Micromachining of circular ring microstructure by femtosecond laser pulses

In this paper, integration of interference phenomenon into femtosecond laser micromachining was reported as the femtosecond laser pulses were reshaped spatially to perform ablation. The generation of circular interference pattern was demonstrated by overlapping infrared femtosecond laser pulses. The interference pattern was subsequently focused on a copper substrate to ablate microstructures of concentric circular rings. The present technique is expected to open up new applications in the areas of rapid fabrication of micro-Fresnel lenses, hybrid microlenses and lens arrays.     

含气率对PTS时压力容器内流动与传热的影响

本文对反应堆压力容器紧急安注时的流动与传热特性在1/10的模型上进行了流动可视化、局部传热系数以及混合函数的试验研究。针对三个热冲击敏感区域的部分测点,比较了环腔流速为0.5m/s、安注流速为1～30 m/s时不同含气率对下降环腔内流动与传热特性的影响,得出并分析了不同测点传热系数、混合函数的变化规律。研究结果表明:随着含气率增大,安注流体与环腔流体的混合增强;下降环腔内的含气率对小安注流速时的流动与传热影响显著,而对大安注流速时影响较小。     

YBa2Cu3Oz超导体的低温稳定相

基于8点长方集团变分模型,并引入各向同性最近邻相互作用,以及各向异性次近邻相互作用,计算了YBa₂Cu₃O_z两Ba层间铜氧平面上□—O系统的有序—无序相变图,不仅在z=7.0附近得到具有超导电性的正交相,并且在z=6.5附近得到具有两倍晶格长度的另一种正交相(正交相Ⅱ)。 关键词：     

Optic Fiber Interferometer for Absolute Distance Measurement

1.IntroductionAbsolutedistancemeasurementisfarfromanewtopic.However,itisstillafieldstimulatinggreatinterestsnowadaysduetoitSimportantroleinmanufacturingandassembly['J.SincethegreatsuccessachievedbyMichelsonandBenoitwhentheyfirstdevelopedaninterferometertodeterminethestandardmeterintermsofthemonochromaticredcadmiumline,theopticinterferometerhasbeenprovedtobeoneofthemostpreciseandefficientwayindisplacementmeasurementbecauseofitshighdiscriminationandsimplestructure.However,thetraditionalinterfe…     

Comparative studies on the mechanism of uridine phosphorolysis

We have used quantum mechanical method to study the transition states(TSs) of uridine phosphorolysis reaction. Comparing the four different reaction pathways and the five transition states obtained, we conclude that enzymatic uridine phosphorolysis takes place mainly according to acid-catalyzed SN2 mechanism. The proposed reaction pathway is consistent with many experimental results.     

压力淬火过程中锗的相结构研究

 应用高压原位差热方法，直接测量了压力下锗的固化参数─—固化温度与过冷度。高压差热信号表明，当压力大于3 GPa时，锗在凝固过程中可能发生结构相变。X射线结构分析表明，在最终的样品中除GeⅠ相外，还形成GeⅢ相和GeⅣ相。     

离心力场作用下多孔介质中强制对流换热的研究

对离心流化床中空气通过多孔物料层的强制对流换热进行了理论和实验研究。获得了气流和物料间强制对流换热的准则关联式。研究结果表明,在气流速度和温度梯度方向一致的条件下,强制对流换热比通常的边界层强制对流换热有所强化,其换热的准则关联式具有 Nu=CRePr的线性形式。从而验证了改变气流方向和热流密度矢量之间夹角可以强化换热的这一强化传热新原理。     

固体间界面的物理模型和界面对声波的反射

简要描述了模拟两固体间界面特性的弹簧模型，该模型最早是根据静力学方法提出的，后来用固体间界面薄层的声波反射方法加以改进，从界面弹簧模型可以方便地得到界面外近似边界条件，其中包含界面“弹簧”振子的劲度常数和质量，文章还给出了两相间固体中界面声反射系数的表达式，介绍了测量界面劲度常数的超声反射谱方法。最后讨论了仍关声波与界面相互作用研究领域中最近的一些研究进展。     

Estimation of multivariate binary density using orthogonal functions

In this paper, the authors studied certain properties of the estimate of Liang and Krishnaiah (1985, J. Multivariate Anal. 16, 162–172) for multivariate binary density. An alternative shrinkage estimate is also obtained. The above results are generalized to general orthonormal systems.     

计量累积和控制图方案设计的选择

常规控制图已广泛应用于生产,国家标准<计数型累积和图>GB4887-85的实施,使得判断生产“过程”异常具有更高的灵敏度,能更经济地保证产品质量,它是常规控制图的改进与发展.在常规控制图中,为了使控制图能对小偏差有较快的反映,一般用缩小控制界线,如将3σ限改为2σ限,但会导致第一类误判率大大升高.而累积和方法可以通过对方案参数的适当选择使控制图在第一类误判率并不明显升高的情况下对小偏差反映敏感.此外,累积和方法还允许针对各种需要设计出特别适于发现某个偏差,例如1.5σ_e 的