Preconcentration and separation of copper(II), cadmium(II) and chromium(III) in a syringe filled with 3-aminopropyltriethoxysilane supported on silica gel

In this study, a syringe was filled with silica gel loaded with 3-aminopropyltriethoxysilane, for the separation and preconcentration of copper, cadmium and chromium prior to their determination by graphite furnace atomic absorption spectrometry (GFAAS) in seawater. For this purpose, a syringe was filled with 0.5 g of modified silica gel and the sample solution was drawn into the syringe and ejected back again. The analyte elements were quantitatively retained at pH 5. Then, the elements sorbed by the silica gel were eluted with 2.0 M of HCl and determined by GFAAS. At optimum conditions, the recovery of Cu, Cd and Cr were 96-98%. Detection limits (3delta) were 6.6, 7.5 and 6.0 micro g L(-1) for Cu, Cd and Cr, respectively. The elements could be concentrated by drawing and discharging several portions of sample successively but eluting only once. Cu, Cd and Cr added to a seawater sample were quantitatively recovered (>95%) in the range of the 95% confidence level. The method proposed in this paper was compared with a column technique. Optimum experimental conditions, reproducibility, precision and recoveries of both techniques are the same, but the syringe technique is much faster, easier and more practical than the column technique. It is a portable system and allows one to make the sorption process in the source of sample. In addition, the risk of contamination is less than in the column technique.     

Borate adsorption at Pt(111) in acidic medium

The adsorption/desorption process of borate was studied at Pt(111) in acidic solution by cyclic voltammetry. A so-called butterfly wave in the cyclic voltammogram of Pt(111) in HClO₄ shifted to negative direction upon the addition of boric acid with the disappearance of its sharp spikes. The shift in potential was found to be −57 mV with a tenfold increase of boric acid concentration. This illustrates that this anomalous wave is due to borate adsorption/desorption by a one-electron transfer process. The borate adsorption/desorption wave was observed to shift by −63 mV/pH. At pH>3, the anomalous wave splits forming two separate waves, depending on the pH and the scan rate. The appearance of two waves is assigned to the change in the adsorption mode of borate or the participation of OH in the adsorption process.     

Coordination of solvent molecules to VO(acac)<Subscript>2</Subscript> complexes in solution studied by hyperfine sublevel correlation spectroscopy and pulsed electron nuclear double resonance

Interactions and binding sites of the solvent molecules chloroform and ethanol to bis(acetylacetonate)oxovanadium(IV) (VO(acac)₂) complexes in (frozen) solutions have been investigated by pulsed electron nuclear double resonance, sum peak electron spin echo envelope modulation and hyperfine sublevel correlation spectroscopy. The experimental proton hyperfine coupling data of coordinating solvent molecules have been interpreted using quantum chemical calculations (density functional theory). Experimental and computed hyperfine couplings indicate that ethanol coordinates to vanadium in the equatorial plane of VO(acac)₂ and chloroform interacts via hydrogen bonding to oxygens of the acac ligands.     

Harnack Inequalities for Functional SDEs Driven by Subordinate Brownian Motions

Potential Analysis - Using coupling by change of measure and an approximation technique, Wang’s Harnack inequalities are established for a class of functional SDEs driven by subordinate...     

求解二维Fisher-KPP方程的一类保正保界差分格式及其Richardson外推法

本文研究求解二维Fisher-Kolmogorov-Petrovsky-Piscounov (Fisher-KPP)方程的一类保正保界差分格式.运用能量分析法证明了当网格比满足$R_{x}+R_{y}+[b\tau (p-1)]/2\leq\frac{1}{2}$时差分解具有一系列数学性质,包括保正性、保界性和单调性,且在无穷范数意义下有$O (\tau+h_{x}^{2}+h_{y}^{2})$的收敛阶.然后通过发展Richardson外推法得到收敛阶为$O (\tau^{2}+h_{x}^{4}+h_{y}^{4})$的外推解.最后数值实验表明数值结果与理论结果相吻合.值得提及的是在运用本文构造的Richardson外推法时对时空网格比没有增加更严格的条件.     

基于简化的应变梯度理论下Kirchhoff板模型边值问题的提法及其应用北大核心CSCD

考虑应变梯度和速度梯度的影响,建立薄板控制微分方程及给出其边值问题的提法,修正了前人给出的薄板角点条件.采用Levy法,给出受分布力作用下简支板的挠度及自由振动频率的解析解.通过与文献中分子动力学数据对比,验证了该文模型的有效性并提出校核材料参数的一种方法.研究结果表明,增大弹性地基和应变梯度参数可以有效提高板的等效刚度,而速度梯度参数则相反.该文提出的板的边值问题为研究薄板在复杂支撑边界及外荷载等条件提供了理论依据.同时,有望为其有限元法、有限差分法和基于能量原理的Galerkin法等数值方法提供理论依据.     

空间机器人组装超大型结构的动力学分析北大核心CSCD

超大型航天结构具有超大柔性、超低固有频率的特点,空间机器人在轨组装时应尽可能避免激起超大型结构的柔性振动.空间机器人组装超大型结构模块的过程分成抓捕阶段、位姿调整与稳定阶段、安装阶段和爬行阶段.通过对安装阶段的动力学与控制研究,提出共线安装的轨迹规划方法,有效避免了柔性结构振动.首先,采用自然坐标法和绝对节点坐标法建立主结构-空间机器人-待组装结构的在轨组装系统动力学模型.然后,将共线安装的要求转化为空间机器人的轨迹规划约束,要求空间机器人质心到主结构/待组装结构的距离保持不变,实现共线安装的轨迹规划.数值仿真表明:提出的组装方法在组装过程中可有效避免超大型结构的横向运动,降低夹持力矩.最后,分析了系统参数对组装过程动力学响应的影响,为超大型航天器的在轨组装提供了参考.     

Orientation control of perovskite thin films on glass substrates by the application of a seed layer prepared from oxide nanosheets

Orientation control of perovskite compounds was investigated by the application of a seed layer prepared from oxide nanosheets. An aqueous suspension of oxide nanosheets was prepared by the exfoliation of a layered compound of KCa₂Nb₃O₁₀ oxide grains. A seed layer composed of (TBA)Ca₂Nb₃O₁₀ nanosheets (TBA = tetrabutylammonium) was formed on a glass substrate by simply dip coating it in the suspension. Two kinds of perovskite compounds, LaNiO₃ (LNO) and Pb(Zr,Ti)O₃ (PZT) with a preferred orientation of (00l) were successfully grown on this seeded glass substrate. In this study, the relation between lattice mismatch and electrical properties is investigated. A large, oriented PZT film with a size of 5 ×4 cm shows an improved P-E hysteresis behavior by use of this orientation control.     

An approach for solving fuzzy multi-criteria decision problem under linguistic information

Fuzzy Optimization and Decision Making - Linguistic information processing exists in multi-criteria decision making, and linguistic truth-valued lattice implication algebra (LTV-LIA) has definite...     

Safety Stock Determination with Serially Correlated Demand in a Periodic-Review Inventory System

We consider a periodic-review inventory replenishment model with an order-up-to-R operating doctrine for the case of deterministic lead times and a covariance-stationary stochastic demand process. A method is derived for setting the inventory safety stock to achieve an exact desired stockout probability when the autocovariance function for Gaussian demand is known. Because the method does not require that parametric time-series models be fit to the data, it is easily implemented in practice. Moreover, the method is shown to be asymptotically valid when the autocovariance function of demand is estimated from historical data. The effects on the stockout rate of various levels of autocorrelated demand are demonstrated for situations in which autocorrelation in demand goes undetected or is ignored by the inventory manager. Similarly, the changes to the required level of safety stock are demonstrated for varying levels of autocorrelation.