The Calibrating Theory in the Network Parameters Measurement of Microwave and MMW Devices

The paper introduces a special system calibration technology in s-parameters measurement of microwave and millimeter wave devices. The 8-term errors module is built by analyzing the signals flowing in the measurement system. Then the calibration technology using non-standard kits is designed on the base. Finally, the experiment using the calibration technology is introduced.     

Molecular mobility in hydrogels based on poly(acrylic acid) and macrodiisocyanates

Partially water-swellable polymer networks were synthesized on the basis of poly(acrylic acid) and various macrodiisocyanates. Hydrophilic and hydrophobic local regions were revealed in swollen networks (hydrogels) by means of the spin probe technique. The local mobility in hydrophobic regions depends on the macrodiisocyanate structure; however, it is substantially lower than that in hydrophilic regions for all gels. It was assumed that the presence of hydrophobic and hydrophilic regions and the difference in their local dynamics must have a substantial effect on the pharmacokinetics of release of drugs immobilized in these hydrogels.     

Effects of annealing conditions on the electrical properties of Bi4-xNdxTi3O12 (x = 0.46) thin films processed at low temperature

Neodymium-substituted Bi₄Ti₃O₁₂ (BNdT) thin films were prepared by a chemical solution deposition technique on platinum- coated silicon substrates. All of the samples were annealed at the relatively low temperature of 600 °C by a rapid thermal annealing process in different atmospheres, such as O₂, air, and nitrogen, and vacuum. Irrespective of different annealing atmospheres, all of the BNdT thin films exhibit good ferroelectric properties, such as a saturated hysteresis loop, good fatigue endurance, and low leakage current density. A large remanent polarization (P_r) of ∼48 μC/cm² with an electric field of 240 kV/cm was observed from the BNdT thin film annealed in O₂ atmosphere. The BNdT thin films annealed in nitrogen and vacuum, at reduced oxygen partial pressures, exhibit smaller P_r than that annealed in oxygen. The difference of P_r of the BNdT thin films annealed in different atmospheres may originate from differences in the grain sizes and the number of oxygen vacancies. PACS 77.55.+f; 77.80.-e; 77.80.Fm; 81.15.-z     

Roles of SiH4 and SiF4 in growth and structural changes of poly-Si films

The structural properties of polycrystalline silicon films, prepared by plasma enhanced chemical vapor deposition system, with different flow rates of SiH₄/SiF₄ mixtures at 300 °C were investigated. This study indicates that the low hydrogen coverage on the growing surface, under optimum fluorine radicals, will be leaded to an improvement of crystallized area as compared with case of high hydrogen coverage surface. Moreover, the studies of the role of SiH₄ and SiF₄ radicals show that the SiH₄ radicals are important in the nucleation and growth of grains. However, SiF₄ radicals are effective in the structural change of grain boundaries regions and by this way, in the present system, establish the growth of grains under the dominant 〈1 1 0〉 direction. The stress investigation indicates that addition of high flow rate of SiF₄ in amorphous film, results in the nearly stress free films. Finally, we found that the changes in g-value reflect the changes in the intrinsic compressive and tensile stress in the both polycrystalline and amorphous silicon films.     

Application of rainbow schlieren deflectometry to measure temperature and oxygen concentration in a laminar gas-jet diffusion flame

The quantitative rainbow schlieren deflectometry (RSD) technique was applied to measure temperature and oxygen concentration in an axisymmetric hydrogen gas-jet diffusion flame burning in quiescent air at fuel jet exit Reynolds number of 70. Schlieren measurements were compared with conventional measurements using a thermocouple and a gas-sampling probe. Good agreement between the two measurement techniques was achieved on the fuel-lean side of the flame.     

Flow regime identification in a two-phase flow using wavelet transform

This study addresses the problem of the automatic flow regime identification in two-phase flows in pipes. A novel wavelet transform-based approach is proposed and validated using time series of differential pressure fluctuations. The experimental data on the differential pressure measured in a vertically installed Venturi meter for air-water flow were analyzed and found to be appropriate for flow regime identification. The wavelet spectrum of the measured signal is shown to characterize the flow patterns completely, and the vector of the wavelet variances is proposed as the characteristic vector for use in an on-line flow regime identification system.     

Cytotoxic acetylenes from Panax quinquefolium

Three new cytotoxic polyacetylenes, PQ-1 (1), PQ-2 (2) and PQ-3 (3), have been isolated from Panax quinquefolium. The structures of these acetylenes were determined by analyses of their 1H-1H and 1H-13C COSY spectra. All these compounds exhibited strong cytotoxic activities against leukemia cells (L 1210) in tissue culture.     

Quantum General Relativity,Torsion and Uncertainty Relations

It is shown that in gravitational theories with torsion one is led to commutation rules corresponding to Landau-Peierls type uncertainty relations.     

A Recursive Algorithm for Order Cycle-time that Minimizes Logistics Cost

A firm's logistics cost, including shipping and inventory-carrying, is a substantial percentage of its sales. Nevertheless, typical inventory-control methods ignore or insufficiently represent the shipping cost. This paper describes a recursive algorithm that determines the reorder cycle-time that minimizes total logistics cost. It allows for a realistic accounting of shipping cost, which is modelled here as a function of shipping distance and weight. The algorithm uses a relaxation procedure to identify a suitable initial approximation to the optimal order cycle-time and then, through a series of recursive steps, moves to the optimal result. We demonstrate the algorithm with a single item, with a group of items that share a common order cycle, and with multi-items when item demands are random variables. Experience with this algorithm indicates that it converges to the optimal result in a very few steps.