Direction control of chemical wave propagation in self-oscillating gel array

A chemomechanical actuator utilizing a reaction-diffusion wave across gap junction was constructed toward a novel mircoconveyer by micropatterned self-oscillating gel array. Unidirectional propagation of the chemical wave of the Belousov-Zhabotinsky (BZ) reaction was induced on gel arrays. In the case of using a triangle-shaped gel as an element of the array, the chemical wave propagated from the corner side of the triangle gel to the plane side of the other gel (C-to-P) across the gap junction, whereas it propagated from the plane side to the corner side (P-to-C) in the case of the pentagonal gel array. Numerical analysis based on the Keener-Tyson model was done for understanding the mechanism of unidirectional propagation in triangle and pentagonal gel arrays. The swelling and deswelling changes of the gels followed the unidirectional propagation of the chemical wave.     

Controlled growth for synthesizing a compact mordenite membrane

Controlling the growth of zeolite crystals on a porous alumina support is essential for preparing a compact zeolite membarne. First, mordenite seed crystals applied on a nonporous -alumina disk were grown and morphological change of mordenite crystals were observed in the course of growth. Then, mordenite membranes were synthesized on a porous -alumina tube under the same conditions employed in the study using the alumina disks. We found that seed crystal growth was widely controllable by changing water content in reaction solution, which resulted in better control of the morphology of mordenite crystals for synthesizing a thin compact mordenite membrane. Separation properties for mordenite membranes were studied in water–hydrogen binary system at 473 K with 10 kPa of water partial pressure, where no capillary condensation was expected in non-zeolitic pores. Separation factor for a mordenite membrane with a few defects was poor; however, a defect-free mordenite membrane prepared under a suitable condition highly separated steam from hydrogen.     

Construction of Chiral Tri‐ and Tetra‐Arylmethanes Bearing Quaternary Carbon Centers: Copper‐Catalyzed Enantioselective Propargylation of Indoles with Propargylic Esters

Copper‐catalyzed enantioselective propargylation of indoles with propargylic esters and sequential Huisgen cycloaddition with azides lead to the construction of chiral triarylmethanes, bearing a quaternary carbon center, with high to excellent enantioselectivities. The result described herein can be used in the enantioselective preparation of a tetraarylmethane.     

Alkylation of active methylene compounds with alcohols catalyzed by an iridium complex

Base-free catalytic alpha-alkylation of active methylene compounds with primary alcohols was successfully achieved using an [IrCl(cod)](2) complex in the presence of PPh(3) to afford the corresponding saturated alpha-alkylated products in good yields.     

Simple and sensitive quantification of bioactive peptides in biological matrices using liquid chromatography/selected reaction monitoring mass spectrometry coupled with trichloroacetic acid clean-up

A simple and sensitive liquid chromatography/electrospray ionization tandem mass spectrometric (LC/ESI-MS/MS) method has been developed for the quantification of bioactive peptides in biological fluids. The method employs protein precipitation with 4% trichloroacetic acid (TCA) and selected reaction monitoring (SRM) using an immonium ion as the product ion. This method was applied to determine the synthetic parathyroid hormone (PTH) analog (MW 1721) in rat plasma and human hepcidin-25 (MW 2789) in human serum. TCA clean-up showed a sufficient recovery for peptides with a MW of less than 3000, and would be useful as a simple and rapid method because of direct injection of the supernatant without evaporation or dilution. In addition, TCA clean-up allowed us not only to reduce sample preparation time, but also to select an immonium ion as a product ion of SRM, which led to detection more sensitive than SRM using other types of product ions. The lower limits of quantitation (LLOQs) of the PTH analog and the human hepcidin-25 were 0.2 ng/mL and 5 ng/mL, respectively. This method was fully validated with acceptable linearity, intra- and inter-assay precisions, and accuracy. Furthermore, this simple and rapid method is applicable to pharmacokinetic studies.     

Vibrational relaxation on the mixed vibronic levels of the and states in all-trans-neurosporene as revealed by subpicosecond time-resolved, stimulated emission and transient absorption spectroscopy

In all-trans-neurosporene, whose level is lower than the level by one vibrational quantum, the following two steps of vibrational relaxation from the mixed vibronic states were identified, in the order, stimulated emission stimulated emission transient absorption. The stimulated emission patterns were simulated by the use of Franck–Condon factors in the transitions from the pair of mixed vibronic levels down to the ground vibronic levels. The vibronic levels of the mixed and state were characterized theoretically based on the diabatic approximation.     

Simple on-line sample preconcentration technique for peptides based on dynamic pH junction in capillary electrophoresis-mass spectrometry

We report an on-line sample preconcentration technique based on dynamic pH junction in capillary electrophoresis-mass spectrometry (CE-MS). For peptide analysis, the samples were dissolved in a solution with higher pH than the background solution (BGS), and were injected into the capillary as a long plug. The pH difference between the sample matrix and BGS caused changes in analytes' mobilities during electrophoresis, resulting in narrowing of their bands at the boundary. Around 550-1000-fold sensitivity enhancement could be achieved in terms of peak intensity without degrading peak shape and resolution. This technique is easy to perform and will be useful for peptide mass fingerprinting in protein analysis.     

Array of aromatic amino acid side chains located near the chromophore of photoactive yellow protein

The role of the array of aromatic amino acid side chains located close to the chromophore binding loop of photoactive yellow protein (PYP) was studied using the alanine-substitution mutagenesis. Phe92, Tyr94, Phe96 and Tyr98 were replaced with alanine (F92A, Y94A, F96A and Y98A, respectively), then these mutants were characterized by UV-visible absorption spectra, circular dichroism (CD) spectra, thermal stability and photocycle kinetics. Absorption maxima of F92A, Y94A, F96A and Y98A were 444, 442, 439 and 447 nm, respectively, different to wild type (WT) at 446 nm. Far-UV CD spectra of mutants other than F92A were different from WT, indicating that Tyr94, Phe96 and Tyr98 maintain the native secondary structure of PYP. Mid-point temperatures of thermal denaturation of F92A, Y94A and F96A, estimated by the CD signal at 222 nm, were 5-10 degrees C lower than WT. Time constants of the photocycle estimated by flash-induced absorbance change were 0.36 s for WT and 1.4 s for Y98A, however, 100, 30 and 3000 times slower than WT for F92A, Y94A and F96A, respectively. Tyr98 is located in the loop region, whereas Phe92, Tyr94 and Phe96 are incorporated in the beta4 strand, showing that aromatic amino acid residues in the beta-sheet regulate the absorption spectrum, thermal stability and photocycle of PYP. Aromatic rings of Phe92, Tyr94 and Phe96 lie nearly perpendicular to the aromatic ring of Phe75 or chromophore. Possible weak hydrogen bonds between the aromatic ring hydrogen and pi-electrons of these residues are discussed.