Spin gapless semiconductor like Ti2MnAl film as a new candidate for spintronics application

A novel Heusler ferrimagnet Ti₂MnAl film has been grown on Si(001) substrate using magnetron sputtering. Characteristics of its magnetic and transport properties reveal the spin‐gapless‐semiconductor (SGS) nature of the stoichiometric Ti₂MnAl, in agreement with theoretical prediction. The as‐grown SGS‐like Ti₂MnAl film demonstrated high Curie temperature, nearly compensated ferrimagnetic properties with small coercivity and low magnetization. It also showed semiconductor‐like behavior at room temperature allowing good compatibility with commercial Si‐based semiconductor. In this regards, Ti₂MnAl film is a potential candidate material for spintronics application, especially for the minimization of energy consumption of device. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

N-乙基吡咯S1态超快动力学：飞秒时间分辨光电子成像研究

N-乙基吡咯是吡咯分子的一个乙基取代衍生物,它的激发态衰变动力学目前为止很少被研究. 本文利用飞秒时间分辨光电子成像的实验方法研究N-乙基吡咯分子S₁态的衰变动力学. 实验采用241.9和237.7 nm的泵浦激发波长. 在241.9 nm激发下,得到5.0±0.7 ps,66.4±15.6 ps和1.3±0.1 ns三个寿命常数. 在237.7 nm激发下,得到2.1±0.1 ps和13.1±1.2 ps两个寿命常数. 所有寿命常数都归属为S₁态的振动态. 本文并对不同S₁振动态的弛豫机理进行了讨论.     

光纤微位移法测量固体线膨胀系数

本文绘出了一种金属固体线膨胀系数的测量方法,即采用光纤位移传感器的方法（光纤微位移法）来测量固体的线膨胀系数．测量了黄铜的线胀系数,分别用逐差法和线性回归法处理了实验数据,并与标准值进行了比较．     

热传导方程的一类无网格方法

构造求解热传导方程的一类无网格方法,只要选择好每个节点的适当的邻点集合,便可利用节点信息顺利进行计算.作为特殊情形,也可在各种结构或非结构网格上进行计算.在矩形或均匀平行四边形网格上进行计算时具有二阶精度,当在任意的不规则四边形或三角形网格上计算时仍然是守恒的和相容的,且至少具有一阶精度.作为数值试验,将该方法用于在不规则四边形网格上及四边形与三角形混合网格上求解二维非线性抛物型方程,并在不规则四边形网格上求解二维三温辐射热传导方程,均获得了较为理想的数值结果.     

Room-Temperature Magnetism Realized by Doping Fe into Ferroelectric LiTaO3

We synthesize LiTal-x FexO3-σ （LTFO） remain single phase up to x = 0.09 ceramics by the conventional solid-state reaction method. The samples The magnetic measurements show that the doping of Fe successfully realizes ferromagnetism of LTFO at room temperature. The dielectric measurements indicate that LTFO is ferroelectric, similarly to LiTaO3 （LTO）, but its ferroelectric Curie temperature seems to decrease with the increasing Fe content. By means of doping Fe ions into LTO, the coexistence of spontaneous electric polarization and spontaneous magnetic moment is realized at room temperature.     

Prospective study on observations of γ-ray sources in the Galaxy using the HADAR experiment

The High Altitude Detection of Astronomical Radiation (HADAR) experiment is a refracting terrestrial telescope array based on the atmospheric Cherenkov imaging technique. It focuses the Cherenkov light emitted by extensive air showers through a large aperture water-lens system for observing very-high-energy γ-rays and cosmic rays. With the advantages of a large field-of-view (FOV) and low energy threshold, the HADAR experiment operates in a large-scale sky scanning mode to observe galactic sources. This study presents the prospects of using the HADAR experiment for the sky survey of TeV γ-ray sources from TeVCat and provids a one-year survey of statistical significance. Results from the simulation show that a total of 23 galactic point sources, including five supernova remnant sources and superbubbles, four pulsar wind nebula sources, and 14 unidentified sources, were detected in the HADAR FOV with a significance greater than 5 standard deviations (σ). The statistical significance for the Crab Nebula during one year of operation reached 346.0 σ and the one-year integral sensitivity of HADAR above 1 TeV was ~1.3%–2.4% of the flux from the Crab Nebula.     

SiN团簇光电子能谱的指认

应用含时密度泛函理论研究了SiN团簇低能激发态的性质.将计算结果与前人已有的计算结果进行了比较，此外还根据计算得到的低能激发能对SiN^-阴离子的光电子能谱进行了理论指认.研究表明，SiN^-阴离子的基态为¹Σ态，而光电子能谱上的X峰和A峰分别对应于¹Σ→²Σ和¹Σ→²Π的跃迁.研究结果还表明，用含时密度泛函的方法来处理激发态的问题是成功的. 关键词： 团簇 光电子能谱 基态 激发态     

熔石英后表面坑点型划痕对光场调制的近场模拟

建立了坑点型划痕的旋转抛物面模型, 用三维时域有限差分方法研究了熔石英后表面坑点型划痕随深度、 宽度、 间距以及酸蚀量变化对波长λ =355 nm入射激光的调制.研究表明, 这类划痕调制最强区位于相邻两坑点的连接区, 且越靠近表面调制越强.当其宽深比为2.0---3.5、 坑点间距约为坑点宽度的1/2时, 可获得最大光场调制, 最大光强增强因子(LIEF)为11.53; 当坑点间距大于坑点宽度时, 其调制大为减弱, 相当于单坑的场调制.对宽为60δ (δ =λ/12), 深和间距均为30δ的坑点型划痕进行刻蚀模拟, 刻蚀过程中最大LIEF为11.0, 当间距小于300 nm时, 相邻坑点由于衍射形成场贯通.     

Two localized CO2 laser treatment methods for mitigation of UV damage growth in fused silica

Two methods：high-power,short-time,single-shot irradiation（Method A） and low-power,long-time,multi-shot irradiation（Method B） are investigated to mitigate the UV damage growth in fused silica by using a 10.6-μm CO2 laser.To verify the mitigation effect of the two methods,the laser induced damage thresholds（LIDTs） of the mitigated sites are tested with a 355-nm,6.4-ns Nd：YAG laser,and the light modulation of the mitigation sites are tested with a 351-nm continuous Nd：YLF laser.The mitigated damaged sites treated with the two methods have almost the same LIDTs,which can recover to the level of pristine material.Compared with Method A,Method B produces mitigated sites with low crater depth and weak light modulation.In addition,there is no raised rim or re-deposited debris formed around the crater edge for Method B.Theoretical calculation is utilized to evaluate the central temperature of the CO2 laser beam irradiated zone and the radius of the crater.It is indicated that the calculated results are consistent with the experimental results.     

快速匹配算法在药筒模块检测中的应用

为了能够快速、准确判断药筒模块是否合格,实现检测的自动化,针对药筒模块中可燃性紧塞盖图像的特点和检测要求,在研究经典相关系数匹配算法基础上,采用了一种快速图像匹配算法,即通过减少相关系数计算量和模板搜索范围,在保证匹配准确度的前提下来提高图像匹配速度。实验和现场测试表明,使用该方法,匹配速度提高了近67%,实现了图像的快速匹配,软件误判率1%,满足实际生产要求。