Production of bulk dilute ferromagnetic semiconductor by mechanical milling

We tried to prepare the bulk dilute ferromagnetic semiconductor (DMS) by mechanical milling (MM). Experimental results were as following: (1) The observation of X-ray diffraction and transmitting electron microscopy showed that the particle diameter of host ZnO powder were reduced to about 10 nm by MM. (2) The MM for the mixtures of V₂O₅/ZnO or γ-Fe₂O₃/ZnO realizes the V- or Fe-doped ZnO nano-powders. (3) The values of magnetization under the field of 5 kOe were nearly saturated to 0.8×10⁻³ to 3×10⁻³ μ_B/V-ion for V_xZn_1−xO (x=0.05, 0.1 and 0.2), and 0.2–0.3 μ_B/Fe-ion for Fe_xZn_1−xO (x=0.05 and 0.1) at room temperature. The above results show that the ferromagnetic DMS powder of V_xZn_1−xO and Fe_xZn_1−xO were successfully prepared by MM method.     

Epitaxial growth of 4H–SiC{0001} and reduction of deep levels

Homoepitaxial growth of 4H–SiC{0001} by hot-wall chemical vapor deposition (CVD) and characterization of deep levels in both n- and p-type epilayers have been investigated. On 4 off-axis 4H–SiC(0001), formation of macrosteps can be reduced by decreasing the C/Si ratio during CVD, though the growth condition leads to the increase in nitrogen incorporation. The 4H–SiC() face is promising, owing to its very smooth surface morphology even on 4 off-axis substrates and to its superior quality of the oxide/SiC interface. Deep level transient spectroscopy measurements in the wide temperature range from 100 K to 820 K on both n- and p-type 4H–SiC epilayers have revealed almost all the deep levels located in the whole energy range of the bandgap. Thermal annealing at 1350–1700 C of epilayers has resulted in reduction of deep level concentrations by one order of magnitude.     

Observation of light propagation across a 90 degrees corner in chains of microspheres on a patterned substrate

To demonstrate light-path manipulation in arbitrary shapes we fabricated coupled-resonator optical waveguides (CROWs) having a 90 degrees-corner structure on a lithographically patterned substrate. The spectra of propagation light within the CROWs were directly measured by guide-collection-mode near-field scanning optical microscopy. The spectra revealed that the propagation light through the CROWs has a larger transverse-magnetic polarization mode than a transverse-electric (TE) one. The most plausible cause of the lower intensity in the TE mode is that light leaks out to the Si substrate.     

Selective synthesis of novel cyclic phenylazomethine trimers

Novel cyclic phenylazomethine trimers (CPAs) were synthesized in a one-step dehydration of the 4-aminobenzophenone derivatives in the presence of TiCl(4) or p-toluenesulfonic acid (PTS). The CPAs were isolated in over 90% yield under nondilute conditions. When using TiCl(4) as the dehydration agent, the induction of bulky substituents at the alpha-position of the substrate enhanced the yields of the CPAs. On the other hand, PTS served as an effective catalyst for the synthesis of the phenyl-substituted CPA. This different reactivity between TiCl(4) and PTS depends on the dehydration mechanism being dominated by a kinetic process or thermodynamic one. The obtained CPAs were confirmed by NMR, UV-vis spectra, and MM2 calculation to have only a Z conformation and a nonconjugated structure compared to the linear oligophenylazomethines (OPAs) and the aniline-capped OPAs (OPA's).     

Achieving high time-resolution with a new flow-through type analyzer for total inorganic carbon in seawater.

A fully automated, continuous-flow-through type analyzer was developed to observe rapid changes in the concentration of total inorganic carbon (CT) in coastal zones. Seawater and an H3PO4 solution were fed into the analyzer's mixing coil by two high-precision valveless piston pumps. The CO2 was stripped from the seawater and moved into a carrier gas, using a newly developed continuous-flow-through CO2 extractor. A mass flow controller was used to assure a precise flow rate of the carrier gas. The CO2 concentration was then determined with a nondispersive infrared gas analyzer. This analyzer achieved a time-resolution of as good as 1 min. In field experiments on a shallow reef flat of Shiraho (Ishigaki Island, Southwest Japan), the analyzer detected short-term, yet extreme, variations in CT which manual sampling missed. Analytical values obtained by the analyzer on the boat were compared with those determined by potentiometric titration with a closed cell in a laboratory: CT(flow-through) = 0.980 x CT(titration) + 38.8 with r2 = 0.995 (n = 34; September 1998).     

Influence of temperature variation on field effect transistor properties using a solution-processed liquid crystalline semiconductor,C8BTBT

In this study, we used a LC semiconductor, C₈BTBT, solution (e.g. 0.1 wt % in heptane) for forming an organic semiconductor layer by casting method, and fabricated bottom-gate/bottom-contact type FETs. The FETs mobility was determined 0.17 cm² V^?1 s^?1 which was comparable to that determined by time-of-flight technique in a sandwich type cell at room temperature. We have investigated the surface morphology and the influence of temperature variation on FET properties. The LC FET mobility was kept below 60°C and drastically decreased after heat stress above 100°C irreversibly.     

Synthesis of imidazo[4,5-c]pyridines with a trifluoromethyl group at C-4 and/or C-6

Thermal condensation of histamine with trifluoroacetaldehyde gives 4-(trifluoromethyl)spinacamine and subsequent dehydrogenation with selenium dioxide leads to 4-(trifluoromethyl)-1H-imidazo[4,5-c]pyridine (42%). Fluorination with sulfur tetrafluoride of L-spinacine, obtained from the condensation of L-histidine with formaldehyde, affords 6-(trifluoromethyl)spinacamine, which can be converted to 6-(trifluoromethyl)-1H-imidazo[4,5-c]pyridine with selenium dioxide (49%). Application of the sequential reactions to 4-(trifluoro-methyl)-L-spinacine gives 4,6-bis(trifluoromethyl)-1H-imidazo[4,5-c]pyridine. Dehydrogenation of the tetrahydropyridine ring also occurred during the fluorination with sulfur tetrafluoride.