羟丙基醋酸纤维素的合成及其膜的反渗透性

研究了羟丙基纤维素和羟丙基醋酸纤维素的合成。制备羟丙基纤维素的较佳反应温度为40℃左右和2小时或稍长,羟丙基含量随环氧丙烷浓度的增加而增加。在制备羟丙基醋酸纤维素时,随羟丙基含量的增加,所需醋化和水解的时间减少。以甘油-正丙醇或磷酸为添加剂,丙酮为溶剂经30～60s蒸发后制得了羟丙基醋酸纤维素反渗透膜。后者在20kg/cm~2下对氯化钠脱盐率可达95～98％,水通量1.0～2.1mL/cm~2·h,其使用温度上限比醋酸纤维素反渗透膜提高10℃以上。     

Single Atoms of Iron on MoS2 Nanosheets for N2 Electroreduction into Ammonia

Efforts have been devoted to achieving a highly efficient artificial synthesis of ammonia (NH₃). Reported herein is a novel Fe-MoS₂ catalyst with Fe atomically dispersed onto MoS₂ nanosheets, imitating natural nitrogenase, to boost N₂ electroreduction into NH₃ at room temperature. The Fe-MoS₂ nanosheets exhibited a faradic efficiency of 18.8 % with a yield rate of 8.63 μg mg_cat.⁻¹ h⁻¹ for NH₃ at −0.3 V versus the reversible hydrogen electrode. The mechanism study revealed that the electroreduction of N₂ was promoted and the competing hydrogen evolution reaction was suppressed by decorating the edge sites of S in MoS₂ with the atomically dispersed Fe, resulting in high catalytic performance for the electroreduction of N₂ into NH₃. This work provides new ideas for the design of catalysts for N₂ electroreduction and strengthens the understanding about N₂ activation over Mo-based catalysts.     

Influences of permeation of vanadium ions through PVDF-g-PSSA membranes on performances of vanadium redox flow batteries

The preparation and physical characterization of a poly(vinylidene fluoride)-graft-poly(styrene sulfonic acid) (PVDF-g-PSSA) membrane prepared by a solution-grafting method were described. These membranes exhibited high conductivity with a value 3.22 x 10(-2) S/cm at 30 degrees C. ICP studies revealed that the PVDF-g-PSSA membrane showed dramatically lower vanadium ion permeability compared to Nafion 117. Trivalent vanadium ions had the highest permeability through all these membranes in contrast to pentavalent vanadium ions with the lowest. The VRB with the low-cost PVDF-g-PSSA membrane exhibited a higher performance than that with Nafion 117 under the same operating conditions, and its energy efficiency reached 75.8% at 30 mA/cm(2). The performance of VRB with the PVDF-g-PSSA membrane can be maintained after more than 200 cycles at a current density of 60 mA/cm(2).     

Simultaneous determination of arsenic,mercury, antimony and selenium in biological materials with prior collection of gaseous products followed by neutron activation analysis

A method combining prior collection of gaseous products with subsequent neutron activation analysis has been developed for simultaneous determination of traces of arsenic, mercury, antimony and selenium in biological materials. The generation of hydrides of arsenic, antimony and selenium and cold vapor of mercury in the vapor generaion and collection system was investigated by the use of radiotracers of the respective elements. The result indicates that selenium and mercury can be completely evaporated from the digested sample solution in 5M HCl with the addition of 5% sodium tetrahydroborate solution, while additional reduction proces by potassium iodide and ascorbic acid is needed for complete evaporation of arsenic and antimony. The gaseous products were collected in a quartz tube for neutron irradiation. The detection limits of these elements were fount to be in the range of 10^–7 to 10^–8 g under the present experimental conditions. The reliability was checked with NBS standard reference materials.     

Novel amphiphilic fluorescent graft copolymers: synthesis,characterization, and potential as gene carriers

Amphiphilic fluorescent graft copolymer (PVP‐PyATAm) was successfully synthesized by the free radical copolymerizations of hydrophobic monomer N‐acryloyl‐thioureylene‐4‐(1‐pyrene)‐butyryl amide (PyATAm) with hydrophilic precursor polymers of vinyl‐functionalized poly (N‐vinylpyrrolidone) (Acryloyl‐PVP) in DMF. FT‐IR, ¹H NMR, TEM, gel permeation chromatography‐multi‐angle laser light scattering, UV‐vis spectroscopy, viscometric measurement, and fluorescence spectroscopy were used to characterize this copolymer. The TEM observation showed that the copolymer PVP‐ PyATAm formed spherical micelles in an aqueous solution and the size of micelles was between 50 and 70 nm in diameter. The interaction of PVP‐PyATAm copolymer and plasmid DNA was examined by agarose gel electrophoresis and TEM. Results indicated that the copolymer–DNA complexes were self‐assembled and the size of complexes was between 90 and 120 nm in diameter. Cytotoxity studies using MTT colorimetric assays suggested good biocompatibility of PVP‐PyATAm in vitro. These results suggested the potential of this graft copolymer as gene delivery carrier. Copyright © 2007 John Wiley & Sons, Ltd.     

Elution of Cationic Species with/without Ion Pair Reagents from Polar Stationary Phases via SFC

Traditionally, the application of supercritical fluid chromatography has been limited to compounds of relatively low polarity. Thus, we report here that one secondary amine and two quaternary amine salts were successfully eluted from a Deltabond Cyano-bonded silica column with the addition of sodium alkylsulfonate to the methanol-modified, carbon dioxide-based mobile phase. A possible ion-pairing interaction between the positively charged analytes and the anionic part of the sulfonate additive has been proposed. In another set of experiments, the three amine salts readily eluted from both Ethyl-pyridine-bonded silica and Amino-bonded silica phases without the need of additive although the peak shapes were less than desirable. The addition of sulfonate salt to the mobile phase again sharpened the peaks. In the presence of a mixture of methanol and CO₂, we suggest that these stationary phases are positively charged. We describe here also for the first time the employment of a strong silica-based anion exchange (SAX) column for supercritical fluid separation of cationic species. Two elution mechanisms were proposed for the three amine salts depending upon whether the ionic additive was incorporated into the mobile phase. Separation as the ion-pair was proposed with an ionic additive in the mobile phase; whereas separation of the intact amine salt from the positively charged basic stationary phases was suggested to be operational without the ionic additive.     

An extended two‐dimensional copper–molybdate compound with mixed dicarboxyl and organodiamine ligands

The title complex, poly[di‐μ₃‐oxo‐hepta‐μ₂‐oxo‐tetra­oxo­bis(1,10‐phenanthroline)‐μ₄‐terephthalato‐dicopper(II)­tetra­molybdate(VI)], [Cu₂Mo₄(C₈H₄O₄)O₁₃(C₁₂H₈N₂)₂], represents a novel two‐dimensional copper–molybdate compound with mixed ligands. Tetra­nuclear molybdenum oxide clusters are joined through corner‐sharing into a ribbon‐like chain, with [Cu(phen)]²⁺ (phen is 1,10‐phenanthroline) complexes grafted onto either side. The terephthalate ligand lies about an inversion centre and links these chains to form a layer via Cu—O and Mo—O bonds. Face‐to‐face π–π stacking inter­actions between adjacent phen ligands stabilize the structure.     

Solvent effects on infrared spectra of methyl 4-hydroxybenzoate in pure organic solvents and in ethanol/CCl4 binary solvents

Infrared spectroscopy studies of methyl 4-hydroxybenzoate (MHB) in 17 different organic solvents and in ethanol/CCl4 binary solvent were undertaken to investigate the solvent-solute interactions. The frequencies of carbonyl stretching vibration nu(C=O) of MHB in single solvents were correlated with the solvent acceptor number (AN) and the linear solvation energy relationships (LSER). The assignments of the two bands of nu(C=O) of MHB in alcohols and the single one of that in non-alcoholic solvents were discussed. The shifts of nu(C=O) of MHB in ethanol/CCl4 binary solvents showed that several kinds of solute-solvent hydrogen bonding interactions coexisted in the mixture solvents, with a change in the mole fraction of ethanol in the binary solvents.     

Diastereoselective formation of glycoluril dimers: isomerization mechanism and implications for cucurbit[n]uril synthesis

Cucurbit[6]uril (CB[6]) is a macrocyclic compound, prepared in one pot from glycoluril and formaldehyde, whose molecular recognition properties have made it the object of intense study. Studies of the mechanism of CB[n] formation, which might provide insights that allow the tailor-made synthesis of CB[n] homologues and derivatives, have been hampered by the complex structure of CB[n]. By reducing the complexity of the reaction to the formation of S-shaped (12S-18S) and C-shaped (12C-18C) methylene bridged glycoluril dimers, we have been able to probe the fundamental steps of the mechanism of CB[n] synthesis to a level that has not been possible previously. For example, we present strong evidence that the mechanism of CB[n] synthesis proceeds via the intermediacy of both S-shaped and C-shaped dimers. The first experimental determination of the relative free energies of the S-shaped and C-shaped dimers indicates a thermodynamic preference (1.55-3.25 kcal mol(-)(1)) for the C-shaped diastereomer. This thermodynamic preference is not because of self-association, solvation, or template effects. Furthermore, labeling experiments have allowed us to elucidate the mechanism of this acid-catalyzed equilibrium between the S-shaped and C-shaped diastereomers. The equilibration is an intramolecular process that proceeds with high diastereoselectivity and retention of configuration. On the basis of the broad implications of these results for CB[n] synthesis, we suggest new synthetic strategies that may allow for the improved preparation of CB[n] (n > 8) and CB[n] derivatives from functionalized glycolurils.     

Synthesis and Crystal Structure of Two One—dimensional Chain Copper Complexes [Cu（TTA）2（4,4‘’—azpy）] and [Cu（TTA）2（3,3‘’—azpy）

Two copper complexes [Cu(TTA)₂(4,4′‐azpy)] (1) and [Cu‐(TTA)₂(3,3′‐azpy)] (2) (HTTA = 1,1,1‐trifluoro‐3‐(2‐thenoyl)‐acetone, 4,4′‐azpy = 4,4′‐azobispyridine, 3,3′‐azpy = 3,3′‐azobispyridine) were synthesized and characterized. The crystal structures were determined by X‐ray diffraction analysis. The crystal 1 belongs to triclinic with space group P1 , a = 0.8515(2) nm, b = 0.9259(2) nm, c = 0.9468(2) nm, a = 66.126(9)°, β = 79.667(9)°, γ = 90.13(1)°, Z = 1, V = 0.6692(2) nm³, D_c = 3.425 g/cm³, γ = 2.113 mm^?1, F(000) = 694, R₁ = 0.0594, wR₂ = 0.1499. The crystal 2 belongs to monoclinic with space group P2₁/c, a = 1.0661(2) nm, b = 1.4296(3) ran, c = 1.0041(3) nm, β = 114.50(3)°, V = 1.3926(5) nm³, Z = 2, D_c = 1.646 g/ cm³, μ = 1.015 mm^?1, F(000) = 694, R₁, = 0.0535, wR₂ = 0.1113. In the crystals of complexes 1 and 2, the copper atoms have distorted octahedral symmetry. The two compounds possess very similar one‐dimensional linear chains linked through the rodlike 4,4′‐azpy ligands or 3,3′‐azpy ligands.