Repetition rate multipliers for efficient implementation of multiphoton and pump-probe fluorescence microscopy

With the advances in pulsed laser systems, microscopic imaging techniques such as multiphoton and pump-probe fluorescence microscopy have developed into effective tools for investigating intensity and time-resolved phenomena inside biological systems. However, pulsed lasers used in these techniques usually are commercial systems with repetition frequencies of around 80 MHz. While these systems have proven to be adequate for multiphoton and pump-probe microscopic imaging applications, the temporal separation of the laser pulse train (around 12.5 ns) is long compared to the fluorescence lifetimes of many common fluorescence species. In this work, we present the designs of repetition rate multipliers based on passive optical components that can be used to increase the efficiency in multiphoton and pump-probe fluorescence microscopy. Depending on the lifetime of fluorescence molecules under investigation, the passive repetition rate multiplier can increase the duty cycle of multiphoton or pump-probe microscopy up to fourfold.     

C-V法提取SiC隐埋沟道MOSFET沟道载流子浓度

本文对用C-V法提取SiC隐埋沟道MOSFET沟道载流子浓度的方法进行了理论和实验分析. pn结的存在所造成的埋沟MOS结构C-V曲线的畸变为沟道载流子浓度的提取带来一些问题. SiC/SiO₂界面上界面态的存在也会使提取出的数值与实际数值产生偏差. 本文首先从理论上分别分析了沟道深度和界面态对沟道载流子浓度提取结果的影响，然后对两种沟道深度的埋沟MOS结构C-V曲线进行了测试，提取出了沟道掺杂浓度. 在测试中，采用不同的扫描速率，分析了界面态对提取结果的影响. 理论分析结果和实验测 关键词： C-V法 SiC 隐埋沟道MOSFET 沟道载流子浓度     

Dispersion Compensation in Externally Modulated Transmission System Using Chirped Fiber Grating

We present an externally modulated NTSC AM-VSB erbium-doped fiber amplifier (EDFA)-repeated system in the 1550 nm region which uses a chirped fiber grating (CFG) as a dispersion compensation device. In contrast to the conventional externally modulated fiber optical CATV systems, either with or without dispersion compensation fiber (DCF), good performances of carrier-to-noise ratio (CNR) ≥50 dB, composite second order (CSO) ≥74 dB, and composite triple beat (CTB) ≥65 dB were achieved for the full channel band after a 100-km single-mode fiber (SMF) transmission.     

Synthesis,and Antimycobacterial and Cytotoxic Evaluation of Certain Fluoroquinolone Derivatives

Certain 1‐ethyl‐ and 1‐aryl‐6‐fluoro‐1,4‐dihydroquinol‐4‐one derivatives were synthesized and evaluated for antimycobacterial and cytotoxic activities. Preliminary results indicated that, for 1‐aryl‐6‐fluoroquinolones, both 7‐(piperazin‐1‐yl)‐ and 7‐(4‐methylpiperazin‐1‐yl) derivatives, 9b and 11a , are able to completely inhibit the growth of M. tuberculosis at a concentration of 6.25 μg/ml, while the 7‐[4‐(2‐oxo‐2‐phenylethyl)piperazin‐1‐yl] derivative 13 exhibits only 31% growth inhibition at the same concentration. For 1‐ethyl‐6‐fluoroquinolones, both 7‐[4‐(2‐oxopropyl)piperazin‐1‐yl]‐ and 7‐[4‐(2‐oxo‐2‐phenylethyl)piperazin‐1‐yl]‐derivatives, 2a and 2b , respectively, show complete inhibition, while their 2‐iminoethyl and substituted phenyl counterparts 3a and 2c are less active. In addition, the 6,8‐difluoro derivative was a more‐favorable inhibitor than its 6‐fluoro counterpart ( 2b vs. 2d ). These results deserve full attention especially because 2a, 2b, 9b , and 11a are non‐cytotoxic at a concentration of 100 μM . Furthermore, compound 9b proved to be a potent anti‐TB agent with selective index (SI)>40 and an EC₉₀ value of 5.75 μg/ml.     

Analysis of nine rhubarb anthraquinones and bianthrones by micellar electrokinetic chromatography using experimental design

An efficient micellar electrokinetic chromatography (MEKC) method has been developed for the analysis of nine anthraquinones and bianthrones in rhubarb. A chemometric approach was used to search for the optimum conditions of separation. Those factors which were found to be significant with a screening design were further optimized with a central composite face-centered (CCF) design. Acetonitrile concentration was found to be the most influential, not only in resolution, but also in analysis time and peak asymmetry. With the optimized conditions: 15 mM sodium tetraborate/15 mM sodium dihydrogenphosphate buffer, 30 mM sodium deoxycholate, pH 8.6, 17 vol.% acetonitrile and 28 kV, nine tested analytes were baseline-separated within 14 min. The method was validated to analyze the rhubarb material. Solid-phase extraction (SPE) was manipulated to remove interfering substances. Five anthraquinones and two glycosidic bianthrones were detected and quantificated. The method should be suitable for determining these major active principles in rhubarb crude drugs.     

Behaviors of the positive temperature coefficient of resistance of poly(styrene‐co‐n‐butylacrylate) filled with Ni‐plated core‐shell polymeric particles

Conductive composite films of poly(styrene‐co‐n‐butylacrylate) copolymers filled with low‐density, Ni‐plated core‐shell polymeric particles were prepared and their behaviors of positive temperature coefficient of resistance (PTCR) were investigated. When the conductive fillers in the composite film were loaded beyond the critical volume, 10 up to 25 vol %, composite films exhibited a unique electrical resistant transition behavior, which the electrical resistance rapidly increased by several orders of magnitude at the critical temperature. The PTCR transition temperature, in general, occurred before the glass transition temperature of polymer matrix. Further increased the conductive filler loading to 30 vol %, the overpacked conduction paths were formed in the entire composite and the PTCR effects became blurred. While the composite film treated with thermal cycle several times from room temperature up to 120 °C, the electrical resistivity increased accompanied with the shift of the PTCR transition to lower temperature. The reason might have been caused by the formed interfacial cracks within the composite film. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 322–329, 2007     

应力对La0.83Sr0.17MnO3薄膜输运性能的影响

采用溶胶-凝胶方法在Si(111)上制备了LSMO(x=0.17)薄膜.研究了块体材料和不同厚度薄膜R -T曲线、红外光谱和X射线衍射.结果表明，LSMO薄膜属于正交晶体结构，薄膜取向与膜厚度 有关，当膜厚度为450nm或680nm时，主要取向〈200〉，而膜厚度为900nm时取向为〈020〉 ：根据离子对相互作用能和谐振子模型，得到了红外吸收与Mn—O—Mn键长和键角关系式，6 00cm^-1附近红外吸收与晶格常数b的变化有关；块体与薄膜的金属—绝缘体转变 温度(T_MI)存在较大差别，薄膜转变温度显著低于块体，并与厚度有一定关系. 认为是LSMO薄膜中的应力诱导了晶格常数变化，引起键角改变及JT效应是转变温度变化的主 要原因. 关键词： 单晶硅 晶格常数 金属—绝缘体转变温度 应力诱导     

纳米晶Y_2SiO_5∶Eu的浓度猝灭研究

报道了分别用溶胶－凝胶法合成的Ｙ２ＳｉＯ５∶Ｅｕ纳米晶和用高温固相法合成常规尺度的Ｙ２ＳｉＯ５∶Ｅｕ材料的光致发光光谱和猝灭浓度的实验研究．结果表明：纳米Ｙ２－ｘＥｕｘＳｉＯ５比常规尺度的Ｙ２－ｘＥｕｘＳｉＯ５有更高的猝灭浓度和更高的发光亮度．理论分析认为这是由于在纳米材料中能量共振传递被阻断和猝灭中心在各个纳米晶内分布的涨落造成的．这个结果为高亮度的Ｙ２ＳｉＯ５∶Ｅｕ纳米材料的实际开发应用展示了广阔前景．