石墨烯纳米带电极区N掺杂电子输运性质研究

运用密度泛函理论和非平衡格林函数结合的方法,研究电极区N掺杂对扶手椅型石墨烯纳米带电子输运特性的影响.结果表明,与本征扶手椅型石墨烯纳米带电流-电压曲线相比,宽度为7的石墨烯纳米带电流-电压曲线表现出明显的不对称性,其中心N掺杂表现强烈的整流特性,整流系数达到102数量级,且将N原子从电极区中心位置移动到边缘,整流特性减弱.研究结果表明宽度为7的扶手椅型石墨烯纳米带出现强整流现象的原因主要是负向偏压下能量窗内没有透射峰引起的,该研究结果对将来石墨烯整流器件的设计具有重要的意义.     

Asymmetric nonlinear-mode-conversion in an optical waveguide withPT symmetry

Asymmetric mode transformation in waveguide is of great significance for on-chip integrated devices with one-way effect, while it is challenging to achieve asymmetric nonlinear-mode-conversion (NMC) due to the limitations imposed by phase-matching. In this work, we theoretically proposed a new scheme for realizing asymmetric NMC by combining frequency-doubling process and periodic PT symmetric modulation in an optical waveguide. By engineering the one-way momentum from PT symmetric modulation, we have demonstrated the unidirectional conversion from pump to second harmonic with desired guided modes. Our findings offer new opportunities for manipulating nonlinear optical fields with PT symmetry, which could further boost more exploration on on-chip nonlinear devices assisted by non-Hermitian optics.     

Defect-induced failure of optical coating filters

Optical filters composed of Ag, Al₂O₃, and ZnSe films were prepared on BK7 substrates by evaporation. By employing spectrophotometer, microscope, scanning electron microscope (SEM), and energy dispersive spectrum (EDS) analysis, the moisture-dependent stability of the samples was tested. The experimental results revealed that filter failure often occurs initially at defect sites. Small sputtering particles and pinhole are found to be two types of defects that induced the optical coating filter failure. The mechanisms of the defect-induced failure of the filters also are discussed in the article.     

微纳光纤布拉格光栅折射率传感特性研究

利用光纤布拉格光栅方程和光纤基模有效折射率随纤芯半径和环境折射率的函数关系, 建立了微纳光纤布拉格光栅(MNFBG)反射波长随环境折射率变化的数学模型, 给出了波长灵敏度函数, 并指出MNFBG反射波长的变化规律决定于有效折射率随纤芯半径和环境折射率变化的关系. 详细探究了有效折射率及其灵敏度的变化规律, 结果表明: 有效折射率随纤芯半径和环境折射率的减小而非线性减小, 其对环境折射率变化的灵敏度随环境折射率的增大而非线性增加, 而且随纤芯半径减小, 有效折射率的灵敏度、线性度以及线性响应范围均呈递增规律. 通过对纤芯半径为0.5 μm的MNFBG在1.20–1.30和1.33–1.43 环境折射率范围内的波长响应关系拟合, 分别获得了477.33 nm/RIU和856.30 nm/RIU的波长灵敏度以及99.58 %和99.7%的高线性度, 论证了分析结论以及折射率区间划分测量方案的正确性, 为MNFBG折射率传感器的设计、优化以及应用提供了参考依据. 关键词： 微纳光纤 光纤布拉格光栅 折射率传感 数值模拟     

Dynamical measurements on viscoelastic behaviors of spiders in electro-dynamic loudspeakers

Spiders in electro-dynamic loudspeakers are most commonly concentrically corrugated fabric disks, and their viscoelastic behaviors affect the loudspeaker reproductions. A noncontact dynamic measuring technology is presented by a subwoofer closed box to excite the tested spiders pneumatically with a Laser Doppler Vibrometer (LDV) to measure the velocity of the moving spiders. Correlation techniques were employed to get an accurate and reliable acoustical transfer function between the measured velocity and sound pressure. The Young’s moduli of the tested spider composite materials were derived from the measured vibration modes. The creep effect and the level dependent behaviors of tested spiders were investigated. The results indicate that, the Young’s moduli of the tested spiders are frequency dependent. The mechanical stiffness increases with a small slope in low frequency range while a large slope in high frequency range. The loss factor exhibits the maximum around the resonance frequency, and after that it decreases with increasing frequency. The effective stiffness has a monotonic decrease with input voltage levels and the harder the spider, the less stiffness changes with input levels.     

环境扫描电镜及其应用

叙述了环境扫描电镜（ＥＳＥＭ）的成像原理———电子信号气体放大原理及其与常规扫描电镜（ＳＥＭ）的区别，介绍了我国第一台带高温台的ＥＳＥＭ．综述了近年来国外学者应用ＥＳＥＭ开展的一些研究工作．介绍了中国科学院化工冶金研究所应用ＫＹＫＹ１５００型ＥＳＥＭ对金属表面氧化反应中晶须／晶粒生长过程的研究     

求解定常不可压Stokes方程的两层罚函数方法

借助于两套有限元网格空间提出了一种求解定常不可压Stokes方程的两层罚函数方法.该方法只需要求解粗网格空间上的Stokes方程和细网格空间上的两个易于求解的罚参数方程（离散后的线性方程组具有相同的对称正定系数矩阵）.收敛性分析表明粗网格空间相对于细网格空间可以选择很小，并且罚参数的选取只与粗网格步长和问题的正则性有关.因此罚参数不必选择很小仍能够得到最优解.最后通过数值算例验证了上述理论结果，并且数值对比可知两层罚函数方法对于求解定常不可压Stokes方程具有很好的效果.     

Highly sensitive bend sensor with hybrid long-period and tilted fiber Bragg grating

We demonstrate a new type of fiber optic bend sensor with a hybrid structure made up of a long period grating (LPG) and a tilted fiber Bragg grating (TFBG). The sensing mechanism is based on the spectrum of power transfers between the core and cladding modes from a TFBG located downstream from a LPG. We show that the curvature of a beam can be determined by the reflected power difference between the core mode and the recoupled cladding modes. We further provide design rules for the LPG and TFBG to optimize and linearize the sensor response. In addition, the temperature cross-sensitivities of this configuration are also investigated for two different types of fiber.     

Highly improved crystallization behavior of poly(L‐lactide) induced by a novel nucleating agent: substituted‐aryl phosphate salts

In this work, a novel nucleating agent (NA) based on substituted‐aryl phosphate salts was introduced into poly(L‐Lactide) (PLLA). The nonisothermal and isothermal crystallization behaviors of nucleated PLLA samples were investigated through differential scanning calorimetry (DSC), wide angle X‐ray diffraction, and polarized optical microscope (POM). Furthermore, the effect of annealing treatment on the cold crystallization behaviors of nucleated samples was also investigated. The results show that the crystallization of PLLA, whether for the melt crystallization (including nonisothermal and isothermal crystallization process) or for the cold crystallization (including the cold crystallization occurring during the DSC heating process and during the annealing process), is greatly dependent upon the content of NA. At relatively lower NA content (≤0.1 wt%), the nucleation effect of NA is inconspicuous, however, at higher NA content (≥0.2 wt%), it exhibits great nucleation effect for the crystallization of PLLA. Further results show that the double endothermic peak of PLLA depends on the temperature applied for the crystallization. Copyright © 2012 John Wiley & Sons, Ltd.