Effect of alkylated diphenylamine on thermal-oxidative degradation behavior of poly-<Emphasis Type="Italic">α</Emphasis>-olefin

An oil-soluble antioxidant, alkylated diphenylamine (ADPA), was prepared by alkylation of diphenylamine. The influence of ADPA on the thermal-oxidative stability of poly-α-olefin (PAO8) was evaluated by thermogravimetry (TG). For comparison, the thermal-oxidative stability of PAO8 with zinc dialkyl dithiophosphate (ZDDP) was also investigated. Activation energy (E_a)of the corresponding thermal-oxidative degradation process was evaluated by the Flynn-Wall-Ozawa (FWO) and Kissinger-Akahira-Sunose (KAS) methods. To demonstrate the reliability of the kinetic study, the antioxidant performance of ADPA and ZDDP in PAO8 was also studied by the pressure drop (PDT) and accelerated oxidation (AOT) tests. The results indicate that ADPA has better antioxidant ability than ZDDP in increasing the E_a value and enhancing the oxidative stability of PAO8. Good correlation between the applied test methods was established.     

Density of lithium fluoride—lithium carbonate-based molten salts

The density of the LiF-Li₂CO₃ melts system was measured using the Archimedean method. Using the quadratic regression orthogonal design with two factors, a regression equation for the density of LiF-Li₂CO₃ melts was obtained in which the concentration of LiF and temperature were considered. The results indicated that the density of the LiF-Li₂CO₃ melts decreased with either increasing the concentration of LiF or increasing temperature; a linear relation was observed between density and temperature. In addition, the influences of NaF, KF, NaCl, and KCl additives on the densities of the given systems were studied. The addition of NaF and KF increased the density of the melts, whereas NaCl and KCl resulted in an initial increase and subsequent decrease with an increasing additive concentration. The density attained a maximum at NaCl and KCl mass fraction of approximately 15%.     

Efficient method for the synthesis of polysubstituted 2,6-dicyanoanilines by one-pot three-component tandem reaction of malononitrile with <Emphasis Type="Italic">α</Emphasis>,<Emphasis Type="Italic">β</Emphasis>-unsaturated imines

A facile and efficient one-pot synthesis of polysubstituted benzenes was achieved via the Michael addition of malononitrile with α,β-unsaturated imines and a sequential tandem reaction. This reaction generates polysubstituted 2,6-dicyanoanilines in high yields (15 examples, isolated yields of 57–91 %), and proceeds under mild reaction conditions (60°C, 10 min). In addition, a possible mechanism accounting for the reaction is proposed.     

Flammability characterization and effects of magnesium oxide in halogen-free flame-retardant EVA blends

The effects of magnesium oxide(Mg O) on the flame retardant performance of intumescent systems based on ammonium polyphosphate(APP) and pentaerythritol(PER) in ethylene vinyl acetate copolymer(EVA) were studied. The results showed that Mg O affects both the quality and quantity of residual char. There is an optimal value for the loading amount of Mg O. More or less Mg O loading may cause the formation of defective char layers and worsen the flame retardancy of EVA. According to the results of limiting oxygen index(LOI), vertical flammability test(UL94 rating) and cone calorimetry(CONE), the best flame retardancy with a strong and well intumescent char is obtained from the sample with 1 wt% of Mg O, which has the highest LOI value of 27.9, UL94 rating of V-0 and the lowest peak heat release rate of 242 k W·m?2.     

The significance of a second adsorption phase with weakly adsorbed species for the calculation of the surface concentrations of a mixture: methanol–DME and methanol–ethene adsorption in SAPO-34

With the calorimetric (adsorption heat versus coverage) curve also measured together with the adsorption isotherm, the simultaneous use of both curves showed that there were two phases of adsorption in the adsorption of methanol, dimethyl ether, ethene and propane in SAPO-34. The dual-site Langmuir equation gave good fits to the adsorption data to support the interpretation that a second (type 2) adsorption phase occurred in the high-pressure region in addition to a first (type 1) adsorption phase on the acid sites at lower pressures. Adsorption experiments and calculations using binary gas mixtures showed that due to the existence of two types of adsorption, the multicomponent Langmuir isotherm equation (Langmuir competitive adsorption model) calculated incorrect surface concentrations when the concentrations were high. In contrast, the ideal adsorbed solution theory (IAST) calculated correct surface concentrations in the adsorption of mixtures.     

Lewis Acid Promoted Ruthenium(II)‐Catalyzed Etherifications by Selective Hydrogenation of Carboxylic Acids/Esters

Ethers are of fundamental importance in organic chemistry and they are an integral part of valuable flavors, fragrances, and numerous bioactive compounds. In general, the reduction of esters constitutes the most straightforward preparation of ethers. Unfortunately, this transformation requires large amounts of metal hydrides. Presented herein is a bifunctional catalyst system, consisting of Ru/phosphine complex and aluminum triflate, which allows selective synthesis of ethers by hydrogenation of esters or carboxylic acids. Different lactones were reduced in good yields to the desired products. Even challenging aromatic and aliphatic esters were reduced to the desired products. Notably, the in situ formed catalyst can be reused several times without any significant loss of activity.     

Isomerization of Secondary Phosphirane into Terminal Phosphinidene Complexes: An Analogy between Monovalent Phosphorus and Transition Metals

Secondary phosphirane complexes isomerize above 100 °C to give the corresponding terminal phosphinidene complexes, which can be trapped by alkenes and alkynes. This reaction is a rare instance of the isomerization of a P^III derivative into a P^I derivative. It appears to mimic the reductive elimination of alkanes from transition‐alkylmetal hydrides.     

Stable Encapsulated Air Nanobubbles in Water

The dispersion into water of nanocapsules bearing a highly hydrophobic fluorinated internal lining yielded encapsulated air nanobubbles. These bubbles, like their micrometer‐sized counterparts (microbubbles), effectively reflected ultrasound. More importantly, the nanobubbles survived under ultrasonication 100‐times longer than a commercial microbubble sample that is currently in clinical use. We justify this unprecedented stability theoretically. These nanobubbles, owing to their small size and potential ability to permeate the capillary networks of tissues, may expand the applications of microbubbles in diagnostic ultrasonography and find new applications in ultrasound‐regulated drug delivery.