Measurement Bias on Nanoparticle Size Characterization by Asymmetric Flow Field-Flow Fractionation Using Dynamic Light-Scattering Detection

In this work, we highlight the influence of the particle–particle interaction on the retention behavior in asymmetric flow field-flow fractionation (A4F) and the misunderstanding considering the size determination by a light-scattering detector (static and dynamic light scattering) by comparing fullerene nanoparticles to similar sized polystyrene nanoparticle standards. The phenomena described here suggest that there are biases in the hydrodynamic size and diffusion determination induced by particle–particle interactions, as characterized by their virial coefficient. The dual objectives of this paper are to (1) demonstrate the uncertainties resulting from the current practice of size determination by detectors coupled to an A4F system and (2) initiate a discussion of the effects of particle–particle interactions using fullerene nanoparticles on their characterization as well as their origins. The results presented here clearly illustrate that the simple diffusion coefficient equation that is generally used to calculate the hydrodynamic size of nanoparticles (NPs) cannot be considered for whole fractograms according to their size distribution. We tried to identify particle interactions that appear during fractionation and demonstrated using the fully developed diffusion coefficient equation. We postulate that the observed interaction-dependent retention behavior may be attributed to differences in the virial coefficient between NPs and between NPs and the accumulation wall (membrane surface) without quantifying it. We hope that our results will stimulate discussion and a reassessment of the size determination procedure by A4F-LS to more fully account for all the influential material parameters that are relevant to the fractionation of nanoscale particles by A4F.     

Static Headspace GC/MS Method for Determination of Methanol and Ethanol Contents,as the Degradation Markers of Solid Insulation Systems of Power Transformers

Methanol in insulating oil has been proposed as a new marker for condition assessment of the solid insulation system of power transformers. In the current work, as a first step of using the new marker, an analytical static headspace gas chromatography/mass spectrometry method has been developed, optimized, and validated to measure methanol and ethanol contents in the insulating mineral oil. The analyzing setup consists of a 6890 N gas chromatograph equipped with a 5973 network mass spectrometer (MS) in the absence of a costly headspace autosampler, and the chromatography separation was performed on a 60 m × 320 µm × 0.5 µm VF-WAXms GC column. Calibration curves have been provided using several concentrations of the alcohols, and also limit of detection (LOD), limit of quantification (LOQ), and relative standard deviation percentage (RSD%) have been determined.     

Magnetic Multi-Walled Carbon Nanotubes Matrix Solid-Phase Dispersion with Dispersive Liquid–Liquid Microextraction for the Determination of Ultra Trace Bisphenol A in Water Samples

Magnetic nanoparticle-assisted solid-phase dispersion (MMSPD) combined with dispersive liquid–liquid microextraction (DLLME) prior to high performance liquid chromatography with fluorescence detector (HPLC–FLU) is presented for determination of ultra trace Bisphenol A (BPA) in water. Magnetic multi-walled carbon nanotubes (MMWCNTs) were synthesized for the adsorption of BPA in water. Ultra trace BPA in water was transferred into the elute solvent by the MMSPD and further concentrated into trace volume extraction solvent by the DLLME. The limit of detection and limit of quantitation were 0.003 and 0.01 µg L^?1, respectively. Good linearity of BPA was found, ranging from 0.01 to 10 µg L^?1, with good squared regression coefficient (R ²) of 0.9999. Additionally, relative recoveries were 83.1 and 95.9% for two environmental water samples spiked with 0.20 µg L^?1 BPA, respectively. All results showed that the MMWCNTs nanoparticle-assisted MMSPD–DLLME–HPLC–FLU method was simple and reliable for the determination of ultra trace BPA in environmental water.     

Determination of Enantiomeric Purity of GSK962040 Based on Liquid Chromatography Using Chiral Stationary Phase Combined with a Pre-column Derivatization Procedure

A sensitive and accurate LC method was developed and further validated for the determination of enantiomeric purity of GSK962040. Before separation, a pre-column derivatization procedure was performed. Baseline separation with a resolution higher than 1.9 was accomplished within 15 min using a Chiralpak AD-H (250 × 4.6 mm; particle size 5 μm) column, with n-hexane: 2-propanol (85:15 v/v) as mobile phase at a flow rate of 1 mL min^?1. The eluted analytes were subsequently detected with a UV detector at 260 nm. The effects of mobile phase components and temperature on enantiomeric selectivity as well as resolution of enantiomers were thoroughly investigated. The calibration curves were plotted within the concentration range between 4 and 200 μg mL^?1 (n = 8), and recoveries between 98.15 and 101.48% were obtained, with relative standard deviation (RSD) lower than 1.42%. The LOD and LOQ for the Boc-GSK962040 were 1.23 and 4.15 μg mL^?1 and for its enantiomer were 1.38 and 4.76 μg mL^?1, respectively. The developed method was also evaluated and validated by analyzing bulk samples with different enantiomeric ratios of GSK962040. It was demonstrated that the method was accurate, robust and sensitive, and also had practical utilities for real analysis.     

Development of a Simple,Rapid, and Robust Isocratic Liquid Chromatographic Method for the Determination of Pyrimethamine and its Synthetic Impurities in Bulk Drugs and Pharmaceutical Formulations

Pyrimethamine is an important antiparasitic drug in the treatment of malaria and toxoplasmosis and is often used in combination with either sulfadoxine, sulfalene, or sulfadiazine. Determining the content of pyrimethamine and investigating the related substances is currently possible applying either a compendial monograph utilizing thin layer chromatography as well as liquid chromatographic methods used by the respective manufacturers. To provide a simple method which is capable of determining the content of pyrimethamine and of resolving four of its potential synthetic impurities a very simple, cheap, precise, and accurate isocratic RP-HPLC method was developed. All analytes can be separated within a total runtime of 30 min and the method was linear within the concentration ranges of 0.12–0.740, 0.104–0.621, 0.120–0.710, 2.0–11.8, and 1.01–5.80 µg mL^?1 for pyrimethamine, impurity A, impurity B, impurity C, and impurity D, respectively. These substances were separated by employing a Eurospher-II C₁₈H column (250 × 4.6 mm, 5 µm particle size), a mobile phase being a mixture of a 0.05 M KH₂PO₄ buffer solution (pH 2.6) and methanol in the ratio 40:60 (v/v). The analysis was carried out at 30 °C, applying a flow rate of 1.2 mL min^?1, and a detection wavelength of λ = 215 nm. The coefficients of determinations (R ²) for the five analytes were greater than 0.994 for pyrimethamine and all impurities. Results of recovery studies were within the range of 89.1–105.1% for all substances. In all tested genuine batches of pyrimethamine raw material impurities within the specified limits were present which is concurrent with results obtained from using the present manufacturer’s method.