Coherent control of the lattice dynamics of bismuth near the lindemann stability limit

The relative contributions of the anharmonicity of the lattice potential and the nonequilibrium concentration of charge carriers to the time dependence of the coherent A _1g phonon frequency in bismuth excited by high-energy ultrashort laser pulses are studied by the coherent control method. The contributions are separated by the pump-probe method in which excitation is performed by two pulses with a controlled time delay. It is shown that, depending on the relative delay between the pump pulses, both correlation and anticorrelation between the amplitude and the initial frequency of oscillations are observed while the chirp and the initial frequency of the coherent phonon are anticorrelated. In addition, it has been found that the contributions of the lattice and the electronic subsystem are always anticorrelated. Therefore, a certain phase can be assigned to an electronic excitation and it may be suggested that the time dependence of the phonon frequency is determined not only by instantaneous values of the lattice and electronic response but also by the phase relations between them.     

Precision measurement of the refractive index of carbon dioxide with a frequency comb

We report a higher precision measurement of the refractive index of carbon dioxide using a frequency comb as the light source in a Mach-Zehnder interferometer setup. The experimental sensitivity can reach the level of 8.8x10(-9). Taking into account the measurement accuracy of temperature and pressure, the experimental accuracy has a value of 1.2x10(-8). The measurement result has a deviation from the commonly quoted result [Old , J. Opt. Soc. Am.61, 89 (1971)] by 6.4x10(-7) at 800 nm.     

First-principles study of fundamental properties and electronic structure of alloys

We have performed first-principles calculations using full-potential augmented-plane-wave method to investigate the fundamental properties of the Cd_1–xZn_xTe alloys. The composition dependence of the lattice constant and the bulk modulus have been estimated from total energy calculations. By means of the analytical fitting the band structures in the vicinity of the Brillouin center a complete set of effective electron- and hole-masses have also been derived. In order to further understand the effects of the chemical bonding on the above macroscopic properties we then studied the relaxation behaviors and the changes of the electronic states upon alloying for x=0.25 system. The results presented here yield a general understanding of the fundamental properties for the Cd_1–xZn_xTe crystals studies.     

1H NMR Reassignment for Z/E-Benzomalvins B and Absolute Configuration of Benzomalvin C

Chemistry of Natural Compounds - Benzomalvins B, C, and E (1, 2, and 3) were simultaneously obtained from the marine fungus Aspergillus sp. isolated from the soft coral Sinularia sp., collected...     

Effect of Protective Measures on Eye Exposure to Solar Ultraviolet Radiation

In this study, ocular biologically effective exposure to solar ultraviolet radiation (UVBE) is investigated with six kinds of sun protective measures (spectacle lenses, sunglasses, cap, bonnet, straw hat and under parasol). Ocular UV exposure measurements were performed on manikins during the summer period in Shenyang city (41.64° N, 123.50° E, 66 m a.s.l.), China. The measurements include the ocular UV exposure of an unprotected eye and the ambient UV as a control concurrently. Based on the relative spectral weighting factors of the International Commission on Non‐Ionizing Radiation Protection (ICNIRP), the ocular biologically effective UV is calculated and compared with the 8‐h exposure limits of ICNIRP (30 J m^?2). The UV index (UVI) of the measurement days is 0–8, and the 8‐h (8:00–16:00 China Standard Time, CST) cumulated UVBE of the unprotected eye is 452.0 J m^?2. The 8‐h cumulated UVBE of the eye with spectacle lenses, sunglasses, cap, bonnet, straw hat and under parasol are 364.2, 69.1, 51.4, 49.0, 56.8 and 110.2 J m^?2, respectively. Importantly, it should be noted that the eye could be exposed to risk despite protective measures. The 8‐h cumulated UVBE of the eye with protection is ca 1.6–15.1 times the exposure limit, respectively. As indicated in the present study, during summer months, high exposure to the sun for more than 30 min without eye protection and more than 1 h with eye protection is not advisable. The protection measures could effectively reduce the UVBE reaching the eye, yet there is still a high degree of risk when compared with the ICNIRP 8‐h exposure limits.     

Direct immobilization of iodine-loaded silver-coated silica gel with silicate glass powders at low temperature

Journal of Radioanalytical and Nuclear Chemistry - To long-term immobilization of secondary iodine-waste, iodine loaded silver-coated silica-gel (AgIs), glass-powder was used to directly solidify...     

Ni-N-C单原子催化剂活化过硫酸盐降解苯酚

采用煅烧法制备了以木质素生物炭为载体的单原子催化剂(Ni-N-C-10), 用于高效活化过硫酸盐(PMS)降解苯酚. 利用扫描电子显微镜(SEM)、 透射电子显微镜(TEM)、 经球差校正的高角度环形暗场扫描透射电子显微镜(AC-HAADF-STEM)、 X射线粉末衍射仪(XRD)以及X射线光电子能谱仪(XPS)等对材料进行了表征分析, 证明合成了原子分散的催化剂Ni-N-C-10. 探究了制备过程中双氰胺的投加量和降解实验中催化剂投加量、 PMS投加量、 pH值以及温度对苯酚降解的影响. 结果表明, 在催化剂制备过程中, 加入10倍质量比的双氰胺更有利于实现原子分散. Ni-N-C-10/PMS体系在较低的催化剂和PMS投加量、 以及较宽的pH值范围(3~9)内都能有效活化PMS降解苯酚. 此外, 该体系的稳定性好且应用范围广, 除了能高效降解苯酚外还能快速降解双酚A、 四环素和亚甲基蓝. 电子顺磁共振检测和自由基淬灭实验结果表明, Ni-N-C-10/PMS体系降解苯酚为SO₄^?-、 ·OH和¹O₂ 3种主要活性物种共同作用的结果, 其中¹O₂起主导作用. 反应前后Ni-N-C-10催化剂的XPS分析结果表明, 催化降解苯酚的效率与Ni位点呈正相关.     

A copper-based coordination polymer formed through synergistic bridging of 1,2,4-triazole and acetate anions: synthesis,crystal structure and magnetic properties

Transition Metal Chemistry - A Cu(II) coordination polymer, [Cu2(pztrz)2(μ-CH3COO)(CH3COO)]·3H2O (1), derived from mono-substituted 1,2,4-triazole derivative 3-(pyrazinyl)-1,2,4-triazole...     

In situ synthesis of CdS/ZnS composite nanoparticles from ZIF-8 for visible light disposal of Cr(VI)

Journal of Sol-Gel Science and Technology - Zeolitic Imidazolate Framework (ZIF-8) micropolyhedra were employed as a raw material for the synthesis of fine cadmium sulfide/zinc sulfide (CdS/ZnS)...     

MIL-53(Al)衍生的Rh单原子催化剂在间氯硝基苯选择性加氢制间氯苯胺反应中的应用

卤代苯胺是化学工业中重要的中间体,主要用于制造药物、聚合物、染料等含氮化学品,用多相金属催化剂催化卤代硝基芳烃加氢制备卤代苯胺是一种高效,绿色和可持续发展的生产工艺.该过程需要选择性加氢硝基基团,同时避免卤素基团的脱卤副反应发生.然而,化学选择性加氢存在巨大的挑战,难点在于催化剂的精准设计,一方面要求具备对硝基基团合适的加氢能力,另一方面要阻止对卤素基团的脱卤副反应发生.基于此,研制高效多相金属催化剂用于卤代硝基芳烃选择性加氢制备卤代苯胺反应引起了高度关注.近年来,单原子金属催化剂受到越来越多的关注,并在卤代硝基芳烃选择性加氢制备卤代苯胺反应中显现出极大的潜力.本文通过在金属有机骨架材料MIL-53(Al)自组装的过程中将金属Rh原位嫁接其骨架结构中,继而通过限域热解的方法制备了Rh@Al2O3@C单原子催化剂,其在间氯硝基苯(m-CNB)加氢制间氯苯胺(m-CAN)反应中显现了高效催化选择性.球差校正高角度环形暗场模式的透射电镜,CO作为探针分子的红外光谱和X射线光电子能谱等结果发现,Rh是以单原子的形式均匀的分布在Al2O3上并被无定型碳包覆,且Rh化学价态呈正价.而27Al固体核磁共振与密度泛函理论计算的结果则进一步确定Al2O3@C载体中存在的五配位的Al物种(AlV)是锚定Rh单原子的主要位点,AlV的不饱和的配位结构可以有效地稳定Rh单原子,对形成Rh位点的单原子分散至关重要.在间氯硝基苯选择性加氢制间氯苯胺反应中,与等体积浸渍法制备的Rh/C和Rh/γ-Al2O3纳米催化剂相比,Rh@Al2O3@C单原子催化剂表现出优异催化性能:其在313 K,氢气压力为20 bar的温和条件下转换频率(TOF)高达2317 molm-CNB·molRh-1·h-1,优于已报道的多相金属催化剂,是目前的最高值.此外,该催化剂展现出极佳的稳定性能,经过五次循环后,该催化剂对m-CAN的选择性仍旧保持在98％左右.Rh@Al2O3@C单原子催化剂的优异催化性能源自于金属单原子结构的形成对于金属位点电子结构的有效调节,进而调控催化剂加氢性能并实现对加氢脱卤副反应的抑制;与此同时,Rh@Al2O3@C催化剂增进了酸位点的可及性,从而促进了其串联步骤中包含的脱水反应的发生,进而有效提高催化剂的反应活性.