FTIR-ATR evaluation of organic contaminant cleaning methods for SiO2 surfaces.

The effectiveness of cleaning organic contaminants from silicon dioxide (SiO2) surfaces was studied by conducting highly sensitive measurements using Fourier Transform Infrared Attenuated Total reflectance (FTIR-ATR) with a Si prism as the waveguide. To serve as an example, the surface of the prism was oxidized to an order of a few nanometers. The oxidized Si surface film was allowed to stand in the atmosphere and then wet-cleaned in a repeated manner; subsequently its thickness was measured by ellipsometry. Although, various wet-cleaning methods were tested, they only showed values of 0.1-0.2 nm larger than, but not equal to, the original thickness immediately after oxidation. FTIR-ATR measurements of the spectral change after exposure to air revealed that organic species, such as C-CH3 and -(CH2)n-, increased with time. Wet-cleaning the sample failed to remove the C-CH3 species, which indicates that they corresponded to the film thickness increment from the original.     

Sequential asymmetric homoallenylation of primary amines with a palladium catalyst

Optically active bis(homoallenyl)amines bearing two chiral axes with the same sense of axial chirality were prepared by a one-pot, palladium-catalyzed sequential homoallenylation of primary amines with 2,3-allenyl phosphates.     

Fluorescence response mechanism of D-glucose selectivity for supramolecular probes composed of phenylboronic-acid-modified beta-cyclodextrin and styrylpyridinium dyes.

Supramolecular complex formation of phenylboronic-acid-modified beta-cyclodextrin (1) with 1-methyl-4-(4-dimethylaminostyryl)pyridinium (C1SP) in aqueous solutions containing saccharides was fully clarified to gain an insight into the observed D-glucose (D-glc) selectivity of a supramolecular fluorescent probe composed of 1 and the 1-heptyl analogue of C1SP (Chem. Commun., 2006, 4319). At pH 9.6, where 1 was in its anionic form, both the stability and the fluorescence of the 1/C1SP complex were reduced by the formation of boronate esters of 1 with saccharides. Among the saccharides, D-glc had the smallest effect on destabilization of the 1/C1SP complex, almost completely retaining the fluorescence of the 1/C1SP complex that was reduced by other saccharides by approximately 2/3. Under neutral conditions, D-glc enhanced the fluorescence of the 1/C1SP complex by increasing the fraction of anionic 1 while minimally decreasing the stability and fluorescence of the 1/C1SP complex. Although other saccharides also increased the fraction of the anionic 1, their relatively large effects on the destabilization and reduction of fluorescence of the 1/C1SP complex limited the enhancement of the fluorescence of the 1-C1SP system under neutral conditions.     

Observation of Overhauser shift in a self-assembled InAlAs quantum dot

We report the polarization-dependent energy shift of excitonic emission in a self-assembled InAlAs/AlGaAs quantum dot (QD). The energy shift is well known as Overhauser shift and was observed in a naturally formed GaAs QD using monolayer fluctuation of a quantum well. However, there has been no observation so far in a self-assembled QD, which is suitable for formation of vertically coupled QDs. We demonstrate that the magnitude of the Overhauser shift is enhanced by the photo-injection of the highly polarized electron and is controllable by the polarization of the excitation light in a self-assembled InAlAs QD.     

A simple in situ visual and tristimulus colorimetric method for the determination of trace arsenic in environmental water after its collection on a mercury(II)-impregnated paper.

A simple in situ visual and tristimulus colorimetric method for the determination of trace arsenic in environmental water after collecting arsenic on a test paper impregnated with mercury(II) bromide and rosaniline chloride by its reduction aeration has been developed. The color development on the test paper is based on the formations of AsH(HgBr)2 (yellow) and/or As(HgBr)3 (brownish yellow) by a reaction between mercury(II) bromide and arsine (AsH3), which is produced through the reduction of As(III) (arsenite ion) and/or As(V) (arsenate ion) in a sample solution. To a sample solution, potassium iodide, tin(II) chloride, zinc sand and 4 ml of 6 M hydrochloric acid solution were added successively. The liberated arsine was collected on the test paper. The yellow or brownish-yellow color intensity on the test paper was measured by a tristimulus colorimeter and also by a visual method. The established method is applicable to the determination of arsenic in environmental water sample such as river, brackish, and seawater types.     

Dynamics in disordered block copolymers and miscible blends composed of poly(vinyl ethylene) and polyisoprene

We investigated the segmental and terminal relaxation dynamics of a well‐characterized disordered diblock copolymer, poly(isoprene‐b‐vinyl ethylene) (PI‐PVE), and miscible blends of polyisoprene (PI)/poly(vinyl ethylene) (PVE), using dielectric and viscoelastic spectroscopies. Generally, the concentration fluctuation (CF) amplitude of a disordered diblock copolymer is smaller than that of the miscible blend, especially in a length scale longer than the size of the whole block chain. To test whether the difference in the CF amplitudes causes the difference in the segmental relaxation spectra, we compared the shape of the dielectric loss curves between PI‐PVE and PI/PVE with the same composition (PI/PVE ratio = 17:83). However, no appreciable difference was observed, indicating that the CF amplitudes in PI‐PVE and PI/PVE are not so different in the length scale of the segmental motions. We also examined the effect of distinct friction coefficients of the PI and PVE chains on the terminal relaxation dynamics by comparisons of the viscoelastic and dielectric normal mode relaxations in PI‐PVE. The former probes the whole chain motion and the latter probes motions of the PI block. Shift factors (a_T) for the viscoelastic and dielectric relaxations were compared. The dielectric normal mode a_T was found to have weaker temperature dependence than the viscoelastic a_T, which indicates that the friction for the PI block chain is lower than the average friction for the PI‐PVE chain. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 4084–4094, 2004     

A cost allocation problem arising in hub–spoke network systems

This paper studies a cost allocation problem arising from hub–spoke network systems. When a large-scale network is to be constructed jointly by several agents, both the optimal network design and the fair allocation of its cost are essential issues. We formulate this problem as a cooperative game and analyze the core allocation, which is a widely used solution concept. The core of this game is not necessarily non-empty as shown by an example. A reasonable scheme is to allocate the cost proportional to the flow that an agent generates. We show that, if the demand across the system has a block structure and the fixed cost is high, this cost allocation scheme belongs to the core. Numerical experiments are given with real telecommunication traffic data in order to illustrate the usefulness of our analytical findings.     

Initial oxidation of HF-acid treated Si(1 0 0) surfaces under air exposure studied by synchrotron radiation X-ray photoelectron spectroscopy

Initial oxidation of HF-acid treated Si(1 0 0) surfaces with air exposure has been studied by using synchrotron radiation X-ray photoelectron spectroscopy. We demonstrate that the initial oxidation is explained not by a layer-by-layer process, but by a non-uniform mechanism. Just after dipping a Si substrate in HF-acid and spin-drying, the Si surface is immediately oxidized partly with a coverage of 0.2. It is considered that the non-uniform oxidation takes place at surface defects on H passivated Si surfaces. With increasing the air exposure up to 1 week, we have found that the non-oxidized part is oxidized uniformly at slower rates compared to the beginning. IR absorption spectroscopy with a multiple-internal-reflection geometry clearly indicates the backbond oxidation of surface Si takes place despite the H passivation produced by the HF-acid treatment.     

Accelerated Molecular Dynamics Study of Z/E Isomerization of Azobenzene: Kramers’ Theory Validation

The reaction rate in a condensed phase is retarded by solvent friction and deviates from the transition state theory (TST) in a highly viscous solvent. The Z/E isomerization kinetics of 4-dimethylamino-4′-nitroazobenzene in solution have been experimentally analyzed in a wide range of pressure in our previous studies. Herein the non-TST behaviors of the rate constant were theoretically modelled by means of Kramers’ theory and its extensions and by molecular dynamics (MD) simulations. The Z/E isomerization takes place in milliseconds or longer and so is not reachable by normal MD simulations. The accelerated MD method was employed to simulate the rare events using a biased isomerization potential barrier.