Investigations into the Pd-catalysed cross-coupling of phenylacetylene with aryl chlorides: simple one-pot procedure and the effect of ZnCl2 co-catalysis

[PdCl(C6H3(OPPri2)2-2,6)] 1 catalyses the coupling of electron-rich, electron-neutral and electron-deficient aryl chlorides with phenylacetylene in the presence of ZnCl2 as cocatalyst to give the products in modest to excellent yields.     

110K铋基超导相形成的组成条件

Bi-Sr-Ca-Cu-O超导材料中存在110K和80K2个超导相。其组成是Bi_2Sr_2Ca_2Cu_3O_y和Bi_2Sr_2CaCu_2O。但迄今为止,在按2223组成比合成的未掺杂Bi系超导材料中从未得到过纯的110K相,也未见过组成为2223,零电阻温度在100K以上材料的报道。为了探索形成110K相的最佳条件,本文以2223组成比为参考,合成了5个系列材料:Bi_xSr_2Ca_2Cu_3O_y,Bi_2Sr_xCa_2Cu_3O_y,Bi_2Sr_2Ca_xCu_3O_y,Bi_2Sr_2Ca_2Cu_xO_y,Bi_i Sr_uCa_yCu_wO_s。     

Ultraviolet protection factors for clothing: an intercomparison of measurement systems

In recent years the need to standardize measurement protocols for quantifying the degree of ultraviolet radiation (UVR) protection provided by clothing has led to the introduction of a number of standards around the world. To date, these standards have specified spectral measurements of UVR transmission by clothing and fabrics. Development of a standard test method has become an important part of the testing process, and this article presents results from an intercomparison involving 10 independent testing laboratories and 11 different UVR transmission measurement instruments. In addition to comparing the measured ultraviolet protection factors (UPF), this intercomparison also incorporates detailed scan results from all 10 laboratories and highlights differences in performance of the various instruments in different wavelength regions. Careful examination of these differences can indicate where changes to the systems could be made to allow improvements both in equipment performance and in agreement of the final results. The variability in the measurements of UPF in this study suggest that the protection categories in standards may need to be broadened.     

Fluordiazadiphosphetidine, 3. Mitt.: Die thermische Behandlung von 2,2,2,4,4,4-Hexafluoro-1,3-dimethyl-1,3,2,4-diazadiphosphetidin unter Druck in Gegenwart von Phosphor(V)fluorid und Alkalimetallfluoriden

Prolonged heating of (CH₃NPF₃)₂ in a sealed tube at 120°C yields (CH₃N)₄P₃F₇ and PF₅. Under the experimental conditions these compounds react to (CH₃N)₄P₃F₆ ⁺PF₆ ^–. Reaction of (CH₃NPF₃)₂ in the presence of PF₅ leads to a marked decrease in the formation of the ionic compound. The influence of the fluoride donating saltsMF (M=Li, Na, K, Cs) is investigated.

---

---

Mit 1 Abbildung

---

Früher: Alkyliminophosphorsäuretrihalogenide, 1. und 2. Mitt.     

Krümmungskennzeichnung der Ketten einer allgemeinen Geometrie Σ(ℜ,\mathfrak{L})

Lie theory renders a concept of curvature for the geometries (,) introduced by W. Benz [1]. Among regular curves in the chains of (, ) are characterized by =0.     

Über die Darstellung von Arsendichloridtrifluorid,AsCl2F3

On the Preparation of Arsenic Dichloride Trifluoride, AsCl₂F₃ AsCl₂F₃ is prepared by pyrolysis of [AsCl₄]⁺ [AsF₆]^?. The vibrational spectra of the new low temperature compound are reported and the valence force constants are calculated. The formation of AsCl₂F₃ by ligand exchange reactions is discussed.     

Electrochemical oxidation of 9-methylxanthine

The electrochemical oxidation of 9-methylxanthine proceeds via four voltammetric oxidation peaks at the pyrolytic graphite electrode. The first voltammetric oxidation peak (peak I_a) is a 1e reaction giving a radical which dimerizes to 8,8′-bi-9-methyl-9H-purine-2,6-(1H, 3H)-dione. Peak II_a is a further 2e electrooxidation of the peak I_a dimer to another yellow dimer 8,8′-bi-9-methyl-9H-purine-2,6-(1H)-dione-3,5-(3H)-diiminylidene. This dimer is not very stable and it hydrolyzes to 1-methyl allantoin. Peak III_a is an adsorption pre-peak to peak IV_a which corresponds, overall, to a direct 4e?4H⁺ electrooxidation of 9-methylxanthine to an unstable diimine of 9-methyluric acid. Hydrolysis of this diimine leads to a variety of ultimate products.     

Characterization of CuO supported on tetragonal ZrO2 catalysts for N2O decomposition to N2

A series of tetragonal zirconia-supported CuO oxide catalysts with various CuO loadings were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), electron spin resonance (ESR), ultraviolet and visible diffuse reflectance spectroscopy (UV/vis-DRS), and temperature-programmed reduction (TPR) measurements. The results indicate that the dispersion capacity of copper oxide on this support is approximately 8.6 Cu(2+) ions/nm(2) ZrO(2). The state of the resulting supported copper species depends on the CuO loading. At CuO loadings below the dispersion capacity, only highly dispersed copper ion species are present on the surface of t-ZrO(2). In particular, isolated Cu ions are the predominant species at low loadings. In contrast, pair Cu ions become the most abundant species at loadings near the dispersion capacity. It has been proposed that these dispersed CuO (isolated and paired Cu ions) have a symmetric 5-fold-oxygen-coordination symmetry (C(3)(v) symmetry) and can be described as distorted octahedra with a missing corner or a trigonal bipyramids. Finally, at CuO loadings above the dispersion capacity the formation of crystalline CuO is observed. TPR results reveal that the dispersed Cu ion species have a different reducibility from CuO crystallites, presumably due to strong interactions between these species and the t-ZrO(2) support. The catalytic activity of these CuO/t-ZrO(2) catalysts for the decomposition of N(2)O can also be directly correlated to CuO dispersion, with paired Cu ions being the most active species for this reaction.     

A general mass spectrometry-based assay for the quantitation of protein-ligand binding interactions in solution

A new method that utilizes matrix-assisted laser desorption/ionization (MALDI) mass spectrometry and exploits the hydrogen/deuterium (H/D) exchange properties of proteins was developed for measuring the thermodynamic properties of protein-ligand complexes in solution. Dissociation constants (Kd values) determined by the method for five model protein-ligand complexes that included those with small molecules, nucleic acids, peptides, and other proteins were generally in good agreement with Kd values measured by conventional methods. Important experimental advantages of the described method over existing methods include: the ability to make measurements in a high-throughput and automated fashion, the ability to make measurements using only picomole quantitities of protein, and the ability to analyze either purified or unpurified protein-ligand complexes.