Fluorescence studies on phenylene moieties embedded in a framework of periodic mesoporous organosilica

The excited state characteristics of phenylene (Ph)-bridged periodic mesoporous organosilica (PMO) powders with crystal-like and amorphous wall structures are investigated. Crystal-like Ph-PMO has a molecular ordering of the bridging organic moieties with intervals of 0.76 and 0.44 nm parallel and perpendicular to the mesochannel direction, respectively, whereas amorphous Ph-PMO has no molecular-level periodicity in the wall. Fluorescence from the exciton and excimer of the Ph moieties and the defect center in the silicate network were detected at room temperature, but fluorescence from the excimer and the defect center were not detected at 77 K for crystal-like Ph-PMO dispersed in a methanol/ethanol mixed solvent. The decay curve of the exciton fluorescence of crystal-like Ph-PMO at room temperature was analyzed successfully using a one-dimensional diffusion model quenched by the defect center and the excimer site. The results were discussed in comparison with those for the crystal-like biphenylene-bridged PMO reported in the preceding paper (Yamanaka et al., Phys. Chem. Chem. Phys., 2010, 12, 11688-11696). The existence of excited states with various conformations including ground state dimers or aggregates of the Ph moieties was suggested for amorphous Ph-PMO. It was clearly apparent that the differences in the excited state dynamics reflected the differences in the molecular-level structure in the wall.     

The large quadrupole of water molecules

Many quantum mechanical calculations indicate water molecules in the gas and liquid phase have much larger quadrupole moments than any of the common site models of water for computer simulations. Here, comparisons of multipoles from quantum mechanical∕molecular mechanical (QM∕MM) calculations at the MP2∕aug-cc-pVQZ level on a B3LYP∕aug-cc-pVQZ level geometry of a waterlike cluster and from various site models show that the increased square planar quadrupole can be attributed to the p-orbital character perpendicular to the molecular plane of the highest occupied molecular orbital as well as a slight shift of negative charge toward the hydrogens. The common site models do not account for the p-orbital type electron density and fitting partial charges of TIP4P- or TIP5P-type models to the QM∕MM dipole and quadrupole give unreasonable higher moments. Furthermore, six partial charge sites are necessary to account reasonably for the large quadrupole, and polarizable site models will not remedy the problem unless they account for the p-orbital in the gas phase since the QM calculations show it is present there too. On the other hand, multipole models by definition can use the correct multipoles and the electrostatic potential from the QM∕MM multipoles is much closer than that from the site models to the potential from the QM∕MM electron density. Finally, Monte Carlo simulations show that increasing the quadrupole in the soft-sticky dipole-quadrupole-octupole multipole model gives radial distribution functions that are in good agreement with experiment.     

UNDERSTANDING STRUCTURAL EFFECTS OF MULTIPOLE MOMENTS ON AQUEOUS SOLVATION OF IONS USING THE SOFT-STICKY DIPOLE-QUADRUPOLE-OCTUPOLE WATER MODEL

The effects of water multipole moments on the aqueous solvation of ions were determined in Monte Carlo simulations using soft-sticky dipole-quadrupole-octupole (SSDQO) water. Water molecules formed linear hydrogen bonds to Cl(-) using the new SSDQO1 parameters, similar to multi-site models. However, the dipole vector was tilted rather than parallel to the oxygen-Na(+) internuclear vector as in most multi-site model, while experiment and ab initio molecular dynamics simulations generally indicate a range of values between tilted and parallel. By varying the multipoles in SSDQO, the octupole was found to determine the orientation around Na(+). Moreover, analysis of the multipoles of more conventional models is predictive of their performance as solvents.     

Comparison between Abel test stability and thermal decomposition behavior of nitrocellulose

Journal of Thermal Analysis and Calorimetry - Nitrocellulose (NC) is prone to spontaneous decomposition with exothermic heat release and thus is generally evaluated for stability during the storage...     

苯并10芳杂环化合物的合成

近年来符合休克尔规则的,经典的6π芳香环以外的大环或多环芳香族化合物的合成及其应用的开发曰益受到人们的重视^[1,2]。本文简要介绍含有三氟甲基及三氟乙酰基的苯并10π-芳杂环化合物的合成及其结构的确定。此类化合物目前文献中尚未见报导。     

An improved procedure for the conversion of indolines into indoles

The addition of a sacrificial enamine (such as indole), or of a vinyl ether (like dihydropyran) to an indoline during dehydrogenation by phenylseleninic anhydride dramatically improves the yield of the corresponding indole. This is due to scavenging of Se¹¹ phenylselenenating species.     

Homoleptic cyclometalated iridium complexes with highly efficient red phosphorescence and application to organic light-emitting diode

Phosphorescence studies of a series of facial homoleptic cyclometalated iridium(III) complexes have been carried out. The complexes studied have the general structure Ir(III)(C-N)(3), where (C-N) is a monoanionic cyclometalating ligand: 2-(5-methylthiophen-2-yl)pyridinato, 2-(thiophen-2-yl)-5-trifluoromethylpyridinato, 2,5-di(thiophen-2-yl)pyridinato, 2,5-di(5-methylthiophen-2-yl)pyridinato, 2-(benzo[b]thiophen-2-yl)pyridinato, 2-(9,9-dimethyl-9H-fluoren-2-yl)pyridinato, 1-phenylisoquinolinato, 1-(thiophen-2-yl)isoquinolinato, or 1-(9,9-dimethyl-9H-fluoren-2-yl)isoquinolinato. Luminescence properties of all the complexes at 298 K in toluene are as follows: quantum yields of phosphorescence Phi(p) = 0.08-0.29, emission peaks lambda(max) = 558-652 nm, and emission lifetimes tau = 0.74-4.7 micros. Bathochromic shifts of the Ir(thpy)(3) family [the complexes with 2-(thiophen-2-yl)pyridine derivatives] are observed by introducing appropriate substituents, e.g., methyl, trifluoromethyl, or thiophen-2-yl. However, Phi(p) of the red emissive complexes (lambda(max) > 600 nm) becomes small, caused by a significant decrease of the radiative rate constant, k(r). In contrast, the complexes with the 1-arylisoquinoline ligands are found to have marked red shifts of lambda(max) and very high Phi(p) (0.19-0.26). These complexes are found to possess dominantly (3)MLCT (metal-to-ligand charge transfer) excited states and have k(r) values approximately 1 order of magnitude larger than those of the Ir(thpy)(3) family. An organic light-emitting diode (OLED) device that uses Ir(1-phenylisoquinolinato)(3) as a phosphorescent dopant produces very high efficiency (external quantum efficiency eta(ex) = 10.3% and power efficiency 8.0 lm/W at 100 cd/m(2)) and pure-red emission with 1931 CIE (Commission Internationale de L'Eclairage) chromaticity coordinates (x = 0.68, y = 0.32).     

Adsorption properties of activated carbon from waste newspaper prepared by chemical and physical activation

Adsorption properties of activated carbons prepared from waste newspaper by chemical and physical activation were investigated using water vapor, ammonia, methane, and methylene blue (MB) as adsorbents. The water vapor adsorption isotherms show type V behavior and the maximum vapor adsorption of the chemically and physically activated products is about 1050 and 450 ml/g, respectively. The higher water vapor adsorption of the chemically activated products is attributed to the higher specific surface area (S(BET)) and greater hydrophilic activity (arising from the surface oxygen-containing functional groups) than in the physically activated products. The adsorption of ammonia and methane was measured by temperature-programmed desorption (TPD). NH(3) adsorption is found to be higher in the chemically activated product than in the physically activated product while methane adsorption is slightly higher in the physically activated products even though these have lower S(BET) values. In the MB adsorption, the chemically activated products show higher adsorption (390 mg/g) than the physically activated product. These results are suggested to be related to the surface characteristics.     

Synthesis and Magnetic Properties of (Pyrrolidin‐1‐oxyl)–(Nitronyl Nitroxide)/(Iminonitroxide)‐Dyads

Unlike extensively studied diradicals linked by π‐conjugated systems, only a few studies have investigated weakly coupled diradicals linked by an sp³ carbon atom. Herein, we prepared pyrrolidin‐1‐oxyl–(nitronyl nitroxide)‐dyad 5 and pyrrolidin‐1‐oxyl–iminonitroxide‐dyad 6 . From the observed temperature dependence of the magnetic susceptibility, 5 and 6 were determined to be in singlet ground states with 2J_intra/k_B=?35.2 K and ?13.6 K, respectively. From these results and theoretical calculations of related diradicals, the spin‐polarization model counting the small spin density of the sp³ carbon atom could be used as a spin‐prediction model.