生长温度对磁控溅射ZnO薄膜的结晶特性和光学性能的影响

采用反应射频磁控溅射方法，在Si (100) 基片上制备了具有高c轴择优取向的ZnO薄膜.利用 原子力显微镜、透射电子显微镜、X射线衍射分析、拉曼光谱等表征技术，研究了沉积温度 对ZnO薄膜的表面形貌、晶粒尺度、应力状态等结晶性能的影响；通过沉积温度对透射光谱 和光致荧光光谱的影响，探讨了ZnO薄膜的结晶特性与光学性能之间的关系.研究结果显示， 在室温至500℃的范围内，ZnO薄膜的晶粒尺寸随沉积温度的增加而增加，在沉积温度为500 ℃时达到最大；当沉积温度为750℃时，ZnO薄膜的晶粒尺度有所减小；在室温至750℃的范 围内，薄膜中ZnO晶粒与Si基体之间均存在着相对固定的外延关系；在沉积温度低于500℃时 ，制备的ZnO薄膜处于压应变状态，而750℃时沉积的薄膜表现为张应变状态.沉积温度的不 同导致ZnO薄膜的折射率、消光系数、光学禁带宽度以及光致荧光特性的变化，沉积温度对 紫外光致荧光特性起着决定性的作用.此外，探讨了影响薄膜近紫外光致荧光发射的可能因 素. 关键词： ZnO薄膜 表面形貌 微观结构 光学常数     

Surface free energy of CrNx films deposited using closed field unbalanced magnetron sputtering

CrN_x thin films have attracted much attention for semiconductor IC packaging molding dies and forming tools due to their excellent hardness, thermal stability and non-sticking properties (low surface free energy). However, few data has been published on the surface free energy (SFE) of CrN_x films at temperatures in the range 20-170 °C. In this study CrN_x thin films with CrN, Cr(N), Cr₂N (and mixture of these phases) were prepared using closed field unbalanced magnetron sputtering at a wide range of Cr⁺² emission intensity. The contact angles of water, di-iodomethane and ethylene glycol on the coated surfaces were measured at temperatures in the range 20-170 °C using a Dataphysics OCA-20 contact angle analyzer. The surface free energy of the CrN_x films and their components (e.g., dispersion, polar) were calculated using the Owens-Wendt geometric mean approach. The influences of CrN_x film surface roughness and microstructure on the surface free energy were investigated by atomic force microscopy (AFM) and X-ray diffraction (XRD), respectively. The experimental results showed that the lowest total SFE was obtained corresponding to CrN at temperature in 20 °C. This is lower than that of Cr(N), Cr₂N (and mixture of these phases). The total SFE, dispersive SFE and polar SFE of CrN_x films decreased with increasing surface temperature. The film roughness has an obvious effect on the SFE and there is tendency for the SFE to increase with increasing film surface roughness.     

偶氮苯衍生物三阶非线性的四波混频研究

用皮秒Ｎｄ：ＹＡＧ激光器的倍频光（５３２ｎｍ）对具有离域π－共轭电子云结构的偶氮苯类样品材料作简并四波混频补给，测得三阶非线性电极化率ｘ＾（３）和它们的时间响应分别为１０＾－９ｅｓｕ和２０ｐｓ，并对影响ｘ＾（３）的瞬时光栅作用和ｘ＾（３）的响应时间人了讨论。     

声流现象的研究及其应用

本文从声流产生的机理出发，综合了影响声流的诸因素，介绍了声流现象的检测方法及声流效应的应用。     

双齿配位过渡金属化合物化学——Ⅲ.钒的邻巯基苯酚配合物的顺磁谱研究

测定了二个顺磁性化合物(Ph_1P)[V_2(mp)_6](Ⅰ)和(Ph_4P)_2[NaV(mp)_3 (MeCN)(MeOH)](Ⅱ)(H_2mp=邻巯基苯酚,o-HO_1C_6H_4SH)的固态和/或溶液中的顺磁波谱。(Ⅰ)的77K固态谱及(Ⅱ)的室温固态谱均经模拟计算,认为它们的钒原子处在S=l/2的Ⅰ=7/2状态,(Ⅱ)的低温(77K)溶液谱(乙腈)与Ⅱ的固态谱相同,均有特征的八条精细结构,认为非配对电子基本上定域在钒原子的周围。     

电沉积n—CdSe在多硫溶液界面上的电荷转移机理

通过测定平带电位,澄清了OH~-离子在CdSe电极上的吸附情况,发现在S、S~(2-)、OH~-溶液中S~(2-)离子优先吸附,结合旋转环盘电极测量,证明n-CdSe电极在多硫溶液界面上的电荷转移过程。     

Influence of Cr interlayer on the structure and optical properties of Ag films on glass substrate by magnetron sputtering

Optical properties and microstructure of Ag film on glass substrate with Cr intermediate layer were studied by using spectrophotometer and XRD. The spectra results showed that introducing Cr intermediate layer reduced the surface roughness and promoted the reflectivity of Ag film. The XRD analysis showed that the crystalline grains increased and the stress decreased. The adhesion was also improved by using the tape test method.     

Preparing polymer brushes on polytetrafluoroethylene films by free radical polymerization

Films of polytetrafluoroethylene (PTFE) were exposed to sodium naphthalenide (Na/naphtha) etchant so as to defluorinate the surface for obtaining hydroxyl functionality. Surface-initiators were immobilized on the PTFE films by esterification of 4,4′-azobis(4-cyanopentanoic acid) (ACP) and the hydroxyl groups covalently linked to the surface. Grafting of polymer brushes on the PTFE films was carried out by the surface-initiated free radical polymerization. Homopolymers brushes of methyl methacrylate (MMA) were prepared by free radical polymerization from the azo-functionalized PTFE surface. The chemical composition and topography of the graft-functionalized PTFE surfaces were characterized by X-ray photoelectron spectroscopy (XPS), attenuated total reflectance (ATR) FT-IR spectroscopy and atomic force microscopy (AFM). Water contact angles on PTFE films were reduced by surface grafting of MMA.     

Towards Strong Duality in Integer Programming

We consider in this paper the Lagrangian dual method for solving general integer programming. New properties of Lagrangian duality are derived by a means of perturbation analysis. In particular, a necessary and sufficient condition for a primal optimal solution to be generated by the Lagrangian relaxation is obtained. The solution properties of Lagrangian relaxation problem are studied systematically. To overcome the difficulties caused by duality gap between the primal problem and the dual problem, we introduce an equivalent reformulation for the primal problem via applying a pth power to the constraints. We prove that this reformulation possesses an asymptotic strong duality property. Primal feasibility and primal optimality of the Lagrangian relaxation problems can be achieved in this reformulation when the parameter p is larger than a threshold value, thus ensuring the existence of an optimal primal-dual pair. We further show that duality gap for this partial pth power reformulation is a strictly decreasing function of p in the case of a single constraint. Dedicated to Professor Alex Rubinov on the occasion of his 65th birthday. Research supported by the Research Grants Council of Hong Kong under Grant CUHK 4214/01E, and the National Natural Science Foundation of China under Grants 79970107 and 10571116.     

On the deformation and fracture of porous materials

The constitutive behavior of porous materials (including the yield loci, the void growth rate, the macro stress-strain relation and the strain to localization instability) is examined based on the lower bound approach proposed by the present authors. These results are then compared with the experimental and the finite element results as well as those predicted by Gurson's equations. Emphasis is placed on approaching the real behavior from the upper and the lower bound analysis. Calculation is also made on the influence of void nucleation on the critical strain to instability and a modified strain-controlled nucleation criterion is proposed. Finally the instability and fracture of AISI4340 steel in plane strain tension is examined and comparison is made between theoretical and experimental results.