n-Hexane dehydrocyclization over Pt?Ni supported on alumina catalysts

Pt–Ni/-Al₂O₃ catalysts have been prepared and studied in n-hexane dehydrocyclization. The selectivity for benzene and toluene, a chain lengthening product formation was improved by Ni and correlated with its content.

---

Pt–Ni/-Al₂O₃ -. Ni . Ni , .

     

用EXAFS研究NiO在γ-Al2O3表面上的分散

本文使用EXAFS方法研究NiO在γ-Al_2O_3的表面上的分散情况。文章讨论了Ni含量为7%、13%、18%、26%、35%的NiO/γ-Al_2O_3体系的径向结构函数图以及Ni含量为13%、26%的NiO/α-Al_2O_3样品的径向结构函数图,认为NiO能在γ-Al_2O_3表面上成单层分散。分散后的Ni-O距离接近NiO晶体的Ni-O距离,表明Ni离子和γ-Al_2O_3表面上的氧有很强的相互作用。     

Adsorption of Carbon Dioxide on Activated Carbon

The adsorption of CO2 on a raw activated carbon A and three modified activated carbon samples B, C, and D at temperatures ranging from 303 to 333 K and the thermodynamics of adsorption have been investigated using a vacuum adsorption apparatus in order to obtain more information about the effect of CO2 on removal of organic sulfur-containing compounds in industrial gases. The active ingredients impregnated in the carbon samples show significant influence on the adsorption for CO2 and its volumes adsorbed on modified carbon samples B, C, and D are all larger than that on the raw carbon sample A. On the other hand, the physical parameters such as surface area, pore volume, and micropore volume of carbon samples show no influence on the adsorbed amount of CO2. The Dubinin-Radushkevich (D-R) equation was the best model for fitting the adsorption data on carbon samples A and B, while the Preundlich equation was the best fit for the adsorption on carbon samples C and D. The isosteric heats of adsorption on carbon samples A, B, C, and D derived from the adsorption isotherms using the Clapeyron equation decreased slightly increasing surface loading. The heat of adsorption lay between 10.5 and 28.4 kJ/mol, with the carbon sample D having the highest value at all surface coverages that were studied. The observed entropy change associated with the adsorption for the carbon samples A, B, and C (above the surface coverage of 7 ml/g) was lower than the theoretical value for mobile adsorption. However, it was higher than the theoretical value for mobile adsorption but lower than the theoretical value for localized adsorption for carbon sample D.     

Synthesis and Antiproliferative Activity of Cyano and Amidino Substituted 2-Phenylbenzothiazoles

Series of cyano, dicyano, amidino, and diamidino substituted 2-phenylbenzothiazoles were prepared. Mono- and dicyano substituted benzothiazoles were obtained by condensation of appropriate substituted benzaldehydes with 2-aminothiophenol or 4-amino-3-mercaptobenzonitrile. The appropriate amidines or diamidines were prepared by Pinner reaction. The compounds were tested against breast, prostate, and lung cancer cell lines in a 72 h cytotoxicity assay. Many of the compounds had at 10 μM activity equivalent to 2-(4-aminophenyl)benzothiazole, while four compounds had significantly better activity, particularly in the breast cancer model.     

Elucidation of the vicarious nucleophilic substitution of hydrogen mechanism via studies of competition between substitution of hydrogen, deuterium, and fluorine.

Relations of rates of the vicarious nucleophilic substitution of hydrogen (VNS) and S(N)Ar substitution of fluorine in 2-fluoronitrobenzenes with chloroalkyl aryl sulfone carbanions were determined from competitive experiments carried out at various concentrations of base. The observed dependence of the VNS/S(N)Ar rate ratio on the base concentration confirmed the two-step mechanism of the VNS, which consists of reversible formation of sigma(H) adducts of the alpha-chlorocarbanion to nitroarene, followed by base-induced beta-elimination of HCl. It was also evidenced that both of these processes can be the rate-limiting steps: the beta-elimination at low base concentration and the nucleophilic addition at high base concentration. Consistent with that conclusion is the finding that the kinetic isotope effect in the VNS reaction decreases from 4.2 (a value typical of a primary KIE) to 0.8 (a value typical of a secondary KIE) with increasing base concentration. Also reported is our discovery that the S(N)Ar substitution of the 2-fluoronitrobenzenes studied in this work was subject to base catalysis under some of the experimental conditions employed in our competitive experiments.     

Decomposition of Toluene and Acetone in Packed Dielectric Barrier Discharge Reactors

The influences of TiO₂ catalytic material and glass pellet packing on the decomposition efficiency of toluene and acetone in air by dielectric barrier discharge (DBD) reactors were experimentally investigated in this study. The effects of both packing materials on the formation of byproducts such as CO and CO₂ were also evaluated. Experimental results indicate that the introduction of glass materials into the plasma zone of a wire-tube reactor would improve the decomposition efficiency of toluene and acetone compared to a nonpacked reactor. The apparent decomposition rate constant of a glass packed-bed reactor was 4.5–4.8 times greater than that of a nonpacked reactor. The results also indicate that the decomposition rate constant of toluene was approximately 2.6 times higher than that of acetone no matter which type reactor was utilized. The application of TiO₂ coated pellets in DBD reactors will enforce the hydrocarbon byproducts to further be oxidized to CO₂, notwithstanding, it will not significantly improve the performance of the reactors in the decomposition of toluene and acetone, and in the formation of CO. The results show that the best selectivity of CO₂ for acetone decomposition in a TiO₂ coated pellets packed-bed reactor was approximately 40% higher than that in a glass packed-bed reactor.     

Separation and identification of perchlorinated polycyclic aromatic hydrocarbons by high-performance liquid chromatography and ultraviolet absorption spectroscopy

High-performance liquid chromatography (HPLC) was coupled with ultraviolet absorption spectroscopy (UV) for the simultaneous separation and identification of a series of perchlorinated polycyclic aromatic hydrocarbons, such as perchlorobenzene (C6Cl6), perchloronaphthalene (C10Cl8), perchlorobiphenyl (C12Cl10), perchloroanthracene (C14Cl10), perchlorophenanthrene (C14C10), perchloroacenaphthylene (C12Cl8), perchloropyrene (C16Cl10) and perchlorofluoranthene (C16Cl10). HPLC was performed on an ODS column using methanol-hexane (80:20) as mobile phase at a flow-rate of 1.0 ml/min. UV absorption spectra of the elutes were detected in the region of 210-350 nm.     

Development and application of a simple routine method for the determination of selenium in serum by octopole reaction system ICPMS

The aim of the study was to develop an inductively coupled plasma mass spectrometry (ICPMS) method for robust and simple routine determination of selenium in serum. Polyatomic interferences on ⁷⁶Se, ⁷⁷Se, and ⁷⁸Se were removed by applying an octopole reaction system ICPMS with the reaction cell pressurized with H₂ gas. We developed a novel simple optimization routine for the H₂ gas flow based on a signal-to-noise ratio (SNR) calculation of the selenium signal measured in a single selenium standard. The optimum H₂ flow was 2.9 mL min^–1. The selenium content in serum was determined after a 50-fold dilution with 0.16 M HNO₃ and quantified by using addition calibration and gallium as an internal standard. The method detection limit was 0.10 g L^–1 for ⁷⁶Se and ⁷⁸Se and 0.13 g L^–1 for ⁷⁷Se. Human serum samples from a case-control study investigating if selenium was associated with risk of colorectal adenoma were analyzed. The average selenium concentration for the control group (n=768) was 137.1 g L^–1 and the range was 73.4–305.5 g L^–1. The within-batch repeatability (a batch is ten samples) estimated from 182 replicate analyses was 6.3% coefficient of variation (CV), whereas the between-batch repeatability was 7.4% CV estimated from 361 replicates between batches. The method accuracy was evaluated by analysis of a human serum certified reference material (Seronorm Serum level II, Sero A/S, Norway). There was a fairly good agreement between the measured average of 145±3 g L^–1 (n=36) and the certified value of 136±9 g L^–1. In addition the method was successfully applied for analysis of zinc serum concentrations without further optimization. For the Seronorm certified reference material a value of 911±75 g L^–1 (n=31) for zinc was obtained, which corresponds well to the certified zinc value of 920±60 g L^–1.     

Determination of trace metals by ICP-OES in plant materials after preconcentration of 1,10-phenanthroline complexes on activated carbon

In this work, 1,10-phenanthroline was used as a complexing agent for the separation and preconcentration of Cd(II), Co(II), Ni(II), Cu(II) and Pb(II) on activated carbon. The metals were adsorbed on activated carbon by two methods: static (1) and dynamic (2). The optimal condition for separation and quantitative preconcentration of metal ions with activated carbon for the proposed methods was for (1) in the static methods in the pH range 7-9. The desorption was found quantitative with 8 mol dm⁻³ HNO₃ for Cd(II) (92.6%), Co(II) (95.6%), Pb(II) (91.0%), and with 3 mol dm⁻³ HNO₃ for Cd(II) (95.4%), Pb(II) (100.2%). The preconcentration factor was 100 with R.S.D. values between 1.0 and 2.9%. For (2), the dynamic method (SPE), the pH range for the quantitative sorption was 7-9. The desorption was found quantitative with 8 mol dm⁻³ HNO₃ for Cd(II) (100.6%), Pb(II) (94.4%), and reasonably high recovery for Co(II) (83%), Cu(II) (88%). The optimum flow rate of metal ions solution for quantitative sorption of metals with 1,10-phenanthroline was 1-2 cm³ min⁻¹ whereas for desorption it was 1 cm³ min⁻¹. The preconcentration factor was 50 for all the ions of the metals with R.S.D. values between 2.9 and 9.8%.The samples of the activated carbon with the adsorbed trace metals can be determined by ICP-OES after mineralization by means of a high-pressure microwave mineralizer. The proposed method provides recovery for Cd (100.8%), Co (97.2%), Cu (94.6%), Ni (99.6%) and Pb (100.0%) with R.S.D. values between 1.2 and 3.2%.The preconcentration procedure showed a linear calibration curve within the concentration range 0.1-1.5 μg cm⁻³. The limits of detection values (defined as “blank + 3s” where s is standard deviation of the blank determination) are 5.8, 70.8, 6.7, 24.6, and 10.8 μg dm⁻³ for Cd(II), Pb(II), Co(II), Ni(II) and Cu(II), respectively, and corresponding limit of quantification (blank + 10s) values were 13.5, 151.3, 20.0, 58.9 and 33.2 μg dm⁻³, respectively.As a result, these simple methods were applied for the determination of the above-mentioned metals in reference materials and in samples of plant material.     

Investigation of Cd(II), Pb(II) and Cu(I) complexation by glutathione and its component amino acids by ESI-MS and size exclusion chromatography coupled to ICP-MS and ESI-MS

The elucidation of structures of glutathione (GSH) complexes play an important role in the fundamental understanding of biochemical pathways of metal ion deactivation in plants. This article attempts to feature key studies for stoichiometry of metal complexes with glutathione and its constituent amino acids to obtain a better understanding of the different metal affinities of the complexation sites of glutathione. The SEC-ICP-MS experiments have indicated that oxidation process of glutathione was accelerated by metal ion presence in following order Cu⁺, Pb²⁺ and Cd²⁺. The redox activity of metal ions was confirmed by ESI-MS experiments, which allowed to observe formation of glutathione disulphide (GSSG) in time. The stoichiometry of Cd²⁺, Cu⁺ and Pb²⁺ complexes with GSH was defined by observing the isotope pattern of investigated metals and hydrogen loss or transfer during binding. The complexes with metal bound to sulphur of 1:1 and 1:2 stoichiometry were found in case of cadmium and lead. The number of hydrogen atoms lost during metal binding and the SEC-ESI-MS results allowed to elucidate that copper is bound by GSSG in ratio 1:1 and 1:2. Additionally, size exclusion chromatography coupled to electrospray MS allowed to differentiate more stable complexes from weak ones that could be created in the gas phase.