丙烯在ZSM-5沸石上齐聚反应的研究 Ⅰ. 模板剂用量对丙烯齐聚反应的影响

考察了不同正丁胺（NBA）模板剂用量合成ZSM-5沸石的物化特性和催化性能。采用XRD、SEM、NH3-TPD和BET等手段对合成样品的物化特性进行了表征。结果表明，模板剂与SiO2摩尔比在0.67～0.22时合成的ZSM-5沸石结晶度高于90%；随着模板剂用量的减少，ZSM-5沸石的平均粒径减小，强酸量也存在相同的趋势。丙烯齐聚反应评价结果显示,模板剂用量对合成ZSM-5沸石的催化活性有显著影响，模板剂与SiO2摩尔比在0.67～0.45之间合成的沸石催化性能较好。     

STUDIES ON POLYVINYL ALCOHOL CARRIERS Ⅲ. ACTIVE AMIDES AND ESTERS DERIVED FROM POLYVINYL ALCOHOL AND THEIR APPLICATION IN AFFINITY CHROMATOGRAPHY

Polyvinyl alcohol carriers bearing active amide and active ester groups were prepared by acetaliza-tion of granular macro-reticular water-insolub1e PVA with glyoxylic acid or p-formylbenzoic acidand further activation reaction with benzotriazole or N-hydroxysuccinimide using DCCI as con-densation agent. The active amides or active esters obtained were easy to react with amines suchas n-butylamine or proteins under mild condition. Ovomucoid, an inhibitor of trypsin was immo-bilized on the above-obtained reactive PVA carrier to give effective affinity adsorbent for the separa-tion or purification of trypsin.     

有机锡配合物[(o-Cl-PhCH2)2Sn(OCOC9H6N)2]·2(C6H6)的合成和晶体结构研究

0引言某些有机锡羧酸酯化合物具有杀虫、杀菌和抗癌活性,引起人们极大的兴趣[1~3]。近年来的研究结果表明,该类化合物中心锡原子的配位形式既决定于与锡原子直接相连的烃基的结构,也与配体的类型有关,尤其是含有孤电子对的杂环酸的引入,导致了许多新型结构有机锡化合物的产生[4     

脂肪酶催化水解反应纯化α-生育酚琥珀酸酯

α-生育酚琥珀酸酯（α-tocopherol succinate）是天然维生素E的衍生物，它是由琥珀酸与α-生育酚的β-色酮环的6位羟基成酯而形成的化合物（图1），由于丧失了自由的羟基而不具有维生素E的抗氧化活性，在空气中较为稳定，因其可保护α-生育酚的6位羟基，使α-生育酚在储存和运输中稳定性增加，而广泛用于α-生育酚的运输和储存。     

杂多阴离子[GeMo12O40]4-α/β异构体的密度泛函研究

采用密度泛函方法，在DND基组水平上，对[GeMo12O40]^4-杂多阴离子最常见的α和β异构体进行了几何构型优化，得到了与X射线晶体衍射实验结果相一致的结构参数，并在此基础上进行了振动频率分析，得到了杂多阴离子的电子结构、热力学特性和振动光谱，通过定义α，β异构体异构化反应的Gibbs函变△Gα-β与温度的关系，研究了这两种异构体的相对稳定性．结果表明：低温时α异构体更稳定，高温时β异构体更稳定些，550K左右为转变点．振动频率分析得到2种异构体的最强峰位于4个频率位置，分别指认为vax(Mo-Od)，vas(Mo-Od)，vas(Mo-Oc-Mo)，vas(Ge-Oa)，vas(Mo-Ob-Mo)振动，与红外光谱(IR)的特征振动峰相对应，观察到了特征频率的振动模式，从理论计算角度说明了Rocchiccioli—Deltcheff关于振动模式的设想是合理的．     

树脂吸附法处理水杨酸甲酯生产废水的研究

采用吸附树脂NDA—99处理水杨酸甲酯生产废水，结果表明该树脂时废水中的5磺基水杨酸及水杨酸均具有良好的吸附—脱附性能．废水经预处理和吸附处理后，CODCr由57000-59000mg／L降至6300mg／L左右，去除率接近89％．用IBV8％NaOH 3BVH2O作脱附剂，在温度为60℃、流量为IBV／h的条件下，脱附率接近100％，树脂可重复使用．高浓度脱附液经酸化、浓缩、冷却结晶，可回收5—磺基水杨酸，回收率为95％左右。纯度为78％。     

Preparation of Micron-size Functional Fluorescent Microspheres

As a kind of special functional microspheres, fluorescent polymer microspheres could be used in cell label and separation, blood flow assay, flow cytometer marking, chemical reaction assay,and in analyst of the transform and diffusion of particles in soil 1. However, one of the most important applications of fluorescent microspheres is in the high-throughput screening of drugs (HTS) 2. Through affinity interaction, radioactive ligands (latent drugs) are bound to fluorescent microspheres covered by receptor, and luminescence is produced by radioactivity, so ligands can be assayed and screened.In this study, we developed a technique for preparing micron-size fluorescent microspheres with different functional groups. The methods included the synthesis of micron-size polystyrene microspheres through the dispersion polymerization of styrene in different media such as ethanol,ethanol-water, and isopropanol; the functional polystyrene microspheres were prepared by introduction of functional monomers into the reaction system of styrene; the functional fluorescent microspheres were obtained by the way of dying functional microspheres in the fluorescent material's ethanol solvent.The average diameter of microspheres was in the range of 1～10 μm, and the distribution was normal distribution. The functional groups included -OH, -CHO, -COOH, -CONH2, and SO3H. The absorbing spectrum and exciting spectrum were tested, the results showed that the maximal absorbance of fluorescent microsphere was near 306.5 nm, and its maximal excitation was near 362 nm. The excitation spectrum of fluorescent material (DPO) and fluorescent microspheres were shown in figure 1, and it indicated that the developed fluorescent microspheres showed the same excitation behavior like DPO, which related to the fluorescent microspheres had stable luminescence property.     

TiO2光催化反应及其在环境保护中的应用

本文简要介绍了TiO2光催化剂的作用机理，讨论了影响TiO2光催化效率的因素及解决途径，综述了光催化在环境保护中的最新应用。     

快速响应的温敏性聚(N-异丙基丙烯酰胺)水凝胶 Ⅰ.以CaCO_3为成孔剂制备方法、表征及动力学研究

以不同粒径的CaCO3粒子为成孔剂 ,合成了快速响应的温敏性聚 (N 异丙基丙烯酰胺 ) (PNIPA)水凝胶 .利用扫描电镜观察到水凝胶具有特殊的孔状结构 ,得到水凝胶的孔径大小为几十微米左右 .动力学研究表明 ,该水凝胶在温敏膨胀或收缩时 ,具有快速的响应速率 ,在 10min内的失水率可达 90 % .比较了干凝胶和4 0℃下失水后的凝胶两种不同状态下水凝胶的膨胀曲线 ,发现两者的溶胀动力学曲线明显不同 ,前者的曲线有拐点 .同时发现与失水收缩速率相比 ,水凝胶具有较慢的吸水膨胀速率 .