双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

IMPULSIVE CONTROL OF A FISHERY SYSTEM

This paper uses the method of linear approximation for impulsive systems and gets a theorem which guarantees a fishery modei to be asymptotically stable at its equilibrium point and gives the ecological explanation.     

双驱动x射线激光等离子体能谱特性研究

用时间积分空间分辨的平晶千电子伏谱仪测量了钽激光等离子体发射波长范围为045— 075nm的软x射线能谱，精确测量和准确辨认出类镍、类钴和类铁离子的共振线及类镍离子 的内壳层跃迁线-对实验结果处理，获得了辐射线谱的强度-通过谱线比率的诊断推断脉冲激 光时差对等离子体状态的影响，至少也可部分解释激光上能级的粒子数及等离子体的 电离程度- 关键词： 离子谱特性 软x线能谱强度 谱线辨认     

Ab-initio molecular dynamics simulation on nano-system under external pressure

A new constant-pressure molecular dynamics (MD) method is developed to simulate the dynamic behavior and structure transition of finite system under external pressure. In this method, no artificial parameter is introduced and the computation overheads are very small. As an application, a hard-soft transition of single wall carbon nanotube (SWCNT) under external pressure is found, which is in agreement with the experiments.

     

Logarithmic Sobolev trace inequality

A logarithmic Sobolev trace inequality is derived. Bounds on the best constant for this inequality from above and below are investigated using the sharp Sobolev inequality and the sharp logarithmic Sobolev inequality.

     

Influence of support properties on the sound radiated from the vibrations of rectangular plates

The control of the forced vibration response of structures through the optimal tuning of its supports is desirable in many applications. Tuning may enhance the dissipation of vibration energy within the supports, thereby reducing fatigue and structure-borne noise. Two different models were developed to calculate the optimal support stiffness that minimizes the velocity response of homogeneous plates. The first model, based on the wave propagation at the edge, yields a good first cut approximation of the optimal properties. The optimal viscous and viscoelastic support stiffness for minimal reflection at the edge was calculated. Maximum absorption of the incident waves occurs when the viscous support stiffness matches the characteristic mechanical impedances of the plate. The second model, based on the Rayleigh-Ritz method, yields more accurate estimates of the optimal support stiffness required to minimize the forced velocity response of the finite rectangular plate. The optimal support properties calculated from the two different methods were in good agreement. This suggested that the modal response of the plate is strongly influenced by the wave reflections at the edges. Finally, the effects of support properties on the sound radiated from the plate were investigated. The optimal support stiffness that minimizes the radiated sound power was found to be smaller than the value that minimizes the velocity response. The results show that both the velocity response and sound radiation are strongly influenced by dissipation of vibration energy at the edges, and demonstrate that support tuning can yield significant noise and vibration reduction.     

神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Hydrogen indium vacancy complex VInH4 in n-type InP studied by positron-lifetime

Positron-lifetime experiments have been carried out on two undoped n-type liquid encapsulated Czochralski (LEC)-grown InP samples with different stoichiometric compositions in the temperature range 10-300 K. For temperatures below 120 K for P-rich InP and 100 K for In-rich InP, the positron average lifetime began to increase rapidly and then leveled off, which was associated with the charge state change of hydrogen indium vacancy complexes from (V_InH₄)⁺ to (V_InH₄)⁰. This phenomenon was more obvious in P-rich samples that have a higher concentration of V_InH₄. The transformation temperature of approximately 120 K suggests that the complex V_InH₄ is a donor defect and that the ionization energy is about 0.01 eV. The ionization of neutral V_InH₄ accounted for the decrease of the positron average lifetime when the sample was illuminated with a photon energy of 1.32 eV at 70 K. These results provide evidence for hydrogen complex defects in undoped LEC InP.     

Metallization of U3O8via catalytic electrochemical reduction with Li2O in LiCl molten salt

The concept of a novel electrochemical reduction process for the treatment of spent nuclear fuels in Li₂O-LiCl molten salt was proposed and fresh tests using U₃O₈ powder were carried out to elucidate the reaction mechanism and verify the feasibility of the process. Electrolysis of Li₂O and reduction of U₃O₈ powder took place simultaneously at the cathode part of the electrolysis cell via a catalytic EC mechanism and the conversion of U₃O₈ to U metal was more than 99%. This revised version was published online in June 2006 with corrections to the Cover Date.     

Evaluation of closed-vessel microwave digestion method for the determination of trace impurities in polymer-based photoresist by inductively coupled plasma mass spectrometry

A closed microwave digestion method followed by inductively coupled plasma spectrometric (ICP-MS) analysis was evaluated for the determination of trace impurities in photoresist. To optimize the digestion procedure, several digestion parameters such as acid, heating temperature and heating time were evaluated. Besides, the digestion efficiency of used photoresist material and the recovery of analyte elements obtained by the use of gravimetric method and ICP-MS measurement, individually, were also compared to clarify the completeness of digestion. According to our experiments, the gravimetric method was found to be not so relevant to the completeness of digestion, because the remaining sample matrix could cause suppression effect in the subsequent ICP-MS measurement. In view of minimizing blank value and working time, a simple single-step heating program was proposed to mineralize 0.25 ml of photoresist material with 5 ml of nitric acid at 180 °C for 10 min. Based on the comparative study of the analytical results obtained by instrumental neutron activation analysis (INAA) and proposed method, the reliability of proposed method for the determination of trace metallic impurities in photoresist material has been confirmed.