位移和速度反馈的数学模型及实现方法

本文提出了位移和速度同时反馈的数学模型 .并给出了位移和速度反馈的实现方法 ,该方法用传统的差动变压器实现了位移和速度的同时反馈     

Surface free energy of CrNx films deposited using closed field unbalanced magnetron sputtering

CrN_x thin films have attracted much attention for semiconductor IC packaging molding dies and forming tools due to their excellent hardness, thermal stability and non-sticking properties (low surface free energy). However, few data has been published on the surface free energy (SFE) of CrN_x films at temperatures in the range 20-170 °C. In this study CrN_x thin films with CrN, Cr(N), Cr₂N (and mixture of these phases) were prepared using closed field unbalanced magnetron sputtering at a wide range of Cr⁺² emission intensity. The contact angles of water, di-iodomethane and ethylene glycol on the coated surfaces were measured at temperatures in the range 20-170 °C using a Dataphysics OCA-20 contact angle analyzer. The surface free energy of the CrN_x films and their components (e.g., dispersion, polar) were calculated using the Owens-Wendt geometric mean approach. The influences of CrN_x film surface roughness and microstructure on the surface free energy were investigated by atomic force microscopy (AFM) and X-ray diffraction (XRD), respectively. The experimental results showed that the lowest total SFE was obtained corresponding to CrN at temperature in 20 °C. This is lower than that of Cr(N), Cr₂N (and mixture of these phases). The total SFE, dispersive SFE and polar SFE of CrN_x films decreased with increasing surface temperature. The film roughness has an obvious effect on the SFE and there is tendency for the SFE to increase with increasing film surface roughness.     

Use of a long-spacer-side-chain liquid crystalline polysiloxane containing a crown ether as a stationary phase for capillary gas chromatography

A new kind of side chain liquid crystalline polysiloxane containing a crown ether with a longer spacer (PSC-11) has been prepared and coated on a fused silica capillary column. The main chroma-tographic characteristics including efficiency, polarity, and selectivity have been examined. The phase exhibits the retention properties of both liquid crystal and crown ether stationary phases and possesses higher efficiency and better selectivity than PSC-3, which has a shorter spacer between the main polysiloxane chain and liquid crystalline side chain.     

The effects of flow split ratio and flow rate in manifolds

This paper reports a combined experimental and numerical investigation of three-dimensional steady turbulent flows in inlet manifolds of square cross-section. Predictions and measurements of the flows were carried out using computational fluid dynamics and laser Doppler anemometry techniques respectively. The flow structure was characterized in detail and the effects of flow split ratio and inlet flow rate were studied. These were found to cause significant variations in the size and shape of recirculation regions in the branches, and in the turbulence levels. It was then found that there is a significant difference between the flow rates through different branches. The performance of the code was assessed through a comparison between predictions and measurements. The comparison demonstrates that all important features of the flow are well represented by the predictions.     

北京自由电子激光最近进展──实现饱和振荡

北京自由电子激光(BFEL)装置于1993年底在10.68μm处实现了饱和振荡.输出激光能量为3mJ,饱和平顶宽度2μs.对应饱和振荡平均功率为210kW(宏脉冲),峰值功率约为20MW,比自发辐射高8个量级,单程小讯号净增益为24%,转换效率为0.45%,与理论预期结果相符.光束质量接近衍射极限.目前装置可工作于9-11μm.     

一维应变压缩下TC4钛合金绝热剪切研究

 利用内径为57 mm的压缩气炮，在撞击速度为0.2~1.2 km/s（相应的靶中压力为3~15 GPa）范围内进行对称碰撞实验，以研究TC4（Ti-Al6-V4）钛合金在一维应变冲击压缩条件下的绝热剪切现象。对回收得到的受冲击样品，在扫描电镜（SEM）下进行细观金相分析。结果指出，一维应变冲击压缩条件下，TC4钛合金中绝热剪切带产生的对称碰撞速度阈值为500 m/s（相当于样品中的压力为5.87 GPa）；主剪切带与冲击方向约为45°角，带上有圆形和椭圆形两种孔洞且随碰撞速度的增大而增多和长大，这是典型的韧性损伤特征。随碰撞速度增大，产生与主剪切带成15°角的支剪切带。这些与理论预言相符。X射线能谱分析结果指出，剪切带内材料发生了(α+β)→β相的转变，是典型的相变带。剪切带的温度估算与实验提供的信息吻合。     

从数学解题看数学美

本论述了“教学好玩”(陈省身语)的五个方面；教学语言精确；教学发现(类比发现；归纳发现和直党发现)；教学解题思路；教学思想方法和数学应用都体现了教学关。     

60keV质子辐照对TiNi记忆合金薄膜马氏体相变的影响

 利用磁控溅射的方法在氧化后的单晶Si基片上制备了TiNi形状记忆合金薄膜，利用示差扫描量热法和原位X射线衍射研究了薄膜的马氏体相变特征。通过60keV质子注入（辐照）薄膜样品研究了H+离子对合金薄膜马氏体相变特征的影响，结果表明氢离子注入后引起了马氏体相变开始Ms和结束点Mf以及逆马氏体相变开始As和结束温度Af的下降，而对R相变开始Rs和结束温度Rf影响不大。掠入射X射线衍射表明H+离子注入后有氢化物形成。H⁺离子注入形成的氢化物是引起相变点的变化的主要因素。     

The primary investigation of optical-limiting effects of optical active phthalocyanine derivative TMBO-SiPc

The optical-limiting property of an optically active phthalocyanine derivative with different configuration in chloroform solution was measured at 532 nm with 10 ns pulses. The excited state absorption cross-section σ_ex of the derivative was determined with the Z-scan technique. The results showed that the phthalocyanine derivative possesses larger σ_ex than the ground state absorption cross-section σ₀, indicating that it is a material for reverse saturable absorption. And it is specially noticed that the change in the optically active configuration affects its optical-limiting property significantly.     

CO_2 Reforming of CH_4 over Ni/CeO_2-ZrO_2-Al_2O_3 Prepared by Hydrothermal Synthesis Method

The Ni/CeO2-ZrO2-Al2O3 catalyst with different Al2O3 and NiO contents were prepared by hydrothermal synthesis method. The catalytic performance for CO2 reforming of CH4 reaction, the interaction among components and the relation between Ni content and catalyst surface basicity were investigated. Results show that the interaction between NiO and Al2O3 is stronger than that between NiO and CeO2-ZrO2.The addition of Al2O3 can prevent the formation of large metallic Ni ensembles, increase the dispersion of Ni, and improve catalytic activity, but excess Al2O3 causes the catalyst to deactivate easily. The interaction between NiO and CeO2 results in more facile reduction of surface CeO2. The existence of a small amount of metallic Ni can increase the number of basic sites. As metallic Ni may preferentially reside on the strong basic sites, increasing Ni content can weaken the catalyst basicity.