Ultraviolet photochemistry of ethane: implications for the atmospheric chemistry of the gas giants

Chemical processing in the stratospheres of the gas giants is driven by incident vacuum ultraviolet (VUV) light. Ethane is an important constituent in the atmospheres of the gas giants in our solar system. The present work describes translational spectroscopy studies of the VUV photochemistry of ethane using tuneable radiation in the wavelength range 112 ≤ λ ≤ 126 nm from a free electron laser and event-triggered, fast-framing, multi-mass imaging detection methods. Contributions from at least five primary photofragmentation pathways yielding CH₂, CH₃ and/or H atom products are demonstrated and interpreted in terms of unimolecular decay following rapid non-adiabatic coupling to the ground state potential energy surface. These data serve to highlight parallels with methane photochemistry and limitations in contemporary models of the photoinduced stratospheric chemistry of the gas giants. The work identifies additional photochemical reactions that require incorporation into next generation extraterrestrial atmospheric chemistry models which should help rationalise hitherto unexplained aspects of the atmospheric ethane/acetylene ratios revealed by the Cassini–Huygens fly-by of Jupiter.

The vacuum ultraviolet photodissociation dynamics of ethane provide clues for modelling the atmospheric chemistry of the gas giants.     

Special Mixing Behavior of Chelate-based Ionic Liquid with Methanol

Compared to the general ionic liquids (ILs), a significant deviation of the binary mixtures of 1-decyl-3-methylimidazolium tri(hexafluoroacetylaceto)-copper(II) ([C₁₀mim][Cu(hfacac)₃]) with methanol was found, indicating the way methanol interacts with ILs might be governed by the special structure of the chelating anion. IR results showed that the (C2-H) of 1-decyl-3-methylimidazolium hexafluoroacetylacetonate ([C₁₀mim][hfacac]) blue-shifted more significantly than that of [C₁₀mim][Cu(hfacac)₃], meanwhile the (C=O) red-shifted in [C₁₀mim][Cu(hfacac)₃], which is contrast with that in [C₁₀mim][hfacac]. Two-dimensional correlation analysis of the FTIR spectra indicated that the chelating cavity has little effect on the sequence of the ILs sites that interact with methanol. Combined with small angle X-ray scattering (SAXS) results, the picture of mixing processes in these two systems were proposed. Methanol interacts directly with the anion followed by the cation in [C₁₀mim][hfacac], while methanol preferentially enters the chelating cavity and enhances the packing effect in the [C₁₀mim][Cu(hfacac)₃] system.     

Gas-phase spectroscopy of the unstable sulfur diisocyanate molecule S(NCO)2.

Sulfur diisocyanate is generated from a heterogeneous reaction of gaseous sulfur dichloride with silver cyanate and studied for the first time in the gas phase. Combined with quantum chemical calculations, the electronic structure is characterized by photoelectron spectroscopy (PES). Simultaneously, an investigation of the possible ionization and dissociation processes for the molecular cation is presented based on experimental soft ionization mass spectrometry. From the calculated bond-dissociation energies, the dissociation pathway is determined. S(NCO)2+ undergoes 1,3-sigmatropic rearrangement with a smaller barrier height (9.9 kcal mol(-1)) than the neutral counterpart. Thus, the 1,3-sigmatropic rearrangement is preferred for the molecular cation, and OCNCO+ and NS+ is produced by subsequent dissociation of the rearrangement product. The analysis agrees very well with the experimental mass spectrum.     

Pressurized gradient capillary electrochromatographic separation of eighteen amino acid derivatives

A pressurized gradient capillary electrochromatography (pCEC) instrument was developed to separate 18 amino acid derivatives. A reversed-phase C18 column (3 microm, 130 mm x 75 microm I.D.) and an acetate buffer (50 mmol/l NaAc, pH 6.4) with an ion-pair reagent (1% N,N-dimethylformamide) were used to separate derivatized amino acids from a standard solution (2 microg/ml), and the wavelength of the UV-Vis detector was 360 nm. The pressure on the capillary column was kept at approx. 70 Pa and 3 kV positive voltage was added on the outlet end of column. The effect of voltage on the eluting order of amino acids and the resolution of separation were studied, and it was found that when the voltage was higher than 3 kV, the adsorption of amino acids in the porous C18 column occurred. The effect of salt concentration, injection volume, and column length on the separation of amino acids was determined. The amino acid sample was separated by pCEC, and RSDs of the migration times of each amino acid were all less than 2.5%.     

Differential pulse voltammetric determination of arsenic(III,V) and antimony (III,V) in glasses

Summary Analytical methods based on differential pulse voltammetry (DPV) have been described for the determination of total As, As(III), As(V), total Sb and Sb(III) as trace to minor constituents in complex glasses. For total As, the sample is decomposed with HF-H₂SO₄-KMnO₄. The As(V) is chemically reduced to As (III) by hypophosphite and a DPV scan is carried out at the dropping mercury electrode from –0.2 to –0.7 Vvs. SCE (E _p –0.41V). As(V) is determined by decomposing the sample in HF-H₂SO₄ and volatilizing the As(III) as AsF₃. The chemical reduction of As(V) and the DPV scan are then applied. If the glass can be decomposed with cold HF, the As(III) present in the glass can be determined by applying the DPV scan after cold sample-dissolution. For Sb(III), the sample is decomposed with HF-H₂SO₄, diluted, and adjusted to 1M in HCl. A DPV scan is conducted from –0.03 to –0.5 V (E _p –0.15 V). Sb(V) is not reduced in the 1M HCl supporting electrolyte. Total Sb is determined by using an aliquot of the sample solution adjusted to 6M in HCl. The DPV sweep is carried out from –0.5 to –0.1 V [E _p for Sb(V) and Sb(III) is –0.30 V]. The methods have been applied to a wide range of glass compositions and the results compared with values obtained by spectrophotometry and coulometric titration.

---

Bestimmung von Arsen(III, V) und Antimon(III, V) in Gläsern mit Hilfe der Differential-Puls-Voltammetrie

Zusammenfassung Analytische Methoden auf der Grundlage der Differential-Puls-Voltammetrie (DPV) für die Bestimmung des gesamten Arsens, As(III), As(V), des gesamten Antimons und Sb(III) als Spuren in komplexen Gläsern wurden beschrieben. Zwecks Bestimmung des Gesamt-As wird die Probe mit Flußsäure +Schwefelsäure + Permanganat aufgeschlossen. As(V) wird mit Hypophosphit reduziert und die DPV wird an einer Quecksilber-Tropfelektrode zwischen –0,2 und –0,7V gegen eine ges. Kalomelelektrode (E _p =–0,41V) durchgeführt. Zur Bestimmung von As(V) wird die Probe mit HF-H₂SO₄ unter Verflüchtigung des As(III) als AsF₃ aufgeschlossen. Dann erfolgt die Reduktion des As(V) und die DPV. Wenn sich das Glas mit kalter HF lösen läßt, wird anwesendes As(III) mittels DPV in dieser Lösung bestimmt. Zur Bestimmung des Sb(III) wird die Probe mit HF-H₂SO₄ zersetzt, verdünnt und bis zur 1-Molarität mit HCl versetzt. Dann wird mit DPV zwischen –0,03 und –0,5V gemessen (E _p =–0,15V). Sb(V) wird in 1M salzsaurer Lösung nicht reduziert. Das Gesamt-Sb wird in einem Aliquot der Probelösung bestimmt, das dazu mit HCl bis zur 6fachen Molarität versetzt wird. Der DPV-Bereich wird von –0,5 bis –0,1 V ausgenützt (E _p f:ur Sb(V) und Sb(III) ist –0,30 V). Das Verfahren wurde für Gläser verschiedenster Zusammensetzung angewendet. Die Ergebnisse wurden mit den Resultaten der Spektrophotometrie und der coulometrischen Titration verglichen.

---

---

Presented at the 8th International Microchemical Symposium, Graz, August 25–30, 1980.     

填料对硅橡胶化学应力松弛的影响

二氧化硅填充的硅橡胶在250—300℃作连续化学应力松弛时相对应力的变化是先衰减到一最低值而后增长。它近似地符合下列式子 f(t)/f(0)=A_1e~(-k_1l+A_2e~(-k_2l)+k_3t+A3f(t)、f(0)分别为t时和起始时的应力。k_1和k_2为应力松弛常数,分别代表与填料相连之链的断裂和胶相断裂的反应速度,k_3为应力增长常数,代表受力链的交联速度。     

Microdetermination of sulfite with a piezoelectric crystal detector

A piezoelectric method is proposed for the determination of sulfite in concentration range 1 × 10^–7–1 × 10^–5 mol/1. The method is based on the redox reaction of sulfite with iodine followed by measuring frequency change of the piezoelectric crystal caused by the unreacted iodine. The method is applied to the determination of sulfite in liquor.     

Recent Advances in Fullerene‐free Polymer Solar Cells: Materials and Devices

What is the most favorite and original chemistry developed in your research group? We focus on developing new organic photovoltaic materials and exploring their applications in photovoltaic devices. Based on the new materials, we can figure out the correlations among chemical strictures, optoelectronic properties, and photovoltaic behaviors. Our group originally demonstrated quite a few build blocks for making conjugated polymers for photovoltaic applications, some of them have been broadly used by the researchers in the field. How do you get into this specific field? Could you please share some experiences with our readers? I got into this field when I was a graduate student in 2002, just because my supervisor gave me a research topic for synthesis of new conjugated polymers. At that moment, as a fresh graduate student, I had no chance to say yes or no, but to do it. The field of organic solar cells is oriented by the new organic photovoltaic materials. In the past decades, the materials have been updated for a few generations, which promoted the device performance to be higher and closer to practical applications. We have to concentrate on the fundamental problems but also need to follow the pace of the filed. How do you supervise your students? In my opinion, the students need more specific projects to get into the field so as to be well trained at the beginning. In the later stage, I prefer to encourage them to find and creatively figure out the real fundamental problems. I used to give them a few questions: Why do you need to do this project? How to make a clear definition for the problem? Can you suggest a new and better approach to solve it? What is the most important personality for scientific research? Passion, perseverance and sense of innovation. What is your favorite journal(s)? The journals publishing the latest and/or systematic research works in chemistry and material science.     

Rational design of an “all-in-one” phototheranostic

We report here porphodilactol derivatives and their corresponding metal complexes. These systems show promise as “all-in-one” phototheranostics and are predicated on a design strategy that involves controlling the relationship between intersystem crossing (ISC) and photothermal conversion efficiency following photoexcitation. The requisite balance was achieved by tuning the aromaticity of these porphyrinoid derivatives and forming complexes with one of two lanthanide cations, namely Gd³⁺ and Lu³⁺. The net result led to a metalloporphodilactol system, Gd-trans-2, with seemingly optimal ISC efficiency, photothermal conversion efficiency and fluorescence properties, as well as good chemical stability. Encapsulation of Gd-trans-2 within mesoporous silica nanoparticles (MSN) allowed its evaluation for tumour diagnosis and therapy. It was found to be effective as an “all-in-one” phototheranostic that allowed for NIR fluorescence/photoacoustic dual-modal imaging while providing an excellent combined PTT/PDT therapeutic efficacy in vitro and in vivo in 4T1-tumour-bearing mice.

We report here porphodilactol derivatives and their corresponding metal complexes as “all-in-one” phototheranostics by controlling the relationship between intersystem crossing (ISC) and photothermal conversion efficiency following photoexcitation.     

Acidichromism in the Mixed Langmuir—Blodgett Films of Stearic Acid with a Carbazole—containing Schiff Base

ＩｎｔｒｏｄｕｃｔｉｏｎＲｅｖｅｒｓｉｂｌｅｃｏｌｏｒｃｈａｎｇｅｓｕｐｏｎｅｘｔｅｒｎａｌｏｒｉｎｔｅｒｎａｌｓｔｉｍｕｌａｔｉｏｎｓｈａｖｅｂｅｅｎａｔｔｒａｃｔｉｎｇｍｕｃｈａｔｔｅｎｔｉｏｎｄｕｅｔｏｔｈｅｉｒｕｔｉｌｉｔｙａｓｆｕｎｃｔｉｏｎａｌｍａｔｅｒｉａｌｓ .Ｆｏｒｅｘａｍｐｌｅ ,ｐｈｏ ｔｏｃｈｒｏｍｉｓｍｄｅｓｃｒｉｂｅｓｔｈｅｃｏｌｏｒｃｈａｎｇｅｓｉｎｄｕｃｅｄｂｙｐｈｏ ｔｏｉｒｒａｄｉａｔｉｏｎａｎｄｃａｎｂｅｕｓｅｄａｓｐｈｏｔｏ ｒｅｃｏｒｄｉｎｇｍａｔｅｒｉ ａｌｓ…