Poly(N-isopropylacrylamide). I. Interactions with sodium dodecyl sulfate measured by conductivity

Conductometric titration of poly(N-isopropylacrylamide) (polyNIPAM) with sodium dodecyl sulfate (SDS) gave two apparent transitions labeled C1 and C2. The C1 transition was independent of polyNIPAM concentration in the 0.05–0.3 wt % range, whereas C2 was proportional to the polymer concentration. C1 corresponded to the onset of binding of surfactant with polymer. Arguments based on a simple mass action model for micellization are presented to show that C2, the second transition, is not due to any simple explanation such as being the point above which only free micelles are formed with surfactant addition. The cloud point of polyNIPAM increased with the amount of bound surfactant. This was attributed to electrostatic contribution of bound sulfate groups to the increased solubility of polyNIPAM. © 1993 John Wiley & Sons, Inc.     

过硫酸胺与N－［（3－二甲氨基）丙基］丙烯酰胺氧化还原引发体系的研究

过硫酸胺与Ｎ－［（３－二甲氨基）丙基］丙烯酰胺氧化还原引发体系的研究司堃，郭新秋，丘坤元（北京大学化学与分子工程学院北京１００８７１）关键词Ｎ－取代丙烯酰胺，氧化还原体系，反应动力学，端基分析，反应机理Ｎ－［（３一二甲氨基）两基］丙烯酸胺（ＤＭＡＰＡ...     

Comparison of model predictions with measured proton-induced production of nickel and iridium isotopes

Journal of Radioanalytical and Nuclear Chemistry - Calculations were performed to support method development for simultaneous production of Ni and Ir isotopes. The work scope included development...     

硝酸甘油:祸兮福所倚,福兮祸所伏——舞台剧剧本

自1846年硝酸甘油被合成以来,人们一直把其当作炸药来使用。但由于硝酸甘油过于敏感,导致事故不断。为解决这一问题,诺贝尔尝试改良硝酸甘油,将硅藻土与硝酸甘油混合,降低了敏感度,达到安全使用炸药的目的。后来人们发现硝酸甘油还有缓解心绞痛的功能,便对其进行了深入研究。本文以剧本的形式向大众科普硝酸甘油的上述功能。     

带有二元连接函数的半参数模型

提出了一种新的带有二元连接函数的广义半参数模型,即二元连接模型(简称为BLM).使用轮廓似然方法估计模型的参数和非参数部分,并给出了计算算法.证明了所得的未知参数的估计量为n~(1/2)-相合,渐近正态且具有渐近最小方差,给出了实际数据分析和模拟研究,最终采用局部功效方法来检验非参数部分的线性性.     

Yb3+/Tm3+共掺杂的钨酸镉纳米晶发光性能的研究

本文采用水热法制备了稀土离子Yb³⁺/Tm³⁺共掺杂的钨酸镉纳米晶。运用X-射线粉末衍射、场发射环境扫描电子显微镜和光谱分析对制备的样品的结构和发光性能进行了表征。根据XRD图谱可知, 钨酸镉为单斜晶系, 晶粒平均尺寸在28 nm左右。从ESEM图片可明显看出, 钨酸镉呈纳米棒结构, 直径在30 nm左右, 长径比在5~8之间。利用980 nm半导体激光器激发钨酸镉纳米晶得到样品的发射光谱, 存在一个较强的蓝光发射, 发光峰位于481 nm,对应于Tm³⁺的¹G₄→³H₆能级的跃迁, 分析了Tm³⁺/Yb³⁺离子共掺体系的发光机制。讨论了发光强度随稀土离子浓度的变化, 当Tm³⁺离子的掺杂浓度在2%, Yb³⁺/Tm³⁺物质的量浓度比为10:1时钨酸镉纳米晶的发光强度最强。根据泵浦功率与发光强度之间的关系, 可知处于481 nm的蓝光发射属于三光子过程, 由发光强度与掺杂浓度之间的双对数衰减曲线可知, 引起蓝光发射源于Tm³⁺的电偶极跃迁。     

Development and evaluation of gas and liquid chromatographic methods for the analysis of fatty amines

In contrast to the plethora of publications on the separation of fatty acids, analogous studies involving fatty amines are scarce. A recently introduced ionic‐liquid‐based capillary column for GC was used to separate trifluoroacetylated fatty amines focusing on the analysis of a commercial sample. Using the ionic liquid column (isothermal mode at 200°C) it was possible to separate linear primary fatty amines from C₁₂ to C₂₂ chain length in less 25 min with MS identification. The log of the amine retention factors are linearly related to the alkyl chain length with a methylene selectivity of 0.117 kcal/mol for the saturated amines and 0.128 kcal/mol for the mono‐unsaturated amines. The sp² selectivity for unsaturated fatty amines also could be calculated as 0.107 kcal/mol for the ionic liquid column. The commercial sample was quantified by GC with flame ionization detection (FID). An LC method also was developed with a reversed phase gradient separation using acetonitrile/formate buffer mobile phases and ESI‐MS detection. Native amines could be detected and identified by their single ion monitoring chromatograms even when partial coelution was observed. The analysis of the commercial sample returned results coherent with those obtained by GC–FID and with the manufacturer's data.     

聚对氨基苯磺酸/石墨烯电化学修饰电极检测药物中氧氟沙星

基于石墨烯纳米材料和循环伏安法技术制备了聚对氨基苯磺酸/石墨烯修饰电极并研究了氧氟沙星(OFL)在该修饰电极上的电化学行为,建立了一种简单快速灵敏测定氧氟沙星的电化学分析方法。 结果表明,与玻碳电极相比,对氨基苯磺酸/石墨烯电化学修饰电极能显著提高氧氟沙星的峰电流。 在优化条件下,其检测线性范围为1~600 μmol/L,最低检测限为(S/N=3)0.33μmol/L。 该修饰电极具有较好的重现性和稳定性,用于实际样品氧氟沙星滴眼液的测定,效果良好。     

Sustainable preparation of gold nanoparticles via green chemistry approach for biogenic applications

Novel premises of ‘Green Nanotechnology’ have tremendous impacts towards industrial scale revolution. The furtive extracted from natural precursors have driven to the generation of biogenic resources for the fabrication of cutting-edge nanomaterials in simple and cost-effective process. This inspection is an intension of the coupling hypothesis of Nanotechnology via ‘Green-Chemistry’ avenue. So, as to diminish the negative effects of technological applications in the health of human beings and the environment, society is focused towards a greener future. Nanoscience assures a promising future by its improvement in green chemistry to develop the 'Greenary Nanoscience and Nanotechnology'. The improvement and execution of chemical assisted processes in order to reduce the usage of harmful substances, the ‘Green Chemistry’ approach is one and only remarkable authentication, which attributed to long range surface area and higher pore volume of gold-nanoparticles. As of now, the efficient biogenic mechanism dramatically reduces the utilization and hazardous reagents have been employed to low-price natural and waste products to yield value-added nanomaterials with extensive relevance, suggesting an economical and green solution to environmental issues. In depth investigation of this critical review illustrates, novel biogenic screening platform was also conducted against antimicrobial strains and degradation of gold-nanoparticles products well explored-from selection precursors evolved from natural extracts, as well as eventually disintegration into bio-degradable yet potentially recyclable byproducts.     

Super‐ and Ferroelastic Organic Semiconductors for Ultraflexible Single‐Crystal Electronics

Like silicon, single crystals of organic semiconductors are pursued to attain intrinsic charge transport properties. However, they are intolerant to mechanical deformation, impeding their application in flexible electronic devices. Such contradictory properties, namely exceptional molecular ordering and mechanical flexibility, are unified in this work. We found that bis(triisopropylsilylethynyl)pentacene (TIPS‐P) crystals can undergo mechanically induced structural transitions to exhibit superelasticity and ferroelasticity. These properties arise from cooperative and correlated molecular displacements and rotations in response to mechanical stress. By utilizing a bending‐induced ferroelastic transition of TIPS‐P, flexible single‐crystal electronic devices were obtained that can tolerate strains (?) of more than 13 % while maintaining the charge carrier mobility of unstrained crystals (μ>0.7 μ₀). Our work will pave the way for high‐performance ultraflexible single‐crystal organic electronics for sensors, memories, and robotic applications.