Surface-enhanced Raman spectra study of metal complexes of N-D-glucosamine beta-naphthaldehyde and glycine and their interaction with DNA

Copper(II), zinc(II), cobalt(II) and cobalt(III) complexes of N-D-glucosamine beta-naphthaldehyde (C17H19O6N, NG) and glycine were synthesized. The four novel metal complexes, Cu(II)C19H28O11N2(CuGNG), Zn(II)C19H24O9N2 (ZnGNG), Co(II)C19H28O11N2(Co(II)GNG) and Co(III)C21H29O12N2(Co(III)GNG) were characterized by means of infrared (IR), electronic absorption spectroscopy and NMR etc. The surface-enhanced Raman spectra of the four complexes and their interaction with DNA were studied. By comparison of the surface-enhanced Raman spectra (SERS), the information of the four complexes' SER active sites and adsorption orientation were obtained. Combined with fluorescence spectra of Ethidium bromide (EthBr) DNA system, we concluded that none of the four complexes intercalate into DNA and that the presence of the glycine ligand lowered the anticancer activity of NG series complexes.     

Extraction and Mutual Separation of Actinide(III), (IV), (V) and (VI) Ions by N,N′-Dimethyl-N,N′-Dihexyl-3-Oxapentanediamide and Thenoyltrifluoroacetone

Actinide(III), (IV), (V) and (VI) ions were extracted by N,N-dimethyl-N,N-dihexyl-3-oxapentanediamide (DMDHOPDA) and thenoyltrifluoroacetone (HTTA). The extraction behaviors suggested the possibility of the mutual separation, and the convenient separation method of actinide ions (III), (IV), (V) and (VI) without reducing and oxidizing agents was studied. Th(IV) was extracted from the aqueous phase by HTTA (5 mM in toluene) in the first step. The Am(III) and U(VI) ions can be extracted by 1 and 20 mM DMDHOPDA in toluene, and the Np(V) ion can be extracted into nitrobenzene with 100 mM DMDHOPDA in the last step. The residual activities in the aqueous phase were much lower than the initial activities. These activities in the fractions were confirmed by the gamma- and the alpha-spectrometry. The one-through and rough separation is advanced, and in case of the fine isolation of actinide elements, each fraction should be purified in more detail.     

The constituents of the root and stem of Aristolochia heterophylla Hemsl

Seven new compounds, sodium aristolochate-VII (1), aristolactam-CIV (2), madolin-I (3), -J (4), -K (5), -L (6) and -M (7) together with 71 known compounds were isolated and characterized from the fresh root and stem of Aristolochia heterophylla Hemsl. Their structures were determined by spectral methods. Compound 8 was revised as aromadendrane-4beta, 10beta-diol by spectral data and single-crystal X-ray analysis.     

Proteomic analysis of simulated occupational jet fuel exposure in the lung

We analyzed protein expression in the cytosolic fraction prepared from whole lung tissue in male Swiss-Webster mice exposed 1 h/day for seven days to aerosolized JP-8 jet fuel at concentrations of 1000 and 2500 mg/m3, simulating military occupational exposure. Lung cytosol samples were solubilized and separated via large scale, high resolution two-dimensional electrophoresis (2-DE) and gel patterns scanned, digitized and processed for statistical analysis. Significant quantitative and qualitative changes in tissue cytosol proteins resulted from jet fuel exposure. Several of the altered proteins were identified by peptide mass fingerprinting, confirmed by sequence tag analysis, and related to impaired protein synthetic machinery, toxic/metabolic stress and detoxification systems, ultrastructural damage, and functional responses to CO2 handling, acid-base homeostasis and fluid secretion. These results demonstrate a significant but comparatively moderate JP-8 effect on protein expression and corroborate previous morphological and biochemical evidence. Further molecular marker development and mechanistic inferences from these observations await proteomic analysis of whole tissue homogenates and other cell compartment, i.e., mitochondria, microsomes, and nuclei of lung and other targets.     

An improved apparatus for the determination of krypton-85 and xenon-133 in an emergency situation

A simple and portable apparatus was developed for measurements of⁸⁵Kr and¹³³Xe that would be released into the atmosphere in an emergency situation of nuclear facilities. The method is based on cryogenic adsorption of these gases on charcoal followed by chromatographic separation from other gases. The⁸⁵Kr and¹³³Xe recovered from atmospheric air are determined separately by liquid scintillation counting. It takes about 1 hour for the stepwise determination of⁸⁵Kr and¹³³Xe. The atmospheric concentration of 3·10^–3 Ci per m³ air (1.1·10² Bq/m³ air) is measurable for both nuclides with 20% counting error.     

Determination of methylated dibenzothiophenes in environmental sarnples by on-line HPLC-CGC

Concurrent solvent evaporation with a loop-type interface was used for on-line HPLC-CGC in the analysis of methylated dibenzothiophene (DBT) isomers in oil samples. The chromatographic behavior of 20 methyl DBT's was studied by HPLC on an aminopropylsilane DBTA phase and by GC on a selective methyl-phenylsilicone phase. That provided a method for analyzing by GC-flame photometric detection, the individual components of the DBT family, previously picked out of the crude oil matrix by HPLC. The GC oven temperature was shown to be critical during HPLC eluent introduction into the GC pre-column. Too high a temperature induced a severe broadening of early eluted peaks whereas a temperature too close to the boiling point of the liquid at the inlet pressure induced double peaks. Optimized conditions were retained on this basis and may be used for the analysis of other families of polyaromatic hydrocarbons.     

Improvement of chemical analysis of antibiotics. X. Determination of eight tetracyclines using thin-layer and high-performance liquid chromatography

Analytical methods for eight tetracyclines (TCs) were established using silica gel high-performance thin-layer chromatography (HPTLC), reversed-phase thin-layer chromatography (RP-TLC) and high-performance liquid chromatography (HPLC). Good separations of eight TCs were obtained using chloroform-methanol-5% disodium ethylenediaminetetraacetate solution (65:20:5) (lower layer) and methanol acetonitrile 0.5 M oxalic acid solution (1:1:4) (pH 3.0) on silica gel HPTLC and C8 TLC plates, respectively. A combination of HPTLC and RP-TLC made possible the identification of the eight TCs. Each calibration graph was linear between 0.1 and 1.0 microgram using UV densitometry except for rolitetracycline. For detection reagents, the diazonium salts including Fast Violet B gave variously coloured spots with the eight TCs and good sensitivities were obtained except with minocycline. In HPLC, the simultaneous analysis of the eight TCs on a C8 column was possible using methanol-acetonitrile-0.01 M oxalic acid solution (1:1.5:7) adjusted to pH 3.0 as the mobile phase. A linear relationship was obtained between 1.0 and 10 ng using the usual sample preparation except for rolitetracycline. The direct determination of rolitetracycline was possible using tetrahydrofuran, dimethyl sulphoxide and the mobile phase as solvents for preparation of the sample. For the determination of residual rolitetracycline, it was effective to measure the amount of rolitetracycline as tetracycline by HPLC, HPTLC and RP-TLC after conversion of rolitetracycline to tetracycline by incubating for 5 min in methanol at 50 degrees C.     

BDMA-catalyzed DDA-epoxy resin system: Temperature and composition effects on curing mechanism

DSC and IR data on benzyldimethylamine-catalyzed dicyandiamide-DGEBA prepolymer system have been utilized to investigate the influences of temperature and composition on the curing mechanism. Etherification as a competitive reaction is favored at lower temperature. On the other hand, the reaction pathway of dicyandiamide (DDA) varies with temperature, especially at the first stage of reaction. At 100°C, the reaction of DDA is shown to be essentially the substitution of the hydrogen atoms by ring-opening of epoxy groups, giving rise to N-alkyl cyanoguanidine. But at 140°C or 160°C, the initial reaction of DDA involves a transformation of nitrile groups to imine groups. A greater amount of BDMA and a higher amine-to-epoxy ratio favor the etherification. The glass transition temperature T_g is a complex function of these different mechanisms; higher T_g could be reached with a amino-to-epoxy ratio equal to 0.6 and after a curing cycle including a precure at 100°C.