叶绿素A较高激发态的发光

采用激发样品表层和样品中心两种激发方式,在300K和77K温度下研究叶绿素A(Chla)的较高激发行为,观测到峰值位于493、520和580nm三条新的荧光发射带.分别测量它们的荧光激发光谱,证明这三条新的荧光带属于Chla的第二激发单线态向基态的不同振动能级的辐射跃迁发光.最后提出电子跃迁模型,同时进行了讨论.     

Four-wave mixing based 10-Gb/s tunable wavelength conversion in dispersion-flattened microstructure fibers

All-optical wavelength conversion of 10-Gb/s signal based on four-wave mixing is experimentally demonstrated in a 30-m-long dispersion-flattened microstructure fiber with small positive dispersion. For an average pump power of 26 dBm, the conversion efficiency was around -19.5 dB with the fluctuation less than ±1.4 dB, covering a conversion bandwidth of 20 nm. The eye diagram of the converted signal shows good eye opening.     

Growth and optical properties of a new self-Q-switched laser crystal: Cr:Yb3Al5O12

Cr⁴⁺:YbAG (Cr⁴⁺:Yb₃Al₅O₁₂) crystal with a size up to Φ24 mm×30 mm was grown by the Czochralski method. In the absorption spectrum, there are two absorption bands at 939 and 969 nm, respectively, which are suitable for InGaAs diode laser pumping, and there is an absorption band at 1030 nm, which is suitable for passive Q-switched laser output at 1.03 μm. A broad emission spectrum from 970 to 1100 nm was exhibited from 940 nm wavelength pumping. This crystal is promising as a self-Q-switched laser crystal used for compact, efficient, highly stable, passive self-Q-switched thin chip solid-state lasers.     

Sensitive monitoring of humic acid in various aquatic environments with acidic cerium chemiluminescence detection.

In this research, a simple, sensitive chemiluminescence (CL) method for the determination of humic acid (HA) in water samples was first developed based on the redox reaction between humic acid and cerium(IV) in the acidic condition. Different with the former redox CL reaction which occurred in alkaline solution, no enhancers were needed and neither precipitation nor a second contamination would occur in the present CL system. Comparing with other spectrometric methods, we find that the proposed analysis system had better applicability and accuracy. Under the optimal experiment conditions, the CL peak height was linear with the concentration of HA in the range of 0.03 to 10.0 microg mL(-1). The detection limit is 0.01 microg mL(-1) (S/N = 3), and the relative standard deviation was 2.3% for 0.5 microg mL(-1) HA solution with eleven repeated measurements. The present CL method was successfully applied to the determination of HA in tap water, spring water and river water samples with good recovery from 90.0 to 110.0%. A possible CL mechanism was proposed based on the results of UV and fluorescence spectrometry and the CL spectrum of HA. It was speculated that the semi-quinone radicals in the excited state were the emitters.     

A Note on the Kissing Numbers of Superballs

The lower bounds for the translative kissing numbers of superballs are studied in this note. We improve the bound given by Larman and Zong. Furthermore, we give a constructive bound based on algebraic-geometry codes that also improves the bound by Larman and Zong in almost all cases.     

On the persistence of elliptic lower-dimensional tori in Hamiltonian systems under the first Melnikov condition and Rüssmann’s non-degeneracy condition

In this paper we formulate a theorem on the persistence of elliptic lower-dimensional invariant tori for nearly integrable analytic Hamiltonian systems under the first Melnikov condition and Rüssmann’s non-degeneracy condition, and give the measure estimates of parameters for the non-resonance conditions under Rüssmann’s non-degeneracy condition, which is essential for the proof of our result.     

Solvothermal synthesis of TiO2: anatase nanocrystals and rutile nanofibres from TiCl4 in acetone

This work reports a new synthetic approach for single‐phase TiO₂ nanomaterials by solvothermal treatment of titanium tetrachloride in acetone at 80–110 °C. Small, uniform, and yet size‐tunable (5–10 nm) anatase titania nanocrystallites were obtained using a low concentration of TiCl₄ in acetone (i.e., at molar ratios of TiCl₄/acetone ≤ 1:15) in the temperature range of 80–110 °C, while rutile nanofibers were synthesized using a high concentration of TiCl₄ (e.g., TiCl₄/acetone = 1:10) at 110 °C. Copyright © 2007 John Wiley & Sons, Ltd.     

Hydrothermal synthesis of FeS2 for lithium batteries

Nanocrystalline FeS₂ cathode material of lithium cell was synthesized from cheap materials of FeSO₄, Na₂S₂O₃, and sulfur by a hydrothermal process. The scanning electron microscopy analysis showed the obtained material was nano-sized, about 500 nm. The X-ray powder diffraction analysis showed that the synthetic FeS₂ material had two phases of the crystalline structure, pyrite and marcasite. The phase of marcasite seems to have no negative effect on the electrochemical performance of the material. The synthetic FeS₂ showed a significant improvement of electrochemical performance for Li/FeS₂ cells.     

A side-coupled photonic crystal filter with sidelobe suppression

This paper presents the theoretical model and the optimization method to suppress the sidelobes of side-coupled photonic crystal filters. Numerical verification shows a good agreement between the theoretical method and the finite-difference time-domain simulation, but the theoretic method does not involve the time-consuming computation. The theoretical method also presents a better physical image for choosing the critical parameters, such as the quality factor, phase shift and the number of resonators. Based on the theoretical model, two optimization methods (chirp and cascading) are proposed to deeply suppress the sidelobes. They also show more flexibility in controlling the bandwidth and steepness of the roll-off in the filter. PACS 42.70.Qs