Synergetic degradation of chitosan with gamma radiation and hydrogen peroxide

Chitosan samples were irradiated by ⁶⁰Co γ-rays in the presence of hydrogen peroxide with radiation dose from 10 kGy to 100 kGy. The degradation was monitored by gel permeation chromatography (GPC), revealing the existence of a synergetic effect on the degradation. Structures of the degraded products were characterized with Fourier-transform infrared spectra (FT-IR), ultraviolet-visible spectral (UV-vis) analysis, and X-ray diffraction (XRD). Results showed that the crystallinity of chitosan decreases with degradation, and the crystalline state of water-soluble chitosan is entirely different from that of water-insoluble chitosan. An elemental analysis method was employed to investigate changes in the element content of chitosan after degradation. Mechanism of chitosan radiation degradation with and without hydrogen peroxide was also discussed.     

Patterned langmuir-blodgett films of monodisperse nanoparticles of iron oxide using soft lithography

Langmuir-Blodgett (LB) films of monodisperse iron oxide nanoparticles have been successfully deposited onto patterned poly(dimethylsiloxane) surfaces. These patterned LB films of iron oxide nanoparticles were transferred onto solid substrates using micro contact printing.     

Investigation on the Performance of Supported Molybdenum Carbide for the Partial Oxidation of Methane

The performance of uspported and unsupported molybdenum carbide for the partial oxidation of methane (POM) to syngas was investgated.An evaluation of the catalysts indicates that bulk molybdenum carbied has a higher methane conversion during the initial stage but a lower selectivity to CO and H2/CO ratio in the products.The rapid deactivation of the catalyst is also a significant problem.However,the supported molybdenum carbide catalyst shows a much higher methane conversion,increased selectivity and significantly improved catalytic stability.The characterization by XRD and BET specific area measurements depict an improved dispersion of molybdenum carbide when using alumina as a carrier.The bulk or the supported molybdenum carbide exists in the β-Mo2C phase,while it is transformed into molybdenum dioxide postcatalysis which is an improtant cause of molybdenum carbide deactivation.     

Schiff碱配合物模拟酶催化性能的温度效应研究

研究了新型Schiff碱双锰配合物在模拟酶催化亚碘酰苯单加氧化环已烷反应及 被亚碘酰苯氧化破坏反应中的温度效应。结果表明，在模拟酶催化反应体系中同时 存在催化环已烷单加氧反应及催化剂的氧化破坏反应；催化反应速率及氧化破坏反 应速率均随反应温度升高有规律地增大，但氧化破坏反应比催化反应对反应温度更 敏感；催化反应总产率一般随反应温度升高而降低；最适宜的反应温度为25 ℃。     

笼形聚氨肟树脂的研究：碱处理对吸附性能的影响

研究碱处理的笼形聚氨肟树脂（ＢＣＡＯ）对二价金属离子的吸附行为。吸附结果若生成２：１配的，得Ｍｇ＾２＋，Ｃａ＾２＋，Ｂａ＾２＋，Ｍｎ＾２＋，Ｃｏ＾２＋，Ｎｉ＾２＋，Ｚｎ＾２＋，Ｃｄ＾２＋，Ｐｂ＾２＋，Ｃｕ＾２＋离子的吸附效率分别是２７．１、２９．２、３０．４、２９．０、２７．１、３０．８、４５．０、３９．８、６０．３、６２．１％，Ｈｇ＾２＋离子的吸附效率高达１０５％，表明在吸附过程中同时生成２：１     

Preparation and properties of polyarylates from 5-t-butylisophthaloyl chloride and various bisphenols

Polyarylates containing a t-butyl pendant group were prepared from 5-t-butylisophthaloyl chloride and various bisphenols through the phase-transfer catalyzed two-phase polycondensation. The polyarylates having inherent viscosities up to 3.1 dL/g were obtained quantitatively. They were readily soluble in various solvents such as chloroform, m-cresol, and pyridine. Coloreless, transparent, and flexible films could be cast from the chloroform solutions of the polymers. The polyarylates had glass transition temperatures between 210 and 320°C, and did not lose weight below 350°C, with 10% weight loss being recorded at 395–450°C in air.     

脊髓小脑变性疾病病人血清铜,锌,铝,铁含量的研究

脊髓小脑变性疾病（ＳＣＤ）的病因可能与遗传、神经生化紊乱、感染、微量元素平衡障碍及自由基损伤等因素有关，其中微量元素平衡障碍的研究具有重要意义。检测了ＳＣＤ中发病率较高的橄榄桥小脑萎缩症（ＯＰＣＡ）及晚发性小脑皮质萎缩症（ＬＣＣＡ）病人１５例血清中铜、锌、铝、铁等微量元素含量。发现病人比对照组铜明显降低，Ｐ〈０．０１；锌明显降低，Ｐ〈０．０１；铝明显升高，Ｐ〈０．０１；铁无明显差别。     

过敏性哮喘患者血清中10种必需微量元素水平的研究

３４例过敏性哮喘患者血清中铁，锌、铜，锰硒铬，钴镍，钡，钼的含量水平与对照组比较，揭示：（１）铁，铜，铬的含量升高；（２）硒，镍，钴、钒的钼的含量降低；（３）锌和锰的含量差异无显著性，Ｐ〉０．０５。     

X射线荧光光谱法在稀土元素分析中的应用

本文研究了Ｘ射线荧光光谱在混合稀土氧化物和高纯稀土氧化物分析中的应用，并探讨了在常量分析中影响分析准确度和精密度的主要因素；样品及标样制备，基体效应校正方法在痕量分析中降低检测限的方法，选择最佳测量条件，降低背景，与分离富集手段相结合，取得满意的结果。     

Microcalorimetric investigation of the growth of the <Emphasis Type="Italic">Escherichia coli</Emphasis> DH5α in different antibiotics

The effects of Amoxicillin Sodium and Cefuroxime Sodium on the growth of E. coli DH5α were investigated by microcalorimetry. The metabolic power-time curves of E. coli DH5α growth were determined by using a TAM air isothermal microcalorimeter at 37°C. By evaluation of the obtained parameters, such as growth rate constants (k), inhibitory ratio (I), the maximum heat power (P _m) and the time of the maximum heat power (t _m), one found that the inhibitory activity of Amoxicillin Sodium vs. E. coli DH5α is enhanced with the increasing of the Amoxicillin Sodium concentration, and the Cefuroxime Sodium has a stimulatory effect on the E. coli DH5α growth when the concentration is about 1 μg mL⁻¹. The IC₅₀ for the Amoxicillin Sodium and the Cefuroxime Sodium are 1.6 and 2.0 μg mL⁻¹, respectively, it implicates that the E. coli DH5α is more sensitive to Amoxicillin Sodium than Cefuroxime Sodium.