Simultaneous measurements of indoor radon and thoron and inhalation dose assessment in Douala City,Cameroon

ABSTRACT

Radon, thoron and associated progeny measurements have been carried out in 71 dwellings of Douala city, Cameroon. The radon–thoron discriminative detectors (RADUET) were used to estimate the radon and thoron concentration, while thoron progeny monitors measured equilibrium equivalent thoron concentration (EETC). Radon, thoron and thoron progeny concentrations vary from 31?±?1 to 436?±?12 Bq?m^–3, 4?±?7 to 246?±?5 Bq?m^–3, and 1.5?±?0.9 to 13.1?±?9.4 Bq?m^–3. The mean value of the equilibrium factor for thoron is estimated at 0.11?±?0.16. The annual effective dose due to exposure to indoor radon and progeny ranges from 0.6 to 9?mSv?a^–1 with an average value of 2.6?±?0.1?mSv?a^–1. The effective dose due to the exposure to thoron and progeny vary from 0.3 to 2.9?mSv?a^–1 with an average value of 1.0?±?0.4?mSv?a^–1. The contribution of thoron and its progeny to the total inhalation dose ranges from 7 to 60?% with an average value of 26?%; thus their contributions should not be neglected in the inhalation dose assessment.     

Anomalous optical transitions in AlInGaN/GaN heterostructures grown by metalorganic chemical vapor deposition

Using temperature-dependent photoluminescence (PL) measurements, we report a comprehensive study on optical transitions in Al_yIn_xGa_1−x−yN epilayer with target composition, x=0.01 and y=0.07 and varying epilayer thickness of 40, 65 and 100 nm. In these quaternary alloys, we have observed an anomalous PL temperature dependence such as an S-shape band-edge PL peak shift and a W-shape spectral broadening with an increase in temperature. With an increase in excitation power density, the emission peak from the AlInGaN epilayers shows a blue shift at 100 K and a substantial red shift at room temperature. This is attributed to the localization of excitons at the band-tail states at low temperature. Compared to 40 and 65 nm thick epilayers, the initial blue shift observed with low excitation power from 100 nm thick AlInGaN epilayer at room temperature is caused by the existence of deeper localized states due to confinement effects arising from higher In and Al incorporation. The subsequent red shift of the PL peak can be attributed by free motion of delocalized carriers that leads to bandgap renormalization by screening. Due to competing effects of exciton and free carrier recombination processes, such behavior of optical transitions leads to two different values of exponent ‘k’ in the fitting of PL emission intensity as a function of excitation power.     

Acylated mono-, bis- and tris- cinchona-based amines containing ferrocene or organic residues: synthesis, structure and in vitro antitumor activity on selected human cancer cell lines

A series of novel functionalized mono-, bis- and tris-(S)-{[(2S,4R,8R)-8-ethyl-quinuclidin-2-yl](6-methoxyquinolin-4-yl)}methanamines including ferrocene-containing derivatives was obtained by the reaction of the precursor amine with a variety of acylation agents. Their in vitro antitumor activity was investigated against human leukemia (HL-60), human neuroblastoma (SH-SY5Y), human hepatoma (HepG2) and human breast cancer (MCF-7) cells by the 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT)-assay and the 50% inhibitory concentration (IC(50)) values were determined. Our data indicate that the precursor amine has no antitumor activity in vitro, but the bis-methanamines with ureido-, thioureido and amide-type linkers display attractive in vitro cytotoxicity and cytostatic effects on HL-60, HepG2, MCF-7 and SH-SY5Y cells. Besides 1H- and 13C-NMR methods the structures of the new model compounds were also studied by DFT calculations.     

Swallow-tailed perylene derivative: a new tool for fluorescent imaging of lipid hydroperoxides

A swallow-tailed perylene derivative including a triphenylphosphine moiety was synthesized and applied to the detection and the live-cell imaging of lipid hydroperoxides. The novel probe, named Spy-LHP, reacted rapidly and quantitatively with lipid hydroperoxides to form the corresponding oxide, Spy-LHPOx, which emits extremely strong fluorescence (Phi approximately 1) in the visible range (lambda(em) = 535 nm, 574 nm). Spy-LHP was highly selective for lipid hydroperoxides, and the addition of other reactive oxygen species (ROS) including hydrogen peroxides, hydroxyl radical, superoxide anion, nitric oxide, peroxynitrite, and alkylperoxyl radical, caused no significant increase in the fluorescence intensity. The probe exhibited good localization to cellular membranes and was successfully applied to the confocal laser scanning microscopy (CLSM) imaging of lipid hydroperoxides in live J774A.1 cells, in which lipid peroxidation was proceeded by the stimulation of 2,2-azobis(2-amidinopropane)dihydrochloride (AAPH). These findings establish Spy-LHP as a promising new tool for investigating the physiology of lipid hydroperoxides.     

A fluorescent photochromic compound for labeling biomolecules

A fluorescent photochromic compound, composed of diarylethene, fluorescein and succinimidyl ester units, was developed for the controllable fluorescent labeling of biomolecules based on a small molecule.     

Sequential injection chemiluminescence immunoassay for nonionic surfactants by using magnetic microbeads

A rapid and sensitive immunoassay based on a sequential injection analysis (SIA) using magnetic microbeads for the determination of alkylphenol polyethoxylates (APnEOs) is described. An SIA system was constructed from a syringe pump, a switching valve, a flow-through type immunoreaction cell equipped with a photon counting unit and a neodymium magnet. Magnetic beads, to which an anti-APnEOs monoclonal antibody was immobilized, were used as a solid support in an immunoassay. The introduction, trapping and release of the magnetic beads in and from the immunoreaction cell were controlled by means of a neodymium magnet and adjusting the flow of a carrier solution. The immunoassay was based on an indirect competitive immunoreaction of an anti-APnEOs monoclonal antibody immobilized on the magnetic beads with a sample APnEOs and a horseradish peroxidase (HRP)-labeled APnEOs in the same sample solution, and was based on the subsequent chemiluminscence reaction of HRP on the magnetic microbeads with a luminol solution containing hydrogen peroxide and p-iodophenol. The anti-APnEOs antibody was immobilized on the magnetic microbeads by coupling the antibody with the magnetic beads after activation of a carboxylate moiety on the surface of the magnetic beads that had been coated with a polylactic acid film. The antibody immobilized magnetic beads were introduced in the immunoreaction cell and trapped in it by the neodymium magnet, which was equipped beneath the immunoreaction cell. An APnEOs sample solution containing the HRP-labeled APnEOs at a constant concentration, and a luminol solution containing hydrogen peroxide and p-iodophenol were sequentially introduced into the immunoreaction cell, according to an SIA programmed sequence. Chemiluminescence emission was monitored by means of a photon counting unit located at the upper side of the immunoreaction cell by collecting the emitted light with a lens. A typical sigmoidal calibration curve was obtained, when the logarithm of the concentration of APnEOs was plotted against the chemiluminescence intensity as the number of photons in 100 ms using standard APnEOs sample solutions at various concentrations (0–1000 ppb) under optimum conditions. The lower detection limit defined as IC₈₀ is ca 10 ppb. The time required for analysis is less than 15 min per a sample. The present method was successfully applied to the determination of APnEOs in river water.     

Year-long biophoton measurements: normalized frequency count analysis and seasonal dependency

Biophoton emissions from three healthy human subjects were measured for 52 weeks. The active nature of dorsal hands and personal discernable patterns in palmar hands were investigated through frequency count analysis of biophoton emission rates. Also, the seasonal dependency of biophoton emission rates from human hands was studied and we found that emission rates were lowest in autumn. There was a reversion of relative emission rates from the palms and the dorsa depending upon the season. The emission rates from the palms remain rather stable throughout the year, but those from the dorsa vary widely depending upon the season. These features of biophoton emission rates were considered in light of the diagnostic view of traditional Chinese medicine.     

A useful ring transformation route to novel thiazepino[7,6-b]indoles from monochloro-β-lactam-fused 1,3-thiazino[6,5-b]indoles,analogues of cyclobrassinin

The Staudinger ketene-imine cycloaddition reactions of cyclobrassinin phytoalexin analogues 2-aryl-4,9-dihydro-1,3-thiazino[6,5-b]indoles with chloroacetyl chloride as a ketene source were investigated under different conditions. Both β-lactam ring formation and the N-chloroacetylation of the indole moiety took place. The indole N-chloroacetyl group can be easily removed by treatment in the presence of silica gel in methanol at reflux temperature. The selective β-lactam formation can be also achieved in certain cases under milder Staudinger conditions. The treatment of azeto[2,1-b]thiazino[6,5-b]indole-1-one derivatives with sodium ethoxide in ethanol provided the novel thiazepino[7,6-b]indole ring systems in a one-step ring transformation. The structures of the new ring systems were determined by means of IR and NMR spectroscopy.     

Analysis of a bi-piezoelectric ceramic layer with an interfacial crack subjected to anti-plane shear and in-plane electric loading

The behaviour of a bi-piezoelectric ceramic layer with a centre interfacial crack subjected to anti-plane shear and in-plane electric loading has been studied. The dislocation density functions and the Fourier integral transform method have been employed to eliminate the problem of singular integral equations. The normalized energy release rate, stress and electrical displacement intensity factors, G/G₀,K_III/K_III0 and K_D/K_D0, respectively, were determined for different geometric and property parameters by use of two different crack surface electric boundary conditions, i.e. impermeable and permeable. It has been shown that the effects of the thickness and material constants of the piezoelectric layer on all the three parameters, i.e. G/G₀,K_III/K_III0 and K_D/K_D0 were significant.