first time thek _p value of hexamethyldisilane is reported. Proton spin-lattice relaxation times (T ₁), spin-spin relaxation times (T ₂), and diffusivities (D) are reported as a function of temperature. The confinement in the pores gives rise to substantial changes in the molecular dynamics and the phase behavior. The line-shape measurements reveal a two-phase system assigned to a relatively mobile component at the pore walls and a crystalline solid at the center of the pores. However, theT ₂ measurements show that the mobile phase also embraces a minor component attributed to nonfrozen liquid in pockets or micropores. The diffusivity of the major narrow-line component is approximately three orders of magnitude larger than that in the plastic bulk phase, reflecting fast diffusion of mobile molecules. Below the melting region,T ₁ of the narrow line is significantly shorter thanT ₁ of the broad line, suggesting that the molecular reorientation is more hindered close to the surface than at the center of the pore.     

Univariate Ore Polynomial Rings in Computer Algebra

We present some algorithms related to rings of Ore polynomials (or, briefly, Ore rings) and describe a computer algebra library for basic operations in an arbitrary Ore ring. The library can be used as a basis for various algorithms in Ore rings, in particular, in differential, shift, and q-shift rings. __________ Translated from Sovremennaya Matematika i Ee Prilozheniya (Contemporary Mathematics and Its Applications), Vol. 13, Algebra, 2004.     

Anisotropic and isotropic phases of polymer melts

The melting mechanism of polymer crystals is proposed. It is assumed that the melting happens due to forming supervacancies. This mechanism leads the appearance of anisotropic phase of a melt. It is shown that two phases—anisotropic and isotropic—can exist in polymer melts.