Modelling pH-Dependent and Microstructure-Dependent Streaming Potential Coefficient and Zeta Potential of Porous Sandstones

In this paper, we have significantly modified an existing model for calculating the zeta potential and streaming potential coefficient of porous media and tested it with a large, recently published, high-quality experimental dataset. The newly modified model does not require the imposition of a zeta potential offset but derives its high salinity zeta potential behaviour from Stern plane saturation considerations. The newly modified model has been implemented as a function of temperature, salinity, pH, and rock microstructure both for facies-specific aggregations of the new data and for individual samples. Since the experimental data include measurements on samples of both detrital and authigenic overgrowth sandstones, it was possible to model and test the effect of widely varying microstructural properties while keeping lithology constant. The results show that the theoretical model represents the experimental data very well when applied to model data for a particular lithofacies over the whole salinity, from 10^?5 to 6.3 mol/dm³, and extremely well when modelling individual samples and taking individual sample microstructure into account. The new model reproduces and explains the extreme sensitivity of zeta and streaming potential coefficient to pore fluid pH. The low salinity control of streaming potential coefficient by rock microstructure is described well by the modified model. The model also behaves at high salinities, showing that the constant zeta potential observed at high salinities arises from the development of a maximum charge density in the diffuse layer as it is compressed to the thickness of one hydrated metal ion.     

Force Chain Characteristics and Effects of a Dense Granular Flow System in a Third Body Interface During the Shear Dilatancy Process

In order to investigate the characteristics of force chains in a granular flow system, a parallel plate shear cell is constructed to simulate the shear movement of an infinite parallel plate and observe variations in relevant parameters. The shear dilatancy process is divided into three stages, namely, plastic strain, macroscopic failure, and granular recombination. The stickslip phenomenon is highly connected with the evolution of force chains during the shear dilatancy process. The load–distribution rate curves and patterns of the force chains are utilized to describe the load-carrying behaviors and morphologic changes of force chains separately. Force chains, namely, “diagonal gridding,” “tadpole-shaped,” and “pinnate” are defined according to the form of the force chains in the corresponding three stages.     

Logarithmic Regge pole

This work presents the subtraction procedure and the Regge cut in the logarithmic Regge pole approach. The subtraction mechanism leads to the same asymptotic behavior as previously obtained in the non-subtraction case. The Regge cut, in contrast, introduces a clear role to the non-leading contributions for the asymptotic behavior of the total cross-section. From these results, some simple parameterization is introduced to fit the experimental data for the proton-proton and antiproton-proton total cross-section above some minimum value up to the cosmic-ray. The fit parameters obtained are used to present predictions for the \begin{document}$ \rho(s)$\end{document} -parameter as well as to the elastic slope \begin{document}$ B(s)$\end{document} at high energies.     

Teaching the Chemistry of Platinum

Following colonisation of South America by the Spanish, many new naturally occurring substances were sent to Europe. One of these was the silvery, unreactive metal, platinum, discovered in New Grenada in the mid-eighteenth century. It was often found in granular form, associated with gold, and the challenge to chemists was to refine it, produce it as wire or sheet, and determine its chemical properties. This interested the professor of chemistry at the University of Edinburgh, Joseph Black, who was able to obtain samples from London-based Spanish contacts, particularly Ignacio Luzuriaga. This paper examines how Black transmitted his knowledge of the metal to large numbers of students attending his annual course.