Ground state cooling of magnomechanical resonator in PT-symmetric cavity magnomechanical system at room temperature

We propose to realize the ground state cooling of magnomechanical resonator in a parity–time (PT)-symmetric cavity magnomechanical system composed of a loss ferromagnetic sphere and a gain microwave cavity. In the scheme, the magnomechanical resonator can be cooled close to its ground state via the magnomechanical interaction, and it is found that the cooling effect in PT-symmetric system is much higher than that in non-PT-symmetric system. Resorting to the magnetic force noise spectrum, we investigate the final mean phonon number with experimentally feasible parameters and find surprisingly that the ground state cooling of magnomechanical resonator can be directly achieved at room temperature. Furthermore, we also illustrate that the ground state cooling can be flexibly controlled via the external magnetic field.     

大规模合成具有氧空位的多孔Bi2O3用于有效降解亚甲基蓝

光催化降解有机污染物由于其具有低能耗和绿色环保的特点,已经成为研究的热点. 氧化铋纳米晶体的带隙在2.0∽2.8 eV之间,利用它催化可见光降解有机污染物具有较高的活性,从而引起了越来越多的关注. 尽管近年来已经开发了几种制备Bi₂O₃基半导体材料的方法,但是仍然难以用简单的方法大规模地制备高活性的Bi₂O₃催化剂. 因此,开发简单可行的大规模制备Bi₂O₃纳米晶体的方法对于工业废水处理的潜在应用具有重要意义. 本文通过蚀刻商用BiSn粉末,然后进行热处理,成功地大规模制备了多孔Bi₂O₃. 获得的多孔Bi₂O₃在亚甲基蓝(MB)的光催化降解中表现出优异的活性和稳定性. 对该机理的进一步研究表明,多孔Bi₂O₃合适的能带结构允许生成活性氧物种,例如O₂^-·和·OH,可有效降解MB.     

埋层界面和空气表面和频光谱信号贡献的调控

本文研究表明通过膜厚控制和表面等离激元增强方法可有效区分隐藏界面和空气表面的和频振动光谱信号. 以氟化钙基底支撑的PMMA薄膜为模型,观察到隐藏界面和空气表面对和频信号贡献的变化. 通过监控羰基和甲基伸缩振动基团,发现薄PMMA膜的和频信号来自PMMA/空气表面的化学基团-CH₂、-CH₃、-OCH₃和C=O,而厚PMMA膜的和频信号则来自基底/PMMA埋层界面的-OCH₃和C=O基团. 随制膜浓度增大,埋层界面C=O基团的取向角从65°下降到43°,且浓度大于或等于0.5 wt%时,取向角等于45°±2°. 相比之下,空气表面C=O的取向角落在21°∽38°之间. 在金纳米棒存在条件下,表面等离激元可以极大地增强和频信号,尤其是来自埋层界面信号.     

基于PdSe2/GaAs异质结的高灵敏近红外光伏型探测器的制备和图像传感的应用

本文制备了一种基于PdSe₂/GaAs异质结的高灵敏近红外光电探测器,该探测器是通过将多层PdSe₂薄膜转移到平面GaAs上制成的. 所制备的PdSe₂/GaAs异质结器件在808 nm光照下表现出明显的光伏特性,这表明近红外光电探测器可以用作自驱动器件. 进一步的器件分析表明,这种杂化异质结在零偏电压和808 nm光照下具有1.16×10⁵的高开关比. 光电探测器的响应度和比探测度分别约为171.34 mA/W和2.36×10¹¹ Jones. 而且,该器件显示出优异的稳定性和可靠的重复性. 在空气中2个月后,近红外光电探测器的光电特性几乎没有下降,这归因于PdSe₂的良好稳定性. 最后,基于PdSe₂/GaAs的异质结器件还可以用作近红外光传感器.     

磁过滤器电流对非晶碳薄膜摩擦学特性影响的研究

研究了过滤阴极真空电弧技术中,不同的磁过滤器电流下(5—13 A),制备的四面体非晶碳(ta-C)薄膜对摩擦学特性的影响.通过对薄膜厚度,薄膜结构以及薄膜表面粗糙度随磁过滤电流的变化结果进行了测试,结果表明,随着磁过滤器电流的增大,薄膜的sp³键含量逐渐减少,表面粗糙度从0.13增大到0.38.磁过滤器电流在5 A时,薄膜的摩擦系数最小约为0.08,当电流增大到7 A时,摩擦系数显著增大,磁过滤器电流从7 A增大到13 A时,薄膜的摩擦系数再次减小约为0.1. 关键词： 四面体非晶碳 过滤阴极真空电弧 磁过滤器电流 摩擦系数     

The lattice polarizability of PbI2

We have measured the far-i.r. reflectivity spectrum of the layer crystal PbI₂ for the in-plane polarization. A strong reststrahlen band is observed, with TO and LO phonon frequencies located at 52 and 108 cm^?1. The large lattice contribution accounts for three-quarters of the low-frequency dielectric constant of 26. The deduced infrared effective charge and electronic polarizability of PbI₂ indicates that the intralayer bonding is closely related to the chemical bonding in the IV–VI rocksalt-structure crystals.     

金属柱平板慢波系统高频特性研究

对于离散的金属柱结构构建的周期性平板慢波系统,本文利用3维FDTD方法结合HFSS仿真软件深入分析了该慢波系统的高频特性.研究了金属柱高度、周期长度对色散特性的影响,计算了耦合阻抗,并与传统光栅慢波系统特性进行了对比分析.分析表明金属柱慢波系统既有与传统光栅慢波系统相似的高频特性,又具有独自的特点,位于离散的金属柱周期间隙中的电子注互作用耦合阻抗具有对称性;金属柱结构用作真空电子器件的高频系统可增加发生有效互作用的电子注厚度,降低起振电流密度,提高器件效率.本文的分析结果为设计低电流密度工作的多电子注短毫 关键词： 金属柱平板慢波系统 3维FDTD算法 色散特性 耦合阻抗     

Orientation dependence of structural transition in fcc Al driven under uniaxial compression by atomistic simulations

By molecular dynamics simulations employing an embedded atom method potential,we have investigated structural transformations in single crystal Al caused by uniaxial strain loading along the [001],[011] and [111] directions. We find that the structural transition is strongly dependent on the crystal orientations. The entire structure phase transition only occurs when loading along the [001] direction,and the increased amplitude of temperature for [001] loading is evidently lower than that for other orientations. The morphology evolutions of the structural transition for [011] and [111] loadings are analysed in detail. The results indicate that only 20% of atoms transit to the hcp phase for [011] and [111] loadings,and the appearance of the hcp phase is due to the partial dislocation moving forward on {111} fcc family. For [011] loading,the hcp phase grows to form laminar morphology in four planes,which belong to the {111} fcc family; while for [111] loading,the hcp phase grows into a laminar structure in three planes,which belong to the {111} fcc family except for the (111) plane. In addition,the phase transition is evaluated by using the radial distribution functions.