Bestimmung des Aluminiums in niedrig- und hochlegierten Stählen,in Erzen und Schlacken durch Atomabsorption

The measurement is carried out of aqueous solutions. The burner is supplied with a mixture of acetylene and nitrous oxide. Interfering influences by acid and iron concentrations of the sample solution as well as by organic solvents are shown. The standard deviation is ± 0.001%. The agreement with conventional analysis methods is very good. By this procedure a rapid and safe determination of aluminium will be possible.     

Fluorescence spectroscopy for monitoring deterioration of extra virgin olive oil during heating

The potential of fluorescence spectroscopy for characterizing the deterioration of extra virgin olive oil (EVOO) during heating was investigated. Two commercial EVOO were analysed by HPLC to determine changes in EVOO vitamin E and polyphenols as a result of heating at 170°C for 3 h. This thermal oxidation of EVOO caused an exponential decrease in hydroxytyrosol and vitamin E (R²=0.90 and 0.93, respectively) whereas the tyrosol content was relatively stable. At the same time, amounts of preformed hydroperoxides (ROOH), analysed by an indirect colorimetric method, decreased exponentially during the heating process (R²=0.94), as a result of their degradation into secondary peroxidation products. Fluorescence excitation spectra with emission at 330 and 450 nm were recorded to monitor polyphenols and vitamin E evolution and ROOH degradation, respectively. Partial least-squares calibration models were built to predict these indicators of EVOO quality from oil fluorescence spectra. A global approach was then proposed to monitor the heat charge from the overall fluorescence fingerprint. Different data pretreatment methods were tested. This study indicates that fluorescence spectroscopy is a promising, rapid, and cost-effective approach for evaluating the quality of heat-treated EVOO, and is an alternative to time-consuming conventional analyses. In future work, calibration models will be developed using a wide range of EVOO samples.     

Chemoselective Removal of Protecting Groups from O-Glycosyl Amino Acid and Peptide (Methoxyethoxy)ethyl Esters Using Lipases and Papain

The selective C-terminal deprotection of O-glycopeptide (methoxyethoxy)ethyl esters is achieved under mild conditions (pH 6.6, 37 degrees C) by enzymatic hydrolysis using papain or lipase M from Mucor javanicus to give building blocks useful for chain-extending glycopeptide synthesis. On the other hand, the selective removal of acetyl protecting groups from the saccharide portion of glycopeptides is accomplished by alternative enzymatic hydrolysis with lipase WG from wheat germ to furnish model substrates for enzymatic glycosyl transfer reactions in order to extend the carbohydrate side chain of these conjugates.     

Influence of structural changes on the ion selectivities of magnesium ionophores based on malonic acid diamides

In an investigation of octamethylene bis(malonic acid diamides) and their selectivities for magnesium, it was found that presence of secondary amides within the particular ionophore played a considerable role in the enhancement of magnesium selectivity. Similar effects in other ionophores, i.e. tris(malonic acid diamides), were thus systematically looked at with the help of selectivity measurements with the hope of optimizing the number of secondary and tertiary amides so as to improve the magnesium selectivity. The syntheses of several investigated tris(malonic acid diamide) isologues are equally reported.Deceased in November 1992     

Solvent triggering between conformational states in amphiphilic shape-persistent macrocycles

The amphiphilic shape-persistent macrocycle 1 containing four phenol-OH groups as polar side groups and four hexyloxy groups as nonpolar side groups in an adaptable arrangement was recrystallized from solvents of different polarity. X-ray crystallography reveals that the conformation of the macrocycle is solvent dependent such that in the pyridine solvate only two of the nonpolar side groups point outward while in the THF solvate all four of them point outward. Moreover, in the latter case the three-dimensional packing leads to the formation of a supramolecular channel structure with a large pore size.     

Kompressionsverhalten und Gleichgewichtsspreitungsdrucke binärer monomolekularer Dipalmitoylkephalin/Dimyristoylkephalin-Mischungen

1. The concentration dependence of theF/A-isotherms (premixed spreading, separate spreading) and the equilibrium spreading pressuresF ^e of the system dipalmitoylcephaline/dimyristoyl-cephaline were studied atT=298 K. The results were analysed and compared by means of thermodynamics with respect to miscibility of the components.
2. The spreading technique (pre-mixed spreading, separate spreading (with and without barrier), does not essentially influence the run of theF/A-isotherm. Alone, the collaps pressuresF _K differ.
3. The concentration dependence of theF/A-isotherms of premixed spread monolayers is analysed in terms of theA-x ^σ-diagram. The additivity of molecular areas at all surface pressures are assumed to indicate complete miscibility of the cephalins.
4. The phase rule according to Crisp was applied to analyse the spreading diagram in connection with the phase diagram of the mixtures in bulk. The results show that the cephalins are completely miscible in the monolayer.
5. The experimental collaps pressuresF _K of pre-mixed spread monolayers are very much larger than the equilibrium collapse presuresF _K calculated according to Garrett. The difference indicate the strong supercompression of mixed film during the compression.

     

Radiometric titration based on colloidal and slow precipitate formation

Fluoride ions and, in about 0.005M concentration, tungstate ions form gelatinous precipitates, poorly soluble in water, with calcium ions. The radiometric determinations of the above ions are based on these reactions. Accurate radiometric determination can be carried out only if the gelatinous precipitate formed during titration can be properly separated from the solution. It has been found that in the case of fluoride ions the application of crystalline, easily filtrable Ca(COO)₂·H₂O or CaCO₃, and in the case of tungstate ions the application of CaWO₄ precipitate improves the filtration properties of⁴⁵CaF₂ and⁴⁵CaWO₄, respectively, formed during titration, whereby the radiometric determinations of the above ions become possible. Titrations were carried out with 0.05M and 0.005M CaCl₂ solutions, labelled with⁴⁵Ca.     

Corrosion-stable nickel- and cobalt-based alloys for dental applications

In a comparative study the in vitro corrosion behavior of a selection of nickel- and cobalt-based alloys for application in dentistry containing no noble metals was studied with slow scan cyclic voltammetry. The obtained breakthrough potentials, the repassivation behavior and further typical features of the cyclic voltamograms are correlated with the chemical composition as measured with electron beam microanalysis. Surface inhomogenities detected with the latter method are discussed with respect to the electrochemical behavior. For all alloys stabilities in terms of breakthrough potential superior to previously reported data for nickel-base alloys are found.     

Synthesis of 11C-amides using [11C]carbon monoxide and in situ activated amines by palladium-mediated carboxaminations

[11C]Carbon monoxide at low concentrations, aryl halides and amines were used in the palladium-mediated synthesis of twenty 11C-amides. In the study several approaches to improve the radiochemical yield were explored. Eight of the selected amides were prepared by in situ activation of the amines using lithium bis(trimethylsilyl)amide and the radiochemical yields of these reactions were improved compared to utilising a previous reported method. In the synthesis of 1-[carbonyl-11C]benzoyl-3-methyl-1H-indole (11) from 3-methyl-1H-indole (25), the corresponding organotin-amine was prepared prior to the acylation reaction. In a typical experiment, N-(4-hydroxyphenyl)[carbonyl-11C]acetamide (5) was prepared in 15% radiochemical yield using 4-aminophenol (20) but the yield increased to 63% when the amine was activated by lithium bis(trimethylsilyl)amide.     

Palladium-catalyzed carbon-carbon bond-forming 1,2-ligand migration of organoalanes

A one-pot, two-step process that transforms terminal alkynes into ethyl methyl-substituted benzylic quaternary carbon centers is described. (E)-2,2-Disubstituted-1-alkenyldimethylalanes have been shown to participate in 1,2-alkyl migration from aluminum to carbon with concomitant arylation at the 2-position to furnish ethyl methyl-substituted benzylic quaternary carbon centers, when reacted intramolecularly with aryl halides and triflates in the presence of a Pd(0) catalyst. The protocol is initiated with Cp2ZrCl2-catalyzed methylalumination of terminal alkynes followed by palladium-catalyzed intramolecular arylation of the resulting (E)-2,2-disubstituted-1-alkenyldimethylalanes, leading to 1,2-methyl shift from aluminum to carbon. In that sequence, a total of three new C-C single bonds are made, and two of the three alkyl groups on Me3Al transferred to the substrate on vicinal carbons. This method was applied to a variety of substrates, and the mechanism was investigated by deuterium-labeling experiments, which revealed that protodealumination of the final dialkylaluminum triflate or halide intermediates by CH3CN results in the formation of the fourth bond in the course of the transformation.