Synthesis and nuclear magnetic resonance analysis of starch‐g‐poly(1,4‐dioxan‐2‐one) copolymers

A new biodegradable starch graft copolymer, starch‐g‐poly(1,4‐dioxan‐2‐one), was synthesized through the ring‐opening graft polymerization of 1,4‐dioxan‐2‐one onto a starch backbone. The grafting reactions were conducted with various 1,4‐dioxan‐2‐one/starch feed ratios to obtain starch‐g‐poly(1,4‐dioxan‐2‐one) copolymers with various poly(1,4‐dioxan‐2‐one) graft structures. The microstructure of starch‐g‐poly(1,4‐dioxan‐2‐one) was characterized in detail with one‐ and two‐dimensional NMR spectroscopy. The effect of the feed composition on the resulting microstructure of starch‐g‐poly(1,4‐dioxan‐2‐one) was investigated. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 3417–3422, 2004     

Hydroxyapatite coating on porous silicon substrate obtained by precipitation process

Hydroxyapatite Ca₁₀(PO₄)₆(OH)₂ (HAP) is known as a bioactive and biocompatible material, HAP coatings were used to improve the biocompatible of substrate by many researcher, In this work, HAP thin films on porous silicon (PS) substrates have been prepared by aqueous precipitation method with rapid thermal annealing (RTA) processes. The HAP films had been prepared under the annealing temperature ranging from 300 to 1000 °C. By the measurement of X-ray diffraction (XRD), it was found that for the crystallinity optimization, the heat-treatment at 850–950 °C for 1 h would be favorable. Atomic force microscopy (AFM) and scanning electron microscope (SEM) measurements reveal a dense and smooth surface of the HAP film, and tightly adherence of the coating on porous silicon substrate after sintered. Thus, by this method, porous silicon could be increased its bioactivity and so that could be used in the biomedical area.     

三十烷醇在GA_3影响水稻幼苗生长和生理性状中的增效作用

微量三十烷醇（ＴＲＩＡ）与ＧＡ３配合使用，比ＧＡ３单独使用能明显地促进幼苗生长和增加幼苗干物质积累．同时还增强了ＧＡ３对幼叶中叶绿素含量、可溶性蛋白质含量、呼吸速率、细胞膜透性和过氧化物酶活性的影响．ＧＡ３＋ＴＲＩＡ与ＧＡ３处理相比，促进幼叶内源ＧＡ３水平提高，稳定保持内源ＺＴ于一定水平，ＴＲＩＡ在ＧＡ３低浓度时降低ＩＡＡ水平，在高浓度时则提高ＩＡＡ水平．作者认为ＴＲＩＡ可作为ＧＡ３处理时的增效剂．     

飞秒激光脉冲在三能级有机分子介质中传播时的频谱分析

通过采用预估校正的时域有限差分法求解麦克斯韦-布洛赫方程,我们研究了飞秒激光脉冲在三能级有机分子(4,4-二甲氨基二苯乙烯分子)介质中传播时脉冲的频谱演化情况.在单光子共振情况下,即入射脉冲频率等于1、2能级之间的共振频率,对大面积入射脉冲,由于强的二次激发的作用,电场频谱中出现了在ω32附近振荡的频率成分,ω32是2、3能级之间的共振频率,说明对大面积入射脉冲二能级模型已经失效,需要采用多能级模型来描述分子介质.在双光子共振情况下,即入射脉冲频率等于1、3能级之间的共振频率的一半,由于介质中放大的自发辐射和四波混频的作用,部分入射脉冲能量转化为高频和低频电场成分的能量,分子介质表现出了很强的光功率限幅特性.     

Electro-optical performance of polymer stabilized cholesteric texture cell: The influence of chiral dopant and monomer concentration

Reverse-mode polymer stabilized cholesteric texture (PSCT) cells with various chiral dopant and monomer concentrations were fabricated. Experimental results indicate that the chiral dopant concentration and the monomer concentration significantly influence the threshold voltage and hysteresis of the cells. The chiral dopant and monomer deform the hysteresis loop. Increasing the monomer concentration reduces the width of the hysteresis loop of the reverse-mode PSCT cell.     

傅里叶变换红外光谱固体制样技术

通过对溴化钾与纳米固体超强酸样品的比例进行了探讨 ,得出制样时溴化钾与样品比例范围为1∶ 0 .0 0 1— 1∶ 0 .0 2 9,其最佳比例范围为 1∶ 0 .0 0 98— 1∶ 0 .0 1 5 ,并且应用于其他固体样品的测定 ,结果基本一致。同时得出 ,固体样品的最少检测量为 2 .0× 1 0 -5g     

基于三维矩阵重构争论有向图的域间路由振荡检测算法

边界网关协议(Border G atew ay P rotoco l,BGP)是当前In ternet域间路由协议的事实标准,基于策略的路由选择过程使它不再是严格意义上的距离矢量协议,也不再具有距离矢量协议的收敛性.V aradhan指出,自治系统各自为政的策略配置方式会导致全局策略冲突,引起永久性的路由振荡.针对该问题,G riffin利用稳定路径问题(S tab le Path P rob lem,SPP)模型形式化的抽象出BGP协议行为,并以此为基础提出了一种分布式的策略冲突检测算法,尽管该算法完全避免了传统方法的缺陷,但仍然存在泄漏策略信息和对BGP协议改动太大以及浪费网络资源的问题.本文提出了一种基于安全多方计算的检测路由策略冲突的方法,用于在怀疑BGP路由发生振荡时,动态的检测系统中是否存在策略冲突.该方法采纳了G riffin的理论基础,同时由于巧妙的运用了安全多方计算协议,可以完全解决G riffin算法的问题,具有很好的实用性.     

Synthesis of poly(p‐phenylene sulfide) from bis(4‐bromophenyl) disulfide

Improved reaction conditions for the preparation of poly(p‐phenylene sulfide) (PPS) directly from bis(4‐bromophenyl) disulfide (BBD) have been established. Heating BBD with magnesium metal afforded only a low molecular weight polymer. PPS with a melting temperature around 280 °C was obtained from BBD in the presence of sodium carbonate or zinc metal. The best results were obtained with the addition of a catalytic amount of KI to the zinc–BBD mixture. Polymers prepared by the above methods are semicrystalline and dissolve in 1‐chloronaphthalene and have properties comparable to commercial PPS. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 900–904, 2006     

Investigation of a liquid-liquid extraction system based on non-ionic surfactant-salt-H2O and mechanism of drug extraction

Based on the investigation of a non-ionic surfactant-salt-H₂O liquid-liquid extraction system, general rules concerning salt selection are concluded and the mechanism of phase separation is explained. The extraction behavior of chlorpromazine hydrochloride (CPZ) and procaine hydrochloride (PCN) in such a system is studied. Research shows that the extraction efficiency of CPZ can amount to 96% by twice extraction, which means that quantitative extraction is realized, while that of PCN is 77%. This system produces distribution coefficients (K_D) of 12.3 and 2.6, respectively, for CPZ and PCN. Extraction mechanism is deduced according to ultraviolet absorbance; and molecular fluorescence spectra change of the drugs in the system studied.     

FTIR和ESR法研究离聚体溶液中的离子相互作用

磺化乙丙三元共聚物(SEPDM)离聚体在二甲苯/5％正己醇混合溶剂中具有特异的粘浓关系和粘温关系,估计是由于金属离子被己醇溶剂化而影响离子间相互作用引起的,但尚未有更多的实验数据加以验证.本文用FTIR和ESR方法对SEPDM离聚体溶液作进一步考察,发现金属离子与己醇确实存在溶剂化效应,溶剂化程度与离子的大小、浓度和温度有关,它直接影响离子在溶液中存在的状态(单离子或离子聚集体),这些结果为从分子水平了解离聚体溶液性质提供了理论根据.用波谱方法研究离聚体溶液中的离子相互作用尚鲜见报道.