Effect of the Electron-LO-Phonon Coupling on an Exciton Quantum Dot

The influence of the electron-LO-phonon coupling on energy spectrum of the low-lying states ofan exciton inparabolic quantum dots is investigated as a function of dot size. Calculations are made by using the method of few-bodyphysics within the effective-mass approximation. A considerable decrease of the energy in the stronger confinement rangeis found for the low-lying states of an exciton in quantum dots, which results from the confinement of electron-phononcoupling.     

Isothermal crystallization kinetics of poly(3‐hydroxybutyrate)/layered double hydroxide nanocomposites

Poly(3‐hydroxybutyrate) (PHB)/layered double hydroxides (LDHs) nanocomposites were prepared by mixing PHB and poly(ethylene glycol) phosphonates (PEOPAs)‐modified LDH (PMLDH) in chloroform solution. Both X‐ray diffraction data and TEM micrographs of PHB/PMLDH nanocomposites indicate that the PMLDHs are randomly dispersed and exfoliated into the PHB matrix. In this study, the effect of PMLDH on the isothermal crystallization behavior of PHB was investigated using a differential scanning calorimeter (DSC) and polarized optical microscopy. Isothermal crystallization results of PHB/PMLDH nanocomposites show that the addition of 2 wt % PMLDH into PHB induced more heterogeneous nucleation in the crystallization significantly increasing the crystallization rate and reducing their activation energy. By adding more PMLDH into the PHB probably causes more steric hindrance of the diffusion of PHB, reducing the transportation ability of polymer chains during crystallization, thus increasing the activation energy. The correlation among crystallization kinetics, melting behavior and crystalline structure of PHB/PMLDH nanocomposites can also be discussed. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 44: 3337–3347, 2006     

Isoelectric focusing sample injection for capillary zone electrophoresis in a fused silica capillary.

An improvement has been made to couple isoelectric focusing (IEF) sample injection and capillary zone electrophoresis in an untreated fused silica capillary. Electroosmotic flow is efficiently prevented by simply using a rubber block at the outlet end of the capillary during IEF sample injection. The experimental conditions that affect the concentration effect are discussed. A concentration enhancement factor of over 100-fold can be easily obtained for two model proteins: lysozyme and ribonuclease A.     

Reductions in overshoot following intense sound exposures

Overshoot refers to the poorer detectability of brief signals presented soon after the onset of a masking noise compared to those presented after longer delays. In the present experiment, brief tonal signals were presented 2 or 190 ms following the onset of a broadband masker that was 200 ms in duration. These two conditions of signal delay were tested before and after a series of exposures to a tone intense enough to induce temporary threshold shift (TTS). The magnitude of the overshoot was reduced after the exposure when a TTS of at least 10 dB was induced, but not when smaller amounts of TTS were induced. The reduction in overshoot was due to a decrease in the masked thresholds with the 2-ms delay; masked thresholds with the 190-ms delay were not different pre- and post-exposure. The implication is that the mechanisms responsible for the normal overshoot effect are temporarily inactivated by the same stimulus manipulations that produce a mild exposure-induced hearing loss. Thus the result is the paradox that exposure to intense sounds can produce a loss of signal detectability in certain stimulus conditions and a simultaneous improvement in detectability in other stimulus conditions.     

Chemical analysis and distribution investigation of trace elements in indium matrix by spark source mass spectrometry

Summary High-purity indium was analysed by spark source mass spectrometry, using electrical and photoplate detection. For the calibration of the differences in elemental sensitivity, a standard sample was prepared in which 10 impurities were determined by graphite furnace atomic absorption spectrometry. In this way accuracies of less than 40% were obtained for relatively homogeneous elements at ppm and sub-ppm level. About 40 elements could be determined with detection limits of 10 to 30 ppb. Two pattern recognition methods, principal component analysis and clustering analysis, were applied to obtain information on trace element distribution, which indicated that a number of elements were strongly spatially correlated in the analysed sample.

---

Chemische Analyse und Verteilungsbestimmung von Spurenelementen in Indium-Matrix durch Funkenquellen-Massenspektrometrie

---

On leave from: Department of Chemistry, Nanjing Normal University, Nanjing, People's Republic of China     

Decrease in the group velocity of a light pulse in the Bose-Einstein condensate of a dilute gas

A semiclassical theory of electromagnetically induced transparency in a Bose-Einstein condensate is considered. A nonlinear Schrödinger equation that describes the interaction of the Bose-Einstein condensate with an electromagnetic field is derived. An analysis of the obtained solutions to this equation demonstrates a decrease in the group velocity of the light pulse.     

Photoluminescence of liquid-crystal azo derivatives in nanopores

Optics and Spectroscopy - The fluorescence of the nematic liquid crystal n-butyl-n′-methoxyazoxybenzene (BMAOB) in the form of a layer and in porous glasses with pores of different diameter...     

Microwave‐improved polymerization of ϵ‐caprolactone initiated by carboxylic acids

The ring‐opening polymerization of ε‐caprolactone (ε‐CL), initiated by carboxylic acids such as benzoic acid and chlorinated acetic acids under microwave irradiation, was investigated; with this method, no metal catalyst was necessary. The product was characterized as poly(ε‐caprolactone) (PCL) by ¹H NMR spectroscopy, Fourier transform infrared spectroscopy, ultraviolet spectroscopy, and gel permeation chromatography. The polymerization was significantly improved under microwave irradiation. The weight‐average molecular weight (M_w) of PCL reached 44,800 g/mol, with a polydispersity index [weight‐average molecular weight/number‐average molecular weight (M_w/M_n)] of 1.6, when a mixture of ε‐CL and benzoic acid (25/1 molar ratio) was irradiated at 680 W for 240 min, whereas PCL with M_w = 12,100 and M_w/M_n = 4.2 was obtained from the same mixture by a conventional heating method at 210 °C for 240 min. A degradation of the resultant PCL was observed during microwave polymerization with chlorinated acetic acids as initiators, and this induced a decrease in M_w of PCL. However, the degradation was hindered by benzoic acid at low concentrations. © 2002 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 41: 13–21, 2003