Simplified analytic solutions and a novel fast algorithm for Yb-doped double-clad fiber lasers

In this paper, continuous wave Yb³⁺-doped double-clad fiber lasers (DCFLs) with linear-cavity are investigated theoretically and numerically using the rate equations. Under the steady state conditions, the simplified analytic solutions of Yb³⁺-doped DCFLs under considering the scattering loss are deduced in the strongly pump condition. Compared with the known analytic solutions in published literatures, our analytic solutions are more accurate, especially, at higher reflectivity of output mirror. In addition, a fast and stable algorithm based on the Newton-Raphson method is proposed to simulate numerically Yb³⁺-doped DCFLs. The results by simplified analytic solutions are in good agreement with those by the numerical simulation. Moreover, we have performed the optimization of an Yb³⁺-doped DCFL using the simplified analytic solutions and the numerical simulations, respectively.     

Characterization of ceramic PVD thin films on AZ31 magnesium alloys

Ceramic thin films have been widely used to protect the metal substrate as coatings in the past years. In order to improve the poor corrosion resistance of AZ31 magnesium alloy, the study in this paper used the electron beam evaporation method to prepare ceramic PVD films on its surface with TiO₂ and Al₂O₃ as donors, respectively. Atomic force microscopy (AFM), scanning electron microscope (SEM), energy dispersive X-ray spectrometer (EDS), Auger electron spectroscopy (AES) and X-ray diffraction (XRD) were used to investigate the surface morphology, composition and microstructure of the thin films. Both films deposited on AZ31 took on compact top surface morphologies and grew as amorphous structures on substrate. AES test not only showed that films compositions deviated the standard stoichiometric ratios, but also found that element Mg diffused into films and existed as magnesium oxide in the TiO_x film as well as the AlO_x film. In the electrochemical corrosion test, the AlO_x coating on AZ31 exhibited the largest electrochemical impedance in a 3.5% NaCl solution. But it did not show better corrosion resistance than others for the poorer adhesion. Even if its thickness was small, the TiO_x coating on AZ31 exhibited the best corrosion resistance in this study. According to the observation and analysis, the damage of these films on AZ31 in aggressive solutions was mainly due to the existence of pores, microcracks, vacancies and poor adhesion between coating and substrate.     

利用富铈混合稀土改善工业纯铝中富铁相形貌的研究

利用金相分析方法研究了富Ce混合稀土变质对含不同Fe量的工业纯铝的组织和其中富铁相形貌的影响。试验结果表明,随着Fe含量的增加,富铁相由弥散细小的颗粒状向短棒状、长针状转变;富Ce混合稀土变质使铝中的富铁相由长针状变为弥散细小的颗粒状。随着稀土含量的增加,-αAl晶粒逐渐细化,富铁相尺寸及数量逐渐减小。添加0.5%稀土时,-αAl晶粒细化效果最佳,而且富铁相呈细小颗粒状均匀分布在-αAl基体的晶界处。本文还对稀土改善富铁相的机制进行了分析。     

Multiple periodic solutions of a delayed stage-structured predator–prey model with non-monotone functional responses

A delayed stage-structured predator–prey model with non-monotone functional responses is proposed. It is assumed that immature individuals and mature individuals of the predator are divided by a fixed age, and that immature predators do not have the ability to attack prey. Some new and interesting sufficient conditions are obtained for the global existence of multiple positive periodic solutions of the stage-structured predator–prey model. Our method is based on Mawhin’s coincidence degree and novel estimation techniques for the a priori bounds of unknown solutions to Lx = λNx. An example is given to illustrate the feasibility of our main result.     

Investigation on hexamethyldisilazane vapor treatment of plasma-damaged nanoporous organosilicate films

Hexamethyldisilazane (HMDS) vapor treatment of plasma-damaged nanoporous organosilicate thin films has been studied as a function of treatment temperature in this work. Although, the HMDS vapor treatment facilitated incorporation of methyl (CH₃) groups subsequent to the removal of free hydroxyl (OH) groups in the damaged films at treatment temperature as low as 55 °C, the bonded OH groups were not removed. More significantly, detailed analysis of the results reveals that HMDS vapor modified only the surface of the plasma-damaged samples and not the entire film as expected. This is attributed to the formation of a thin solid layer on the surface, which effectively prevents penetration of HMDS vapors into the bulk. The Fourier transform-infrared (FT-IR) absorption and dielectric constant measurements confirm that the vapor treatment assists only partial curing of the plasma-damaged films. Alternative processes of curing the films with HMDS dissolved in supercritical carbon dioxide (SCCO₂) as a medium of reaction in static and pulsed modes were also attempted and the results are presented in this paper.     

Homoclinic and Periodic Orbits Arising Near the Heteroclinic Cycle Connecting Saddle-focus and Saddle Under Reversible Condition

In this paper, we study the dynamical behavior for a 4-dimensional reversible system near its heteroclinic loop connecting a saddle-focus and a saddle. The existence of infinitely many reversible 1-homoclinic orbits to the saddle and 2-homoclinic orbits to the saddle-focus is shown. And it is also proved that, corresponding to each 1-homoclinic （resp. 2-homoclinic） orbit F, there is a spiral segment such that the associated orbits starting from the segment are all reversible 1-periodic （resp. 2-periodic） and accumulate onto F. Moreover, each 2-homoclinic orbit may be also accumulated by a sequence of reversible 4-homoclinic orbits.     

Direct mass measurements of neutron-deficient 152Sm projectile fragments at the FRS-ESR facility

The FRS-ESR facility at GSI provides one of the most efficient methods for direct mass measurements. In the present experiment, exotic nuclei were produced via fragmentation of ¹⁵²Sm projectiles in a thick beryllium target at 500-600 MeV/u, separated in-flight with the fragment separator FRS, and injected into the storage-cooler ring ESR. Time-resolved Schottky Mass Spectrometry was applied for mass measurements of stored and electron-cooled bare and few-electron ions. 373 different nuclides were identified by means of the spectra of their revolution frequencies. Masses for 18 nuclides (⁸⁴Zr, ⁹²Ru, ⁹⁴Rh, ^107,108,110Sb, ^111,112,114I, ¹¹⁸Ba, ^122,123La, ¹²⁴Ce, ¹²⁷Pr, ¹²⁹Nd, ¹³²Pm, ¹³⁴Sm, ¹³⁷Eu) have been determined for the first time. Masses for ^111,112I and ¹¹³Xe have been obtained via known α-decay energies. The experiment and first results will be presented.     

Magnetic,structural and electrical properties of ordered and disordered Co50Fe50 films

Co₅₀Fe₅₀ films with thickness varying from 100 to 500 Å were deposited on a glass substrate by sputtering process, respectively. Two kinds of CoFe films were studied: one was the as-deposited film, and the other the annealed film. The annealing procedure was to keep the films at 400 °C for 5 h in a vacuum of 5×10⁻⁶ mbar. From the X-ray study, we find that the as-deposited film prefers the CoFe(1 1 0) orientation. Moreover, the body-centered cubic (bcc) CoFe(1 1 0) line is split into two peaks: one corresponding to the ordered body-centered tetragonal (bct) phase, and the other, the disordered bcc phase. After annealing, the peak intensity of the ordered bct phase becomes much stronger, while that of the disordered bcc phase disappears. The annealing has also caused the ordered CoFe(2 0 0) line to appear. When the amount of the ordered bct phase in Co₅₀Fe₅₀ is increased, the saturation magnetization (M_s) and coercivity (H_c) become larger, but the electrical resistivity (ρ) decreases. From the temperature coefficient of resistance (TCR) measurement, we learn that the bct grains in the CoFe film start to grow at temperature 82 °C.     

N-Widths and Average Widths of Besov Classes in Sobolev Spaces

In this paper, we consider the n-widths and average widths of Besov classes in the usual Sobolev spaces. The weak asymptotic results concerning the Kolmogorov n-widths, the linear n-widths, the Gel＇fand n-widths, in the Sobolev spaces on T^d, and the infinite-dimensional widths and the average widths in the Sobolev spaces on Ra are obtained, respectively.     

Determination of gold in ore by flame atomic absorption spectrometry with flow-injection on-line sorbent extraction preconcentration

Gold in ores was determined by flame atomic absorption spectrometry following on-line preconcentration by sorbent extraction in a flow-injection system. The medium polarity adsorption resin Amberlite XAD-8 packed in a 220-μl micro-column was used to collect gold(III) from hydrochloric acid sample solutions for 40 s at 7.6 ml/min. Ethanol was used to elute the adsorbed analytes into the nebulizer. Optimization studies were made on sample loading rate, elution rate and sample acidity. Some possible interferences on the determination are discussed. A 35-fold enrichment was achieved at a sampling frequency of 60 h^?1 and with an RSD of 1.4%. The detection limit (3σ) and 2 μg l^?1. Results for gold in ore samples showed good agreement with those obtained using activated carbon adsorption preconcentration. The recoveries were 97–108%.