Combustion behaviors of isolated n-decane and ethanol droplets in carbon dioxide-rich ambience under microgravity

The burning and sooting behaviors of isolated fuel droplets for ethanol and n-decane are examined in high concentration of the ambient carbon dioxide under microgravity. A quartz fiber with the diameter of 50 μm maintains the droplet in the center of the combustion chamber and the range in the initial droplet diameter is from 0.30 to 0.80 mm. The ambience consists of oxygen, nitrogen and carbon dioxide. The concentration of oxygen is 21% in volume, and that of carbon dioxide is varied from 0% to 60% in volume. Detail measurements of the projected image of the droplet are conducted by using a high speed video camera and the effective droplet diameter squared are calculated from the surface area of the rotating body of the projected object. From evolutions of the droplet diameter squared, the instantaneous burning rates are calculated. Time history of the instantaneous burning rate clearly represents the droplet combustion events, such as the initial thermal expansion, ignition and following combustion. The instantaneous burning rate for n-decane shows an increasing trend during combustion, while that for non-sooting ethanol remains almost constant or shows a decreasing trend. A slight stepwise increase in the instantaneous burning rate is observed for larger n-decane droplets in air, which may be attributed to soot accumulation. However, this behavior of the burning rate disappears in higher concentration of carbon dioxide. Direct observation of the droplet flame indicates suppression of soot production in higher concentration of carbon dioxide and the suppression is enhanced for smaller droplet.     

Evolution of the Kondo effect in a quantum dot probed by shot noise

We measure the current and shot noise in a quantum dot in the Kondo regime to address the nonequilibrium properties of the Kondo effect. By systematically tuning the temperature and gate voltages to define the level positions in the quantum dot, we observe an enhancement of the shot noise as temperature decreases below the Kondo temperature, which indicates that the two-particle scattering process grows as the Kondo state evolves. Below the Kondo temperature, the Fano factor defined at finite temperature is found to exceed the expected value of unity from the noninteracting model, reaching 1.8±0.2.     

Coherent transfer of light polarization to electron spins in a semiconductor

We demonstrate that the superposition of light polarization states is coherently transferred to electron spins in a semiconductor quantum well. By using time-resolved Kerr rotation, we observe the initial phase of Larmor precession of electron spins whose coherence is transferred from light. To break the electron-hole spin entanglement, we utilized the big discrepancy between the transverse g factors of electrons and light-holes. The result encourages us to make a quantum media converter between flying photon qubits and stationary electron-spin qubits in semiconductors.     

Suppressed speckle contrast of blue light emission out of white lamp with phosphors excited by blue laser diodes for high-brightness lighting applications

The speckle contrast of blue light emission out of high-brightness white lamps using phosphors excited by InGaN/GaN blue laser diodes is evaluated as a measure of coherence. As a result, speckle contrast of as low as 1.7%, the same level as a blue light emitting diode, is obtained. This implies that the original blue laser light can be converted into incoherent light through lamp structures without any dynamic mechanisms. This unique speckle-free performance is considered to be realized by multiple scattering inside the lamp structure, the multi-longitudinal mode operation of the blue laser diodes, and the use of multiple laser diodes. Such almost-incoherent white lamps can be applied for general lighting without any nuisance of speckle noise and should be categorized as lamps rather than lasers in terms of laser safety regulation.     

Effect of plasma treatment on interface property of BCN/GaN structure

Interface properties of BCN/GaN metal-insulator-semiconductor (MIS) structures are investigated by X-ray photoelectron spectroscopy (XPS) and capacitance versus voltage (C-V) characteristics measurements. The BCN/GaN samples are fabricated by in situ process consisting of plasma treatment and deposition of BCN film in the plasma-assisted chemical vapor deposition (PACVD) apparatus. XPS measurement shows that the oxide formation at the BCN/GaN interface is suppressed by nitrogen (N₂) and hydrogen (H₂) plasma treatment. The interface state density is estimated from C-V characteristics measured at 1 MHz using Terman method. The minimum interface state density appears from 0.2 to 0.7 eV below the conduction band edge of GaN. The minimum value of the interface state density is estimated to be 3.0 × 10¹⁰ eV⁻¹ cm⁻² for the BCN/GaN structure with mixed N₂ and H₂ plasma treatment for 25 min. Even after annealing at 430 °C for 10 min, the interface state density as low as 6.0 × 10¹⁰ eV⁻¹ cm⁻² is maintained.     

Efficient sum-frequency generation of continuous-wave single-frequency coherent light at 252 nm with dual wavelength enhancement

Highly efficient frequency conversions were conducted to obtain deep-ultraviolet single-mode coherent light by use of two-stage external cavities. A power of 154 mW at approximately 252 nm was obtained with a conversion efficiency of more than 8% by doubly resonant sum-frequency mixing of 373-nm light from the first-stage conversion and 780-nm light from a single-mode Ti:sapphire laser. The output performance of the deep-ultraviolet light source is sufficient for use in the laser cooling of neutral silicon atoms.     

Characteristics of ZnO epilayer on the post-annealed buffer layer on GaN/sapphire substrate by pulsed laser deposition

We employed epi-GaN substrates for ZnO film growth, and studied the deposition and post-annealing effects. ZnO films were grown by pulsed laser deposition (PLD) method. The as-grown films were annealed for one hour under atmospheric pressure air. ZnO morphologies after annealing were investigated and the post-annealed ZnO films grown at T _g =700^oC have very smooth surfaces and the rms with roughness is about 0.5 nm. Finally, ZnO post-annealed buffer layer was inserted between ZnO epilayer and GaN/sapphire substrates. It is confirmed by AFM that growth temperature of 700^oC helps the films grow in step-flow growth mode. It is observed by cathode luminescence spectrum that the ZnO film grown at 700^oC has very low visible luminescence, indicating the decrease of the deep level defects. It is also revealed by Hall measurements that carrier concentration is decreased by increasing the growth temperatures. It is suggested that low temperature buffer layer growth and post-annealing technique can be used to fabricate ZnO hetero-epitaxy.     

Synthesis of cis-3-arylated cycloalkylamines through palladium-catalyzed methylene sp carbon–hydrogen bond activation

Methylene sp³ carbon–hydrogen bond activation of N-picolinoylcycloalkylamines provides a useful method for synthesizing cis-3-arylated cycloalkylamine derivatives. Pd(II) species catalyzed the γ-arylation of N-picolinoylcycloalkylamines with aryl iodides in the presence of silver carbonate to afford cis-3-arylated N-picolinoylalkylamines in up to 87% yield. Hydrolysis of the amide linkage to give the corresponding cis-3-arylated cycloalkylamines was also demonstrated.     

Multispectral hyperbolic incoherent holography

This paper presents a new method of multispectral hyperbolic incoherent holography in which a hyperbolic volume interferogram was directly measured by an appropriate designed interferometer. This method enables to obtain a set of spectral components of three-dimensional images and continuous spectra for spatially incoherent, polychromatic objects. We introduced a calibration method of a phase aberration of the interferometer. The spectral resolution and spatial resolutions are investigated based on analytical solution of impulse response function of hyperbolic holography. From experimental results and theoretical predictions, the validity of the calibration method was confirmed. Experimental results agree with the theoretical ones. Consequently, the retrieved images obtained by the method are shown to demonstrate the performance of the method.