分配问题的多角度分析

从数理逻辑、整数规划和博弈论三方面对分配问题进行分析,介绍不同的数学分支在分配问题中的应用.     

带凹性生产成本运输问题的新随机规划模型及其求解

提出了一种新的能反映决策者满意度的随机变量序关系,并据此研究了随机不等式的确定性等价类,方法被称为满意度方法.最后将其应用于带凹性生产成本运输问题的求解中,并将方法与常用的机会约束方法进行比较,说明满意度法不仅合理可行,而且当决策者对约束条件的要求越高时,它所得最优值越优于机会约束法所得最优值.     

MgF2对Mn4+掺杂锗酸盐红色荧光粉发光的影响

3.5MgO·0.5MgF₂·GeO₂∶Mn⁴⁺作为优异热稳定性和良好发光性能的红色荧光粉而被市场应用,然而,该粉体中MgF₂的作用影响机理尚不明晰,阻碍其性能进一步优化和发展。采用高温固相法制备了系列Mn⁴⁺激活的锗酸盐荧光粉,通过对比加入MgF₂、H₃BO₃(助熔剂),研究了该粉体的结构、形貌、发光性能等变化规律,阐明了MgF₂的发光影响作用。研究表明,加入MgF₂、H₃BO₃和不加任何助熔剂时的样品,其最佳烧结温度分别为1 150、1 250和1 350 ℃,上述温度下发光强度均为最佳值,其中加入MgF₂、H₃BO₃的样品在最佳温度处生成了纯相。MgF₂的添加,一方面同H₃BO₃一样作为助熔剂对生成纯相、提高样品结晶度起了积极的作用;另一方面,通过研究分析,确认F^-离子成功掺杂进入晶格,促使样品生成的晶体结构为Mg₁₄Ge₅(O,F)₂₄。加入MgF₂、H₃BO₃在最佳烧结温度的样品的荧光寿命分别为0.93和0.75 ms。     

顶空气相色谱法测定瑞替加滨原料药中残留溶剂

建立了测定瑞替加滨原料药中残留溶剂乙醇、正己烷、四氢呋喃、三乙胺的顶空气相色谱方法。采用氢火焰离子化检测器,以N,N-二甲基甲酰胺为样品溶剂,通过对色谱条件优化,建立了以DB-624为分析柱、110℃为平衡温度、15 min为平衡时间的残留溶剂测定方法。经方法学验证,上述4种溶剂的方法检出限依次为0.007 5%、0.000 48%、0.002 4%、0.01%;峰面积的相对标准偏差均小于2.1%;平均回收率为100%～102%;4种溶剂的线性系数均大于0.995。结果表明,该方法的检测灵敏度高、精密度好、准确度高、线性关系良好,能够满足对瑞替加滨质量的控制要求。将该方法应用于3批瑞替加滨原料药的残留溶剂检测,均只检出乙醇和正己烷,且乙醇和正己烷的最高残留量分别为0.149%和0.022%,均未超出限量规定。     

Application of supercritical fluid extraction coupled with counter–current chromatography for extraction and online isolation of unstable chemical components from Rosa damascena

Supercritical fluid extraction (SFE) coupled with high‐speed counter‐current chromatography (HSCCC) was successfully used for the extraction and online isolation of the unstable compounds from Rosa damascene in a single extraction and separation operation in two stages. The solvent systems of SFE/HSCCC were optimized with the help of multiexponential function model. At the first stage, the upper phase of the solvent system of n‐butanol–tert‐butyl methyl ether–acetonitrile–0.1% aqueous TFA (1.7:1.0:0.8:4.0, v/v/v/v) was used as both the SFE entrainer and the HSCCC stationary phase, and the target compounds were eluted with the corresponding lower phase to separate the hydrophobic compounds. At the second stage, the upper phase of the solvent system of n‐hexane–ethyl acetate–methanol–water (3.2:1.0:2.8:2.6, v/v/v/v) was used as both the SFE entrainer and the HSCCC stationary phase, followed by elution with the corresponding lower phase to separate the moderate hydrophobic compounds. Six compounds including formononetin, delphinidin, cyaniding, 5,6,4′‐trihydroxy‐7,8‐dimethoxy flavone, 5,3′‐dihydroxy‐7,8‐dimethoxy flavone, and 5‐hydroxy‐6,7,8,3′,4′‐pentamethoxy flavone were successfully separated in one extraction–separation operation within 300 min. The targeted compounds were identified by MS and NMR spectroscopy. This research has opened up great prospects for industrial application of SFE/HSCCC to the extraction and separation of unstable compounds.     

介孔Co-Al2O3催化剂上甲烷部分氧化制合成气

采用一锅法制备了介孔Co-Al2O3催化剂,并首次用于甲烷部分氧化制合成气反应. 结果表明,与普通浸渍法相比,一锅法制备的Co-Al2O3催化剂表现出更为优异的催化性能. 合成的介孔Co-Al2O3催化剂具有大的比表面积和孔体积,以及规整有序的六方介孔孔道,Co物种高度分散,从而导致还原后高的金属分散度,而介孔孔道对金属纳米颗粒的约束作用可有效增强金属的抗烧结能力.     

Synthesis of LiNi1/3Co1/3Mn1/3O2 cathode material by a modified sol–gel method for lithium-ion battery

LiNi_1/3Co_1/3Mn_1/3O₂ was prepared by a modified sol–gel method, selecting ethylene diamine tetraacetic acid and citric acid as the co-chelating agent. The mole ratios of ethylene diamine tetraacetic acid (EDTA) to metal ion (Mⁿ⁺) were 0:1, 1:1 and 2:1. The obtained samples were characterized by XRD, BET and SEM. The XRD showed that LiNi_1/3Co_1/3Mn_1/3O₂ had good crystallinity and well-ordered layered structure. After calcined at 850 °C, the LiNi_1/3Co_1/3Mn_1/3O₂ particles exhibited a three-dimensional space network structure, which was greatly correlated with the ratio of EDTA to metal ion. The LiNi_1/3Co_1/3Mn_1/3O₂ obtained from a mole ratio of 1:1 (EDTA:Mⁿ⁺) had the best electrochemical performance. The reversible capacities were reached 168 and 100 mAh/g at 1C and 10C discharge rate, respectively. The result of the cycling performance showed a high capacity maintenance ratio of 89.3 % at 1C and 25 °C after 50 cycles. The further electrochemical performance was evaluated by electrochemical impedance spectroscopy and cyclic voltammetry.     

导数同步荧光法同时测定吲哚-3-乙酸和萘氧乙酸

采用荧光光谱法同时测定混合物体系中萘氧乙酸(BNOA)和吲哚-3-乙酸(IAA)两种植物激素。在pH 8.5的条件下,以水为溶剂,选择Δλ=100 nm,在200～500 nm的波长范围对两者的混合物进行了同步荧光光谱扫描,并做一阶导数处理,对其进行定量分析。BNOA和IAA的线性范围是0.01～0.3μg/mL和0.045～0.64μg/mL,检出限分别为0.003μg/mL和0.012μg/mL。方法用于果蔬中BNOA和IAA的同时检测,效果良好。该法可作为植物激素快速检测方法。     

Adsorptive removal of La(III) from aqueous solutions with 8-hydroxyquinoline immobilized GMZ bentonite

Due to the low permeability, high swelling capacity and good retardation properties, bentonite has been considered as the main component of buffer/backfill material for high level radioactive wastes repository all over the world. The adsorptions of metal ion were widely investigated recently. In this presentation, we provide an easy-to-use method to immobilize 8-hydroxyquinoline onto the surface of bentonite for the use of adsorption studies of La(III) from the aqueous solution. The effects of various parameters such as contact time, pH of the solution, ionic strength and metal ion concentration on the adsorption were investigated by the batch experiments. The biggest adsorption capacity is 41.7 mg/g, higher than the value reported by our previous work which is performed by the raw bentonite. Langmuir isotherm fits the experimental data well and the adsorption follows pseudo-second-order kinetic model. In summary, 8-hydroxyquinoline immobilized GMZ bentonite is an effective adsorbent for the removal of La(III) from aqueous solutions.     

水下超疏油聚(3,4-乙烯基二氧)噻吩薄膜的制备简

以离子液体溴化(1-己基-3-甲基咪唑盐)作为电解质和掺杂剂采用电化学一步法制备了微纳米复合结构的聚(3,4-乙烯基二氧噻吩)薄膜,薄膜由槽内排布着纳米珠链的棒状结构组成. 研究表明,通过控制电流密度的大小,可以调节棒状结构和珠状结构的平均直径. 离子液体中的咪唑阳离子和对阴离子均掺杂到聚合物中,该薄膜具有可逆的电化学活性及水下超疏油特性.