Molecular weight distribution studies. I. Radiation-induced polymerization of liquid α-methylstyrene

The concentration of water in purified and BaO-dried α-methylstyrene was found to be 1.1 × 10^?4M. The radiation-induced bulk polymerization of the α-methylstyrene thus prepared was studied in the temperature range of ?20°C to 35°C. The polymerization rate varied as the 0.55 power of the dose rate. The theoretical molecular weights and molecular weight distribution were calculated from a proposed kinetic scheme and these values were then compared with those found experimentally. The agreement between these two was reasonably close, and therefore it was concluded that, from the molecular weight distribution point of view, the proposed kinetic scheme for the cationic polymerization of α-methylstyrene is an acceptable one. The rate constant for chain transfer to monomer k_f changed with temperature and was found to be responsible for the decrease in the molecular weight of the polymer with increase in temperature. k_f and k_p at 20°C were found to be 0.95 × 10⁴ l./mole-sec and 0.99 × 10⁶ l./mole-sec, respectively.     

Differential determination of arsenic (III) and total arsenic with L-cysteine as prereductant using a flow injection non-dispersive atomic absorption device

Speciation of arsenic in environmental samples gains increasingly importance, as the toxic effects of arsenic are related to its oxidation state. A method was developed for the determination of trace amounts of arsenic (III) and total arsenic by flow injection hydride generation coupled with an in-house made non-dispersive AAS device. The total arsenic is determined after prereduction of arsenic (V) to arsenic (III) with L-cysteine in a low concentration of hydrochloric, acetic or nitric acid. The conditions for the prereduction, hydride generation and atomization were systematically investigated. A quartz tube temperature of 800 degrees C was found to be optimum in view of peak shape and baseline stability. Pb(II), Ni(II), Fe(III), Cu(II), Ag(I), Al(III), Ga(II), Se(IV), Bi(III) were checked for interfering with the 2 microg/L As(V) signal. A serious signal depression was only observed for Se(IV) and Bi(III) at a 150-fold excess. With the above system, arsenic was determined at a sampling frequency of about 1/min with a detection limit (3sigma) of 0.01 microg/L using a 0.5 mL sample. The reagent blank was 0.001+/-0.0003 absorbance units and the standard deviation of 10 measurements of the 2 microg/l As signal was found to be 1.2%. Results obtained for standard reference materials and water samples are in good agreement with the certified values and those obtained by ICP-MS     

An immune algorithm for resolution of multicomponent overlapping chromatograms

A novel immune algorithm for resolution and quantitative determination of the components in overlapping chromatograms was proposed by imitating biological immune systems. The algorithm takes an overlapping chromatogram as its input and subtracts the chromatograms of standard samples from the input by iteration of a network. When the residual does not change, the network will converge and chromatographic information of the components in overlapping chromatogram will be obtained. Both simulated and experimental data sets were investigated by the method. Results showed that both resolved results and recoveries of quantitative determination are satisfactory. Comparing with conventional least-square method, the immune algorithm is fast in calculation.     

Synthesis and optical resolution of a series of inherently chiral calix[4]crowns with cone and partial cone conformations

A series of inherently chiral calix[4]arenes with cone and partial cone conformations and with crown ether moieties of variable size have been readily synthesized. By taking advantage of the carboxy appendage on the lower rim, these were condensed with the chiral auxiliary (S)-BINOL to form diastereomers which, in most cases, could be separated by preparative TLC, or more desirably, by column chromatography on silica gel (diastereomeric excess >99 % based on HPLC analysis). Seven enantiopure antipodes of inherently chiral calix[4]crowns were obtained after hydrolysis. It has been found that both the size of the crown moiety and alkylation of the last phenolic hydroxy group (accompanied with or without a change in the conformation) affect the separation of the diastereomers.     

Studies on the reactions of silyl enol ether with perfluoroorganic compounds1 III. Synthesis of perfluoroalkylated α, β-unsaturated aldehydes and their derivatives

Per- and poly-fluoroalkylated α, β-unsaturated alkenals were synthesized by the reaction of silyl enol ether of alkanals with per- and poly-fluoroalkyl iodide initiated by Na₂S₂O₄ conveniently in high yield. Their corresponding alkenol and 2,4-dinitrophenylhydrazone were also synthesized.     

Increased throughput in quantitative bioanalysis using parallel-column liquid chromatography with mass spectrometric detection

The feasibility of quantitative bioanalysis by parallel-column liquid chromatography in conjunction with a conventional single-source electrospray mass spectrometer has been investigated using plasma samples containing a drug and its three metabolites. Within a single chromatographic run time, sample injections were made alternately onto each of two analytical columns in parallel at specified intervals, with a mass spectrometer data file opened at every injection. Thus, the mass spectrometer collected data from two sample injections into separate data files within a single chromatographic run time. Therefore, without sacrificing the chromatographic separation or the selected reaction monitoring (SRM) dwell time, the sample throughput was increased by a factor of two. Comparing the method validation results obtained using the two-column system with those obtained using the corresponding conventional single-column approach, the methods on the two systems were found to be equivalent in terms of accuracy and precision. The parallel-column system is simple and can be implemented using existing laboratory equipment with no additional capital outlays. A parallel-column system configured in this manner can be used not only for the within-a-run analysis of two samples containing two different sets of chemical entities, but also for the within-a-run analysis of two samples containing the same set of chemical entities.     

Topography of the free-energy landscape probed via mechanical unfolding of proteins

Single-molecule experiments in which proteins are unfolded by applying mechanical stretching forces generally force unfolding to proceed along a reaction coordinate that is different from that in chemical or thermal denaturation. Here we simulate the mechanical unfolding and refolding of a minimalist off-lattice model of the protein ubiquitin to explore in detail the slice of the multidimensional free-energy landscape that is accessible via mechanical pulling experiments. We find that while the free-energy profile along typical "chemical" reaction coordinates may exhibit two minima, corresponding to the native and denatured states, the free energy G(z) is typically a monotonic function of the mechanical coordinate z equal to the protein extension. Application of a stretching force along z tilts the free-energy landscape resulting in a bistable (or multistable) free energy G(z)-fz probed in mechanical unfolding experiments. We construct a two-dimensional free-energy surface as a function of both chemical and mechanical reaction coordinates and examine the coupling between the two. We further study the refolding trajectories after the protein has been prestretched by a large force, as well as the mechanical unfolding trajectories in the presence of a large stretching force. We demonstrate that the stretching forces required to destabilize the native state thermodynamically are larger than those expected on the basis of previous experimental estimates of G(z). This finding is consistent with the recent experimental studies, indicating that proteins may refold even in the presence of a substantial stretching force. Finally, we show that for certain temperatures the free energy of a polyprotein chain consisting of multiple domains is a linear function of the chain extension. We propose that the recently observed "slow phase" in the refolding of proteins under mechanical tension may be viewed as downhill diffusion in such a linear potential.     

Simultaneous determination of neodymium, erbium and holmium in rare earth mixtures with 2-phenyltrifluoroacetone and octylphenol poly(ethyleneglycol) ether by third-derivative spectrophotometry

The complexes of the rare earth metals with 2-phenyltrifluoroacetone in the presence of TX-100 are reported. The characteristic absorbances of neodymium, holmium and erbium complexes can be increased by factors of 8.5, 31 and 15 respectively, compared to those of the cholrides. The third-derivative spectra have been used to eliminate the interference of cerium, and the sensitivities are increased again by factors of 7.4, 5.5 and 6.5. A method for the direct determination of neodymium, erbium and holmium in rare earth mixtures is proposed.     

Color Displays with Gel-Glass Dispersed Liquid Crystals

Liquid crystal microdroplets trapped into silica gel-glasses by sol-gel processes may be used for display applications. Gel-glass dispersed liquid crystals (GDLC) are switched between opaque and transparent states by applying external AC-voltage signals; no polarizers are required. The feasibility of applying these materials to colored displays has been explored. A comparative study of different dyes for GDLC color displays, which were either embedded in the sol-gel matrix or dissolved in the liquid crystal microdroplets is presented.     

Adsorption configuration and local ordering of silicotungstate anions on Ag(100) electrode surfaces

X-ray reflectivity, cyclic voltammetry, and scanning tunneling microscopy (STM) are used to examine the structure of alpha-SiW12O4(4-) or silicotungstic acid (STA) adsorbed on Ag(100) in acid solution. The voltammetry shows that STA passivates the Ag surface relative to electron transfer to a solution redox species. STM images reveal the formation of a series of lattice structures, one of which can be associated with a commensurate ( radical13x radical13)R33.69 degrees structural model. X-ray reflectivity measurements show uniquely that STA orients with its four-fold axis perpendicular to the Ag(100) surface and that the center of the STA molecule is 4.90 A above the top layer of the Ag substrate. Analysis of bond lengths leads to a footprint of STA on Ag(100), in which the four terminal O atoms are located near the hollow sites and have a Ag-O bond length of 2.06 A. This bond length is consistent with a strong covalent interaction between STA and the Ag surface.