Determination of protoapigenone in rat plasma by high‐performance liquid chromatography with UV detection and its application in pharmacokinetic studies

A simple and sensitive HPLC method using UV detection was developed to determine the concentration of protoapigenone in rat plasma. Chromatographic separation was conducted on a C₁₈ column with a mobile phase consisting of an acetonitrile–methanol–aqueous phase (containing 0.2% acetic acid, pH 3.0) system at a flow rate of 1.0 mL/min. The UV detector was set at 248 nm. The calibration curve was linear over the range of 0.031–10.0 µg/mL. The lower limit of quantification was 31 ng/mL. The recoveries for plasma samples ranged from 70.3 to 82.5%. The intra‐ and inter‐day accuracy and precision fulfilled the international standards. This method was successfully applied to a pharmacokinetic study of protoapigenone in rats after oral administration of protoapigenone. It was shown that protoapigenone could be absorbed rapidly after oral administration and could reach the maximum concentration within 1 h. Copyright © 2013 John Wiley & Sons, Ltd.     

Simulation of a 2-site Langmuir model for characterizing the sorption capacity of Cs and Se in crushed mudrock under various ionic strength effects

The sorption capacity of cesium (Cs) and selenium (Se) in crushed mudrock was demonstrated in this study through a 2-site Langmuir model. To employ such a numerical analysis, batch tests were applied in this study in synthetic seawater and groundwater with sorption/desorption kinetic experiments (time-dependent) and different concentrations (10^?2–10^?7 M). The 2-site sorption models, which correspond to two rate constants (λ ₁ and λ ₂), might be more adequate than 1-site sorption models in characterizing Cs and Se sorption/desorption according to the least square errors between the numerical analysis and the results of the batch tests. The fitting results showed that a 2-site Langmuir model is capable of appropriately describing Cs and Se sorption in mudrock. Consequently, the sorption capacity was calculated at about 0.06 mol/kg for Cs and at 0.015 mol/kg for Se.     

An unusual substitution reaction of an aromatic sulfonic group based on 3-carbonyl-4-phenolsulfonic acid

An unusual substitution reaction of an aromatic sulfonic group based on 3-carbonyl-4-phenolsulfonic acid was discovered in a diazo-coupling process.The reaction occurred under mild reaction conditions (pH 8.0-9.0.0-5 C,solvent:water) within a short reaction time(1h).A plausible substitution reaction mechanism by phenol-ketone resonance was proposed.     

Hierarchical nanostructured composite cathode with carbon nanotubes as conductive scaffold for lithium-sulfur batteries

Carbon nanotubes (CNTs) are excellent scaffolds for advanced electrode materials, resulting from their intrinsic sp2 carbon hybridization, interconnected electron pathway, large aspect ratio, hierarchical porous structures, and low cost at a large-scale production. How to make full utilization of the mass produced CNTs as building blocks for nanocomposite electrodes is not well understood yet. Herein, a composite cathode containing commercial agglomerated multi-walled CNTs and S for Li-S battery was fabricated by a facile melt-diffusion strategy. The hierarchical CNT@S coaxial nanocables exhibited a discharging capacity of 1020 and 740 mAh g-1 at 0.5 and 2.0 C, respectively. A rapid capacity decay of 0.7% per cycle at the initial 10 cycles and a slow decay rate of 0.14% per cycle for the later 140 cycles were detected. Such hierarchical agglomerated CNT@S cathodes show advantages in easy fabrication, environmentally benign, low cost, excellent scalability, and good Li ion storage performance, which are extraordinary composites for high performance Li-S battery.     

三光气与酚制备三氯甲氧基甲酸芳酯研究

研究了不同取代酚与三光气的反应,得到七种未见报道的新化合物,以IR、MS、1H NMR、13C NMR对产物进行了表征,并探索得到合适的反应催化剂、反应物浓度配比、反应时间,讨论了酚上不同取代基对反应的影响,收率在78.5～90.5%之间。     

Diels–Alder dimerization of Morita–Baylis–Hillman acetates catalyzed by organocatalysts

DABCO-catalyzed dimerization of Morita–Baylis–Hillman acetates to synthesize a series of 3-alkyl-4-(E)-alkenyl-cyclohex-1-ene-1,4-dicarbonyl compounds in excellent yields with modest to excellent diastereoselectivity is reported. A plausible reaction mechanism is also proposed on the basis of previous literature and preliminary investigation the asymmetric version of the reaction.     

A modified procedure for synthesis of the side chain of ceftazidime-activated thioester

A modified procedure for synthesis of the side chain of ceftazidime-activated thioester has been established. This key intermediate of ceftazidime was obtained by a more eco-friendly process than conventional methods, and the yield was much higher (up to 92.4 %). It was found that different organic bases (triethylamine or pyridine) used in this reaction had different effects. The reaction conditions were also optimized to make the route more competitive and suitable for large-scale industrial production.     

一个吡啶二甲酸镉配位聚合物的合成、晶体结构及荧光性质

通过水热方法,采用H3CAM(H3CAM=4-hydroxy-pyridine-2,6-dicarboxylic acid)与Cd(NO3)2.4H2O反应,合成了1个镉配位聚合物[Cd4(HCAM)4(H2O)8]n(1),并对其结构和荧光性质进行了研究。结构分析结果表明该配合物属于单斜晶系,C2/c空间群。四个HCAM2-配体桥联4个镉离子形成了1个四核镉单元。这些孤立的单元通过氢键作用形成了1个三维配位框架。研究表明,该配合物在室温下能发出兰色荧光。     

Immobilized palladium on surface-modified Fe3O4/SiO2 nanoparticles: as a magnetically separable and stable recyclable high-performance catalyst for Suzuki and Heck cross-coupling reactions

A palladium-based catalyst (Fe₃O₄/SiO₂/HPG–OPPh₂–PNP) supported on chlorodiphenylphosphine-functionalized magnetic nanoparticles was successfully prepared from Fe₃O₄/SiO₂ with sequential attachment of glycerol and chlorodiphenylphosphine, followed by treatment of an ethanolic solution of palladium chloride with hydrazine. The as-prepared catalyst was characterized by ICP-AES, FTIR, XRD, SEM, and TEM. The Fe₃O₄/SiO₂/HPG–OPPh₂–PNP was found as a magnetically separable and highly active catalyst for Suzuki coupling reactions of aryl iodides, bromides, and chlorides as well as Heck reactions of aryl iodides and bromides. Under appropriate conditions, all reactions afforded the desired products in moderate to excellent yields. Moreover, this catalyst can be easily recovered by using a magnetic field and directly reused for at least six cycles without significant loss of its activity.     

Direct transition metal-free C-S bond formation: synthesis of 2-aminobenzothiazole derivatives via base-mediated approach

A general, efficient, and more practical protocol for the base-mediated intermolecular or intramolecular S-arylation leading to the 2-aminobenzothiazole derivatives is reported. Remarkably, all reactions were carried out under transition-metal-free conditions with good to excellent yields, rendering the methodology presented herein highly valuable from both environmental and economic points of view.