DNA topology on an increase in positive writhing number of DNA: conformation changes in the time course of cis-diamminedichloroplatinum(II)-DNA adducts

We show that the topological significance of the gel mobility of cis-diamminedichloroplatinum(II) (DDP)-closed circular DNA (ccDNA) adducts decreases with reaction time, until a point at which it joins relaxed DNA, and that the mobility of the adducts increases again. There is no relationship between the relative length of the adducts and the gel mobility. Although the significance of the decrease of gel mobility is due to the unwinding of cis-DDP-DNA (or trans-DDP-DNA) adducts, the conformational significance of the subsequent increase in mobility is unclear. To elucidate the conformational significance for unwinding of the adducts, we measured the writhing number (Wk) of the adducts using electron microscopy and analyzed the topological states of cis-DDP (or trans-DDP) adducts based on the White rule, Lk=Wk+Tk. Where, Lk and Tk represent the linking and twisting number in the ring, respectively. From the data, we found that the Wk of cis-DDP-ccDNA adducts in comparison with trans-DDP-ccDNA adducts increases from a negative to a positive number with time. This suggests that cis-DDP plays a role in the change of the topological state of ccDNA. In the abstraction of platinum from the adducts with CN- ion, the differences in both topological states may explain why Pt in trans-DDP is abstracted more easily than in cis-DDP. To explain the abstraction of Pt ion, we also discuss the findings based on the thermodynamic cycle in a intermolecular crosslink model Pt(NH3)2(guanine)2(2+)-->Pt(CN)4(2-) using the Pt parametrized PM3 method.     

Polyoxymethylene prepared by γ-ray-induced polymerization of tetraoxymethylene single crystal

Summary In order to prepare a large single crystal, tetraoxymethylene recrystallized by distilled water adjusted to pH 8 was sealed in an ampoule at a reduced pressure of 1 mm Hg and was crystallized in a furnace with the temperature gradient of 6 °C/cm. The lowering rate of the ampoule was required to be 6 cm/day for preparing the single crystal with 1 cm diameter and to be 3 cm/day for one with 2 cm diameter. The optimum angle at the pointing end of the ampoule, where a seed crystal is formed, was about 40°. The b-axis of the obtained single crystal was parallel to the direction of the crystal growth i. e. the wall of the ampoule. It was polymerized byγ-ray under conditions which prevent the growth of the twin crystal. The obtained polyoxymethylene was porous, because the polymerization yield of 100% could not be attained. However, it was so tough that a specimen for measurements could be cut down by a diamond cutter. Its fiber axis was parallel to the direction of the wall of the ampoule. It did not contain the so-called amorphous regions, although it did contain defects. It was characterized with the extremely high orientation of the polymer chains.

---

Zusammenfassung Zur Pr?parierung gro?er Einkristalle wurde rekristallisiertes Tetraoxymethylen in destilliertem Wasser von p_H 8 in eine Ampulle bei einem reduzierten Quecksilberdruck von 1 mm eingefüllt und in einem Ofen mit einem Temperaturgradienten von 6 °C/cm kristallisiert. Die Abkühlgeschwindigkeit der Ampulle betrug etwa 6 cm/Tag für die Pr?paration eines Einkristalls mit 1 cm ? und 3 cm/Tag für einen solchen mit 2 cm ?. Der optimale Winkel am spitzen Ende der Ampulle, wo der Keimkristall gebildet wird, betrug etwa 40°. Dieb-Achse des Einkristalls war parallel zur Wachstumsrichtung, d. h. zur Wand der Ampulle. Der Kristall wurde durch R?ntgenstrahlen polymerisiert unter Bedingungen, die das Wachsen eines Zwillingskristalls vermeiden. Das erhaltene Polyoxymethylen war por?s, doch konnte eine Polymerisationsausbeute von 100% nicht erhalten werden. Doch war der Einkristall so z?h, da? für Messungen eine Probe mit dem Diamantschneider abgeschnitten werden konnte. Die Faserachse war parallel zur Wandrichtung der Ampulle. Das kristalline Material enthielt keine sogenannten amorphen Bereiche, allerdings Defekte. Es war durch extrem hohe Orientierungen der Polymerketten charakterisiert.

---

---

We are greatly indebted to Dr.Y. Miyake of Mitsui Toatsu Co., Ltd. for providing the tetraoxymethylene. Thanks are to due Dr.M. Nishii of Osaka Laboratories, Japan Association for Radiation Research on Polymer for the radiation polymerization, to Mr.T. Tsukihara for the X-ray measurement, and to Mrs.H. Tanaka for the help with the electron microscopy. We are also grateful to Prof.S. Seki for offering the use of differential scanning calorimeter.     

New hydroxyl protecting groups of a safety-catch type removable by reductive acidolysis.

New hydroxyl protecting groups of a safety-catch type, i.e., 4-methylsulfinylbenzyl-oxycarbonyl (Msz) group for Tyr and 4-methylsulfinylbenzyl (Msob) ether for Thr, have been developed. O-Msz and O-Msob groups are stable under both acidic and basic conditions and can be removed by a one-pot reaction involving reductive acidolysis using tetrachlorosilane-trifluoroacetic acid (TFA)-scavengers. Using these new protecting groups, a 17 residue-peptide, gamma-endorphin, was successfully synthesized by the efficient solid phase method.     

Cationic polymerization of cyclic olefins

The polymerization and the polymerizabilities of indene, benzofuran, and 1,2-dihydronaphthalene are discussed from the point of view of ring strain, ring stabilization, and steric hindrance in the transition state. Monomer reactivities of these olefins were estimated from copolymerization with styrene and from the rate of addition of iodine bromide in acetic acid. Rates and degrees of polymerization are compared with monomer reactivities and resonance energies of indene, 1,2-dihydronaphthalene, and benzofuran as a measure of ring strain and stabilization. It is found that indence is 1.5–2.0 times more reactive than styrene. This high reactivity of indene is attributed to the ring strain in the monomer state and to the low amount of steric hindrance in the transition state of the coplanar five-membered cyclic olefin. 1,2-Dihydronaphthalene is strained and therefore reactive, but propagation to higher molecular weight products is impeded due to the steric hindrance. The reactivity of benzofuran is decreased by conjugative stabilization of C?C double bonds at the reaction site.     

Studies on Fe complexes produced by yeast. IV. Mechanism of Fe transport from an Fe(II)-oligosaccharide complex across the mucosal membrane of the rat intestine

The mechanism of Fe transport across the rat duodenal membrane from an Fe(II)-oligosaccharide complex (designated B1-c) produced in wine by yeast and showing high hematopoietic activity in rats was examined. The Fe uptake from B1-c by brush border membrane (BBM) vesicles isolated from the rat intestine was based mainly on the Fe binding to membrane components which were suggested to be inside the vesicles. Evidence that Fe was transported into the vesicles by a special transport system other than simple diffusion was obtained by observing saturation kinetics under conditions of isotope exchange, and temperature and pH dependence. This Fe uptake was not inhibited by any metal ions tested, including inorganic Fe(II), and the BBM vesicles from the duodenum had a higher Fe uptake than those from the other parts of the small intestine. Furthermore, the BBM vesicles isolated from rats with Fe deficiency showed a significantly increased Fe uptake. The Km value for B1-c uptake was 0.16 mM, lower than the values for FeSO4 and ferrous ascorbate. These results suggest that a special transport system selective for B1-c may be present on the mucosal membrane. B1-c was taken up by the BBM vesicles in the form of Fe-oligosaccharide complex. From the preloaded vesicles, B1-c was released temperature- and pH-dependently.(ABSTRACT TRUNCATED AT 250 WORDS)     

Simultaneous ion-exclusion/cation-exchange chromatography of anions and cations in acid rain waters on a weakly acidic cation-exchange resin by elution with sulfosalicylic acid

A simple, selective, and sensitive method for the simultaneous determination of anions (sulfate, nitrate, and chloride) and cations (sodium, ammonium, potassium, magnesium, and calcium) in acid rain waters was developed using ion-exclusion/ cation-exchange chromatography with conductimetric detection. A weakly acidic cation-exchange resin column (Tosho TSKgel OA-PAK-A) and a sulfosalicylic acid-methanol-water eluent was used. With a mobile phase comprising 1.25 mM sulfosalicylic acid in methanol-water (7.5:92.5) at 1.2 ml/min, simultaneous separation and detection of the above anions and cations was achieved in about 30 min. Linear calibration plots of peak area versus concentration were obtained over the concentration ranges 0-1.0 mM for anions (R=0.9991) and 0-0.5 mM for cations (R=0.9994). Detection limits calculated at S/N=3 ranged from 4.2 to 14.8 ppb for the anions and from 2.4 to 12.1 ppb for the cations. The reproducibility of retention times was 0.14-0.15% relative standard deviation (RSD) for anions and 0.18-0.31% for cations, and reproducibility of chromatographic peak areas was 1.22-1.75% RSD for anions and 1.81-2.10% for cations. The method was applied successfully to the simultaneous determination of anions and cations in aerosols transported from mainland China to central Japan, as determined by a meteorological satellite data analyzer.     

Mononuclear five-coordinate molybdenum(IV) and -(V) monosulfide complexes coordinated with dithiolene ligands: reversible redox of Mo(V)/Mo(IV) and irreversible dimerization of [MoVS]- cores to a dinuclear [MoV2(mu-S)2]2- Core

A mononuclear five-coordinate molybdenum(IV) monosulfide complex, (Et4N)2[MoS(L)2] (L = cyclohexene-1,2-dithiolate) (1), was obtained and characterized by IR, UV-vis spectroscopic methods, and X-ray crystallography. 1 was oxidized by an equivalent ferrocenium cation to give the corresponding mononuclear molybdenum(V) complex, (Et4N)[MoS(L)2] (2), which was stable for a few minutes under a lower concentration than 0.3 mM and then further dimerized to (Et4N)2[Mo(L)2]2(mu-S)2 (3).     

Three new sesquiterpenoid glucosides of Ficus pumila fruit

As the glycosyl constituents of Ficus pumila L. fruits (Moraceae), three new sesquiterpenoid glucosides, pumilasides A, B and C were isolated together with benzyl beta-D-glucopyranoside, (E)-2-methyl-2-butenyl beta-D-glucopyranoside and rutin. Their structures were characterized as (1S,4S,5R,6R,7S,10S)-1,4,6-trihydroxyeudesmane 6-O-beta-D-glucopyranoside, (1S,4S,5S,6R,7R,10S)-1,4-dihydroxymaaliane 1-O-beta-D-glucopyranoside and 10 alpha, 11-dihydroxycadin-4-ene 11-O-beta-D-glucopyranoside by spectral and chemical methods.