Investigation of all-solid photonic bandgap fiber with low losses in low-order bandgaps

We report synoptically an investigation of design, fabrication and characterization of a new all-solid photonic bandgap fiber. By introducing an index depressed layer around a high index core in every unit cell of photonic crystal cladding, a novel all-solid bandgap fiber is predicted to obtain low confinement and bend losses within low-order bandgaps. After optimizing the structure parameters, we fabricate a batch of rods used for cladding cells, select a pure-silica rod for core cell and an inner-hexagonal jacket tube. We demonstrate an all-solid bandgap fiber with the transmission loss as low as 2 dB/km at 1,310 nm and a bandwidth of over 700 nm within the first bandgap. The guiding properties are also measured, respectively, such as transmission spectrum, attenuation spectrum, bend loss, mode field intensity profile, and chromatic dispersion.     

北京同步辐射装置3W1B软X射线光束线偏振特性测量

应用自行研制的Mo/Si周期多层膜作为起偏器和检偏器的光学元件, 测量了北京同步辐射装置3W1B束线的偏振状态. 通过数据分析, 得到了3W1B软X射线的有关偏振参数, 在86—89eV能区经过起偏器后的偏振度超过98%, 圆偏振分量介于1%—3%之间.     

射流注入角对平板气膜冷却特性影响的实验研究

本文对不同射流注入角的典型单排孔冷却结构的平板气膜冷却特性进行了实验研究,研究对象为轴线与主流来流方向分别成30°、60°、90°的射流孔板,对它们在吹风比为0.5、1.0、1.5条件下的射流孔下游的绝热气膜冷却效率分布特性进行了分析.在吹风比M=0.5时,三个射流注入角条件下近孔区域都能形成较好的冷气覆盖效果;M=1.0时,三者的下游横向平均冷却效率基本相同;M=1.5时,注入角60°的条件下冷却效果最好.     

Microstructure of yttric calcium phosphate bioceramic coatings synthesized by laser cladding

The yttric calcium phosphate (CaP) coatings were in situ prepared on pure titanium substrate by laser cladding. The morphologies and phases constitution of CaP coatings were studied by electron probe microanalysis, X-ray diffraction and so on. The bonding state between the coating and the substrate is fine metallurgical combination, and the addition of yttria can fine the structure and increase the tensile strength of the coatings. The X-ray result shows that the coating is composed of the phases of HA, α-Ca₂P₂O₇, β-Ca₂P₂O₇ and CaTiO₃.     

Re-examining generalized teleportation protocol

We present an explicit generalized protocol for probabilistic teleportation of an arbitrary N-qubit GHZ entangled state via only one non-maximally two-qubit entangled state. Without entanglement concentration, using standard Bell-state measurement and classical communication one cannot teleport the state with unit fidelity and unit probability. We show that by properly choosing the measurement basis it is possible to achieve unity fidelity transfer of the state. Compared with Gordon et al’s protocol [G. Gordon, G. Rigolin, Phys. Rev. A 73 (2006) 042309], this protocol has the advantage of transmitting much less qubits and classical information for teleporting an arbitrary N-qubit GHZ state.     

Optimization on Synchrotron Radiation Lattice of BEPCII

The Beijing Electron and Positron Collider II （BEPCII） is a double ring electron positron collider, which can also be used as a synchrotron radiation （SR） light source. Since the BEPCII will start commissioning with SR mode in November 2006, it is essential to have a satisfying SR lattice. Here we first perform frequency map analysis on the original BEPCII SR lattice. The result shows that the resonance is really severe in the lattice and the transverse motion of particles is unstable. Then a new SR lattice is designed to obtain a large dynamic aperture and much more stable transverse motion. The dynamic aperture of the new lattice including nonlinear wiggler effect is calculated to be very good. This new SR lattice can be used in the commissioning stage of the BEPCII.     

Thickness Determination for a Two-Layered Composite of a Film and a Plate by Low-Frequency Ultrasound

We present an ultrasonic method for determining the thickness of a composite consisting of a soft thin film attached to a hard plate substrate, by resonance spectra in the low frequency region, The interrogating waves can be incident only to the two-layered composite from the substrate side. The reflection spectra are obtained by FFT analysis of the compressive pulsed echoes from the composite, and the thicknesses of the film and the substrate are simultaneously inversed by the simulated annealing method from the resonant frequencies knowing other acoustical parameters in prior. The sensitivity of the method to individual thickness, its convergence and stability against experimental noises are studied, Experiment with interrogating wavelength 4 times larger than the film thickness in a sample of a polymer film （0.054mm） on an aluminium plate （6.24mm） verifies the validity of the method. The average relative errors in the measurement of the thicknesses of the film and the substrate are found to be -4.1% and -0.62%, respectively.     

Electronic Structure of Si1-xⅣx/Si Superlattices on Si （001）

We have preformed systematical ab initio studies of the structural and electronic properties of short-period Si1-xⅣx/Si （x = 0.125, 0.25, 0.5, Ⅳ=Ge, Sn） superlattices （SLs） grown along the [001] direction on bulk Si. The present calculations reveal that the Si0.875Ge0.125/Si, Si0.75Ge0.25/Si and Si0.875Sn0.125/Si are the F-point direct bandgap semiconductors. The technological importance lies in the expectation that the direct gap Si1-xⅣx/Si SLs may be used as components in integrated optoelectronic devices, in conjunction with the already well-established and highly advanced silicon technology.     

Transmission Properties of W3 Y-Branch Filters in Two-Dimensional Photonic Crystal Slabs

A highly efficient W3 Y-branch filter in a two-dimensional photonic crystal slab with triangular lattice of air holes is designed and fabricated, and its transmission properties are measured. By accurately adjusting the size of the resonant cavities, the minimum wavelength spacing of 7 nm between two channels is realized. The corresponding resonant wavelengths of the two cavities agree well with the calculated ones. This implies that this kind of fiIter may be promising in integrated wavelength division multiplexing system.     

单偏振控制器环形腔光纤激光器实验研究

理论分析了非线性偏振旋转环形腔作为类饱和可吸收体获得脉冲的物理机理。在光纤环形腔结构中,采用单个偏振控制器实现了非线性偏振旋转锁模,直接获得了脉冲宽度为131 fs的超短脉冲输出。实验中,采用性能稳定的976 nm半导体二极管激光器作为抽运源,使用高掺杂浓度的Er3 光纤为增益介质,通过调节偏振控制器,获得了光谱谱宽(3 dB带宽处)为23.5 nm的稳定锁模脉冲输出。脉冲中心波长为1535.9 nm,平均功率为5.91 mW,脉冲重复率为11.20 MHz。